Shuoyang Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shuoyang Li has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Lanya Yu
School of Geophysics and Information Technology, China University of Geosciences, Beijing, China
3 shared publications - Xiao Zhao
School of Geophysics and Information Technology, China University of Geosciences (Beijing), Beijing 100083, China
3 shared publications - Liyuan Dong
School of Geophysics and Information Technology, China University of Geosciences, Beijing, China
2 shared publications - Qisheng Zhang
School of Geophysics and Information Technology, China University of Geosciences (Beijing), Beijing, China
2 shared publications - Xilong Zhang
School of Mechanical and Automotive Engineering, Qingdao University of Technology, Qingdao 266520, China
1 shared publication - Yaping Xin
School of Geophysics and Information Technology, China University of Geosciences, Beijing, China
1 shared publication
Latest Publications
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (8) , 8976-8987
A High-Efficiency Fast-Transient LDO With Low-Impedance Transient-Current Enhanced Buffer
This article proposes a new low-impedance transient-current enhanced (LTE) buffer, which is applied for low-dropout regulator (LDO) with large off-chip capacitor. The LTE buffer is based on current-shunt feedback technique and two ac coupling networks, which can achieve an extremely low output impedance and high charging/discharging current of the gate of power transistor at load transient response, while maintaining low-quiescent current consumption under the full-load range. In addition to containing the LTE buffer, the proposed LTE-LDO employs recycling-folded-cascode amplifier as the error amplifier, which has the advantage of high loop gain, loop bandwidth, and current efficiency. Meanwhile, simple Miller compensation with a nulling resistor is employed for frequency compensation and a complete small-signal analysis under different load current conditions is given in this article. This design has been implemented in semiconductor manufacturing international corporation 0.18 $\mu$ m complementary metal–oxide–semiconductor process and the experimental results show that the quiescent current consumption is about 48 $\mu$ A, and the maximum current efficiency of the LTE-LDO is 99.976 $\%$ . The measured transient response shows that under the condition of 1 $\mu$ F load capacitance, when the load current changes to 200 mA/100 ns, the output voltage change is 76 mV.
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (8) , 8976-8987
A High-Efficiency Fast-Transient LDO With Low-Impedance Transient-Current Enhanced Buffer
This article proposes a new low-impedance transient-current enhanced (LTE) buffer, which is applied for low-dropout regulator (LDO) with large off-chip capacitor. The LTE buffer is based on current-shunt feedback technique and two ac coupling networks, which can achieve an extremely low output impedance and high charging/discharging current of the gate of power transistor at load transient response, while maintaining low-quiescent current consumption under the full-load range. In addition to containing the LTE buffer, the proposed LTE-LDO employs recycling-folded-cascode amplifier as the error amplifier, which has the advantage of high loop gain, loop bandwidth, and current efficiency. Meanwhile, simple Miller compensation with a nulling resistor is employed for frequency compensation and a complete small-signal analysis under different load current conditions is given in this article. This design has been implemented in semiconductor manufacturing international corporation 0.18 $\mu$ m complementary metal–oxide–semiconductor process and the experimental results show that the quiescent current consumption is about 48 $\mu$ A, and the maximum current efficiency of the LTE-LDO is 99.976 $\%$ . The measured transient response shows that under the condition of 1 $\mu$ F load capacitance, when the load current changes to 200 mA/100 ns, the output voltage change is 76 mV.
- 4 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (4) , 4039-4049
Multiple Adaptive Current Feedback Technique for Small-Gain Stages in Adaptively Biased Low-Dropout Regulator
Adaptive bias scheme, which can be used to provide a current proportional to the current flowing through the power transistor under high current load, avoiding the need for providing additional large fixed bias current to the circuit, has been adopted in many low-dropout regulators (LDO). When an adaptive bias scheme is applied to an LDO with a current mirror buffer, although a low chip area consumption and a better transient response can be achieved, the loop gain of LDO at high-load current and loop bandwidth at low load are still low. In previous works, multiple small-gain stages can effectively improve the gain and bandwidth but may lead to stability problems or even need to consume large currents to ensure stability, thus affecting current efficiency. This article proposes the multiple adaptive current feedbacks technique for small-gain stages in adaptively biased low dropout regulator (AB-LDO) with a current mirror buffer, improving the loop gain and bandwidth and eliminating the need for frequency compensation to meet stability requirements. Moreover, in the case that multiple adaptive bias loops can be introduced after the proposed technique is applied to this design, an intuitive and simple method is adopted to analyze the whole circuit. The designed AB-LDO was fabricated in Semiconductor Manufacturing International Corp (SMIC) 0.18- $\mu$ m process. The measured results show that the designed LDO realizes 30.75-mV transient performances with a step of 10 ns.
- 4 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (4) , 4039-4049
Multiple Adaptive Current Feedback Technique for Small-Gain Stages in Adaptively Biased Low-Dropout Regulator
Adaptive bias scheme, which can be used to provide a current proportional to the current flowing through the power transistor under high current load, avoiding the need for providing additional large fixed bias current to the circuit, has been adopted in many low-dropout regulators (LDO). When an adaptive bias scheme is applied to an LDO with a current mirror buffer, although a low chip area consumption and a better transient response can be achieved, the loop gain of LDO at high-load current and loop bandwidth at low load are still low. In previous works, multiple small-gain stages can effectively improve the gain and bandwidth but may lead to stability problems or even need to consume large currents to ensure stability, thus affecting current efficiency. This article proposes the multiple adaptive current feedbacks technique for small-gain stages in adaptively biased low dropout regulator (AB-LDO) with a current mirror buffer, improving the loop gain and bandwidth and eliminating the need for frequency compensation to meet stability requirements. Moreover, in the case that multiple adaptive bias loops can be introduced after the proposed technique is applied to this design, an intuitive and simple method is adopted to analyze the whole circuit. The designed AB-LDO was fabricated in Semiconductor Manufacturing International Corp (SMIC) 0.18- $\mu$ m process. The measured results show that the designed LDO realizes 30.75-mV transient performances with a step of 10 ns.
- 1 May 2021
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 134, 153643
A 101 dB SNR fourth-order ΣΔ modulator for MEMS digital geophones
- 1 May 2021
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 134, 153643
A 101 dB SNR fourth-order ΣΔ modulator for MEMS digital geophones