Arturo Sibaja-Hernandez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Arturo Sibaja-Hernandez has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Bertrand Parvais
IMEC
2 shared publications - Hao Yu
IMEC
2 shared publications N. Collaert
IMEC, Leuven, Belgium
2 shared publications- Uthayasankaran Peralagu
IMEC
2 shared publications A. Alian
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
1 shared publicationA. Milenin
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
1 shared publication
Latest Publications
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 47 (9) , 1728-1731
Semi-On State Hole Generation in GaN HEMTs: Experimental Evidence and TCAD Modeling
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 47 (9) , 1728-1731
Semi-On State Hole Generation in GaN HEMTs: Experimental Evidence and TCAD Modeling
- Open Access
- 6 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 10, 854-859
The Impact of Width Downscaling on the High-Frequency Characteristics of InGaAs Nanowire FETs
This work demonstrates the high-frequency characteristics of In0.53Ga0.47As nanowire with scaled wire width by implementing TCAD simulations. The physical models and correlated parameters have been calibrated to the experiments in the literature 19. As the width of the nanowire is scaled to 10 nm, the electron density peaks are no longer located close to the oxide/semiconductor interface. Instead, the peaks merge and volume inversion effects appear due to the strong quantum confinement. The volume inversion effects lead to higher cut-off frequency due to the reduced total transport delay time. To have a better understanding of this phenomena, the high-frequency properties of nanowire were quantified with the assistance of small-signal analysis and delay time analysis using TCAD. It is found that the channel charging delay increases with narrower wire width due to the raise of source/drain resistance. Regarding the extrinsic and intrinsic delay, they increase with smaller wire width and drop at width of 10 nm due to the volume inversion effects. Electron distribution which aims to clarify the abovementioned observation is also plotted.
- 6 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 10, 854-859
Open AccessThe Impact of Width Downscaling on the High-Frequency Characteristics of InGaAs Nanowire FETs
This work demonstrates the high-frequency characteristics of In0.53Ga0.47As nanowire with scaled wire width by implementing TCAD simulations. The physical models and correlated parameters have been calibrated to the experiments in the literature 19. As the width of the nanowire is scaled to 10 nm, the electron density peaks are no longer located close to the oxide/semiconductor interface. Instead, the peaks merge and volume inversion effects appear due to the strong quantum confinement. The volume inversion effects lead to higher cut-off frequency due to the reduced total transport delay time. To have a better understanding of this phenomena, the high-frequency properties of nanowire were quantified with the assistance of small-signal analysis and delay time analysis using TCAD. It is found that the channel charging delay increases with narrower wire width due to the raise of source/drain resistance. Regarding the extrinsic and intrinsic delay, they increase with smaller wire width and drop at width of 10 nm due to the volume inversion effects. Electron distribution which aims to clarify the abovementioned observation is also plotted.
- 14 July 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (2) , 024302
Understanding the factors affecting contact resistance in nanowire field effect transistors (NWFETs) to improve nanoscale contacts for future scaling
In this paper, dry etched vertical nanowires (VNWs) are used in transmission line/transfer length analysis to study the contacts of gate-all-around devices for future technology nodes. VNW resistors with Mo and Pd based metal stack contacts to p-InGaAs show Schottky behavior, unlike the planar counterpart. The resistance for Mo contact is higher than Pd, however, Pd was found to form an alloy with InGaAs at temperatures as low as 190 °C, and the length of Pd diffusion into the InGaAs increased at smaller NW dimensions, hindering future scalability. The minimum extracted specific contact resistivity (ρC) values are 1.6 × 10−5 Ω cm2 (Mo) and 4.2 × 10−6 Ω cm2 (Pd) for a doping level of 1 × 1019 cm−3. An apparent dependence of ρC on the NW diameter was also observed. This has been attributed to the surface states under the un-gated region of NW devices and found to dominate at smaller diameters. An analytical model to account for such geometrical effects has also been developed and validated with technology computer-aided design simulations. The analysis presented in this paper effectively captures the 3D aspects of an NW contact at nanoscale dimensions and can be applied irrespective of the semiconductor and contact metal used.
