Tai-Jong Jung
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tai-Jong Jung has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Yoon-Cheol Ha
Battery Research Division, Korea Electrotechnology Research Institute (KERI), Changwon, Republic of Korea
3 shared publications - Hyobin Lee
Daegu Gyeongbuk Institute of Science and Technology (DGIST)
2 shared publications - Yong Min Lee
Department of Chemical and Biomolecular Engineering Yonsei University Seoul Republic of Korea
2 shared publications Chil-Hoon Doh
Korea Electrotechnol Res Inst KERI, Battery Res Div, 12 Jeongiui Gil, Changwon Si 51543, Gyeongsangnam D, South Korea
1 shared publication- Chil-Hoon Doh
Korea Electro-Technology Research Institute (KERI)
1 shared publication Dongyoon Kang
Daegu Gyeongbuk Inst Sci & Technol DGIST, Dept Energy Sci & Engn, Daegu 42988, South Korea
1 shared publication
Latest Publications
- Open Access
- 31 October 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (11) , 2924
Vertically Aligned Binder-Free TiO2 Nanotube Arrays Doped with Fe, S and Fe-S for Li-ion Batteries
Vertically aligned Fe, S, and Fe-S doped anatase TiO2 nanotube arrays are prepared by an electrochemical anodization process using an organic electrolyte in which lactic acid is added as an additive. In the electrolyte, highly ordered TiO2 nanotube layers with greater thickness of 12 μm, inner diameter of approx. 90 nm and outer diameter of approx. 170 nm are successfully obtained. Doping of Fe, S, and Fe-S via simple wet impregnation method substituted Ti and O sites with Fe and S, which leads to enhance the rate performance at high discharge C-rates. Discharge capacities of TiO2 tubes increased from 0.13 mAh cm−2(bare) to 0.28 mAh cm−2 for Fe-S doped TiO2 at 0.5 C after 100 cycles with exceptional capacity retention of 85 % after 100 cycles. Owing to the enhancement of thermodynamic and kinetic properties by doping of Fe-S, Li-diffusion increased resulting in remarkable discharge capacities of 0.27 mAh cm−2 and 0.16 mAh cm−2 at 10 C, and 30 C, respectively.
- 31 October 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (11) , 2924
Open AccessVertically Aligned Binder-Free TiO2 Nanotube Arrays Doped with Fe, S and Fe-S for Li-ion Batteries
Vertically aligned Fe, S, and Fe-S doped anatase TiO2 nanotube arrays are prepared by an electrochemical anodization process using an organic electrolyte in which lactic acid is added as an additive. In the electrolyte, highly ordered TiO2 nanotube layers with greater thickness of 12 μm, inner diameter of approx. 90 nm and outer diameter of approx. 170 nm are successfully obtained. Doping of Fe, S, and Fe-S via simple wet impregnation method substituted Ti and O sites with Fe and S, which leads to enhance the rate performance at high discharge C-rates. Discharge capacities of TiO2 tubes increased from 0.13 mAh cm−2(bare) to 0.28 mAh cm−2 for Fe-S doped TiO2 at 0.5 C after 100 cycles with exceptional capacity retention of 85 % after 100 cycles. Owing to the enhancement of thermodynamic and kinetic properties by doping of Fe-S, Li-diffusion increased resulting in remarkable discharge capacities of 0.27 mAh cm−2 and 0.16 mAh cm−2 at 10 C, and 30 C, respectively.