Shijia Ye
Research Subjects
Shijia Ye has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
J.Y. Huang
2 shared publicationsS.N. Luo
2 shared publicationsB.B. Zhang
1 shared publicationC. Li
1 shared publication- Chuanlong Lin
Center for High Pressure Science and Technology Advanced Research (HPSTAR) Beijing China
1 shared publication - D. Fan
The Peac Institute of Multiscale Sciences, Chengdu, Sichuan, PR China
1 shared publication
Latest Publications
- Open Access
- 1 December 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (12)
Time-resolved Raman spectroscopy for monitoring the structural evolution of materials during rapid compression
Rapid compression experiments performed using a dynamic diamond anvil cell (dDAC) offer the opportunity to study compression rate-dependent phenomena, which provide critical knowledge of the phase transition kinetics of materials. However, direct probing of the structure evolution of materials is scarce and so far limited to the synchrotron based x-ray diffraction technique. Here, we present a time-resolved Raman spectroscopy technique to monitor the structural evolutions in a subsecond time resolution. Instead of applying a shutter-based synchronization scheme in previous work, we directly coupled and synchronized the spectrometers with the dDAC, providing sequential Raman data over a broad pressure range. The capability and versatility of this technique are verified by in situ observation of the phase transition processes of three rapid compressed samples. Not only the phase transition pressures but also the transition pathways are reproduced with good accuracy. This approach has the potential to serve as an important complement to x-ray diffraction applied to study the kinetics of phase transitions occurring on time scales of seconds and above.
- 1 December 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (12)
Open AccessTime-resolved Raman spectroscopy for monitoring the structural evolution of materials during rapid compression
Rapid compression experiments performed using a dynamic diamond anvil cell (dDAC) offer the opportunity to study compression rate-dependent phenomena, which provide critical knowledge of the phase transition kinetics of materials. However, direct probing of the structure evolution of materials is scarce and so far limited to the synchrotron based x-ray diffraction technique. Here, we present a time-resolved Raman spectroscopy technique to monitor the structural evolutions in a subsecond time resolution. Instead of applying a shutter-based synchronization scheme in previous work, we directly coupled and synchronized the spectrometers with the dDAC, providing sequential Raman data over a broad pressure range. The capability and versatility of this technique are verified by in situ observation of the phase transition processes of three rapid compressed samples. Not only the phase transition pressures but also the transition pathways are reproduced with good accuracy. This approach has the potential to serve as an important complement to x-ray diffraction applied to study the kinetics of phase transitions occurring on time scales of seconds and above.
- 1 December 2021
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 94, 164-174
Multiple ballistic impacts on 2024-T4 aluminum alloy by spheres: Experiments and modelling
- 1 December 2021
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 94, 164-174
Multiple ballistic impacts on 2024-T4 aluminum alloy by spheres: Experiments and modelling
- 1 June 2021
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 152
Penetration dynamics of a carbonate sand: A synchrotron phase contrast imaging study
- 1 June 2021
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 152
Penetration dynamics of a carbonate sand: A synchrotron phase contrast imaging study
- Open Access
- 21 October 2019
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 46 (20) , 11018-11024
Phase Stability and Thermal Equation of State of Iron Carbide Fe3C to 245 GPa
We conducted shock wave experiments on iron carbide Fe3C up to a Hugoniot pressure of 245 GPa. The correlation between the particle velocity (up) and shock wave velocity (us) can be fitted into a linear relationship, us = 4.627(±0.073) + 1.614(±0.028) up. The density‐pressure relationship is consistent with a single‐phase compression without decomposition. The inference is further supported by the comparison of the observed Hugoniot density with the calculated Hugoniot curves of possible decomposition products. The new Hugoniot data combined with the reported 300‐K isothermal compression data yielded a Grüneisen parameter of γ = 2.23(7.982/ρ)0.29. The thermal equation of state of Fe3C is further used to calculate the density profile of Fe3C along the Earth's adiabatic geotherm. The density of Fe3C was found to be too low (by ~5%) to match the observed density in the Earth's inner core, and Fe3C is unlikely a dominant component of the inner core.
- 21 October 2019
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 46 (20) , 11018-11024
Open AccessPhase Stability and Thermal Equation of State of Iron Carbide Fe3C to 245 GPa
We conducted shock wave experiments on iron carbide Fe3C up to a Hugoniot pressure of 245 GPa. The correlation between the particle velocity (up) and shock wave velocity (us) can be fitted into a linear relationship, us = 4.627(±0.073) + 1.614(±0.028) up. The density‐pressure relationship is consistent with a single‐phase compression without decomposition. The inference is further supported by the comparison of the observed Hugoniot density with the calculated Hugoniot curves of possible decomposition products. The new Hugoniot data combined with the reported 300‐K isothermal compression data yielded a Grüneisen parameter of γ = 2.23(7.982/ρ)0.29. The thermal equation of state of Fe3C is further used to calculate the density profile of Fe3C along the Earth's adiabatic geotherm. The density of Fe3C was found to be too low (by ~5%) to match the observed density in the Earth's inner core, and Fe3C is unlikely a dominant component of the inner core.
- 4 January 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (5) , 2659-2664
Crack propagation in graphene monolayer under tear loading
Crack propagation in graphene monolayer under tear loading is investigated via an energy-based analytical model and molecular dynamics (MD) simulations.
- 4 January 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (5) , 2659-2664
Crack propagation in graphene monolayer under tear loading
Crack propagation in graphene monolayer under tear loading is investigated via an energy-based analytical model and molecular dynamics (MD) simulations.