- 14 July 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (2) , 024302
Understanding the factors affecting contact resistance in nanowire field effect transistors (NWFETs) to improve nanoscale contacts for future scaling
In this paper, dry etched vertical nanowires (VNWs) are used in transmission line/transfer length analysis to study the contacts of gate-all-around devices for future technology nodes. VNW resistors with Mo and Pd based metal stack contacts to p-InGaAs show Schottky behavior, unlike the planar counterpart. The resistance for Mo contact is higher than Pd, however, Pd was found to form an alloy with InGaAs at temperatures as low as 190 °C, and the length of Pd diffusion into the InGaAs increased at smaller NW dimensions, hindering future scalability. The minimum extracted specific contact resistivity (ρC) values are 1.6 × 10−5 Ω cm2 (Mo) and 4.2 × 10−6 Ω cm2 (Pd) for a doping level of 1 × 1019 cm−3. An apparent dependence of ρC on the NW diameter was also observed. This has been attributed to the surface states under the un-gated region of NW devices and found to dominate at smaller diameters. An analytical model to account for such geometrical effects has also been developed and validated with technology computer-aided design simulations. The analysis presented in this paper effectively captures the 3D aspects of an NW contact at nanoscale dimensions and can be applied irrespective of the semiconductor and contact metal used.
- 25 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (4) , 2180-2187
ESD HBM Discharge Model in RF GaN-on-Si (MIS)HEMTs
Gallium nitride (GaN) technologies have become an essential role in commercial advanced RF systems, which accompany emerging RF electrostatic discharge (ESD) reliability challenges. As opposed to ESD clamp transistors in LV CMOS technologies, a mis-correlation between standard-defined human body model (HBM) ESD robustness and commonly used TLP failure current was observed in GaN (MIS) high electron mobility transistors (HEMTs). Using transient HBM ${I}$ – ${V}$ characteristics, a novel discharge model is proposed to explain the transient discharge mechanism. The TCAD and SPICE simulations confirmed that the observed mis-correlation between TLP and HBM is attributed to 2-dimensional electron gas (2DEG) resistance modulation in response to HBM ESD transient voltage waveforms. The HBM waveforms under full transient duration in terms of rising and falling edges are further discussed. Eventually, the failure mechanisms in the TLP IVs and the HBM transient IVs can be well correlated in GaN (MIS)HEMTs.
- 25 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (4) , 2180-2187
ESD HBM Discharge Model in RF GaN-on-Si (MIS)HEMTs
Gallium nitride (GaN) technologies have become an essential role in commercial advanced RF systems, which accompany emerging RF electrostatic discharge (ESD) reliability challenges. As opposed to ESD clamp transistors in LV CMOS technologies, a mis-correlation between standard-defined human body model (HBM) ESD robustness and commonly used TLP failure current was observed in GaN (MIS) high electron mobility transistors (HEMTs). Using transient HBM ${I}$ – ${V}$ characteristics, a novel discharge model is proposed to explain the transient discharge mechanism. The TCAD and SPICE simulations confirmed that the observed mis-correlation between TLP and HBM is attributed to 2-dimensional electron gas (2DEG) resistance modulation in response to HBM ESD transient voltage waveforms. The HBM waveforms under full transient duration in terms of rising and falling edges are further discussed. Eventually, the failure mechanisms in the TLP IVs and the HBM transient IVs can be well correlated in GaN (MIS)HEMTs.
- 22 November 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (20) , 205701
Analysis of semi-insulating carbon-doped GaN layers using deep-level transient spectroscopy
Electrically active defects in carbon-doped GaN layers were studied with a metal/carbon-doped GaN (GaN:C)/Si-doped GaN (GaN:Si) MIS structure. The GaN:C layers were grown with three different carbon doping concentrations (NC). A semi-vertical metal/semi-insulator/n-type semiconductor (MIS) device was fabricated to perform deep-level transient spectroscopy (DLTS) measurements. Two electron traps E1 and E2 with energy level at EC − (0.22–0.31) eV and EC − (0.45–0.49) eV were observed. E1 and E2 are associated with a nitrogen vacancy VN-related defect in the strain field of extended defects and a nitrogen antisite defect, respectively. By changing the reverse bias voltage of the DLTS measurement, the location and relative defect concentration of the E1 and E2 traps could be verified. A dominant electron trap E3 with an unusual capture cross section was only observed in devices with an NC = 2 × 1019 cm−3 GaN:C layer. This may charge carriers from a defect band and lead to the charge redistribution in the GaN:C layer when forward biased. A hole trap H1 with energy level at EV + 0.47 eV was found for the pulse bias in the forward ON-state. H1 is suggested to correspond with the CN induced 0/+ donor level. By analyzing the schematic band diagrams across the MIS structure, the carrier transport and defect charging mechanisms underlying the DLTS transient measurements are illustrated. The identification of the trap states in the carbon-doped GaN with different NC gives further understanding on the carbon doping impact on electric characteristics of GaN power devices made on Si substrates.
- 22 November 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (20) , 205701
Analysis of semi-insulating carbon-doped GaN layers using deep-level transient spectroscopy
Electrically active defects in carbon-doped GaN layers were studied with a metal/carbon-doped GaN (GaN:C)/Si-doped GaN (GaN:Si) MIS structure. The GaN:C layers were grown with three different carbon doping concentrations (NC). A semi-vertical metal/semi-insulator/n-type semiconductor (MIS) device was fabricated to perform deep-level transient spectroscopy (DLTS) measurements. Two electron traps E1 and E2 with energy level at EC − (0.22–0.31) eV and EC − (0.45–0.49) eV were observed. E1 and E2 are associated with a nitrogen vacancy VN-related defect in the strain field of extended defects and a nitrogen antisite defect, respectively. By changing the reverse bias voltage of the DLTS measurement, the location and relative defect concentration of the E1 and E2 traps could be verified. A dominant electron trap E3 with an unusual capture cross section was only observed in devices with an NC = 2 × 1019 cm−3 GaN:C layer. This may charge carriers from a defect band and lead to the charge redistribution in the GaN:C layer when forward biased. A hole trap H1 with energy level at EV + 0.47 eV was found for the pulse bias in the forward ON-state. H1 is suggested to correspond with the CN induced 0/+ donor level. By analyzing the schematic band diagrams across the MIS structure, the carrier transport and defect charging mechanisms underlying the DLTS transient measurements are illustrated. The identification of the trap states in the carbon-doped GaN with different NC gives further understanding on the carbon doping impact on electric characteristics of GaN power devices made on Si substrates.
- 26 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 55 (1) , 358-364
SiGe HBTs With Normal High-Speed Emitter-Up and Reverse Low-Power Collector-Up Operation
SiGe heterojunction bipolar transistors (HBTs) are usually optimized to obtain best performance in the forward operation mode. In this paper, we demonstrate that a simultaneous excellent performance in the reverse mode of operation can be obtained as well. A fT / fmax combination of 50/100 GHz is obtained, which is, to our knowledge, the best value reported for a Si-based HBT operating in the reverse mode. This excellent performance is analyzed and explained by studying the different delay components of the device in the reverse operation mode. It is shown that the extrinsic SiGe base region plays a crucial role. Additionally, good low-power performance in the reverse operation mode is obtained as well, which is attributed to a reduction in the device parasitic contributions. The simultaneous availability of a high-speed performance in the forward mode and a low-power performance in the reverse mode offers additional flexibility to optimize circuit performance in terms of speed, power, and area.
- 26 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 55 (1) , 358-364
SiGe HBTs With Normal High-Speed Emitter-Up and Reverse Low-Power Collector-Up Operation
SiGe heterojunction bipolar transistors (HBTs) are usually optimized to obtain best performance in the forward operation mode. In this paper, we demonstrate that a simultaneous excellent performance in the reverse mode of operation can be obtained as well. A fT / fmax combination of 50/100 GHz is obtained, which is, to our knowledge, the best value reported for a Si-based HBT operating in the reverse mode. This excellent performance is analyzed and explained by studying the different delay components of the device in the reverse operation mode. It is shown that the extrinsic SiGe base region plays a crucial role. Additionally, good low-power performance in the reverse operation mode is obtained as well, which is attributed to a reduction in the device parasitic contributions. The simultaneous availability of a high-speed performance in the forward mode and a low-power performance in the reverse mode offers additional flexibility to optimize circuit performance in terms of speed, power, and area.