CLChia-Wei Lin

Chia-Wei Lin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Chia-Wei Lin has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Design and Implementation of a 28-GHz Four-Phase Beam-Steering Antenna Based on a Butler Matrix Network

    by Ming-An Chung, Chia-Wei Lin, Bing-Ruei Chuang

    This paper presents a four-phase beam-steering antenna for 28 GHz wireless communication, targeting the demand for high-efficiency and low-complexity beam-steering solutions in millimeter-wave systems. The proposed design employs a Butler matrix network to achieve multi-directional beam switching while reducing implementation complexity. The antenna is realized using microstrip technology on a printed circuit board (PCB), and the overall architecture consists of a 1 × 4 microstrip antenna array and a 4 × 4 Butler matrix network. Each component is carefully designed and analyzed to ensure optimized performance and proper system balance. The proposed antenna exhibits excellent performance in terms of bandwidth and compact size, while also providing advantages that include low cost, ease of fabrication, and structural simplicity. The beam-steering capability is experimentally verified through far-field measurements. The measurement results indicate that the four beam directions are −38°, −13°, +19°, and +41°, with corresponding gains of 8.79, 9.66, 10.8, and 9.21 dBi, respectively. In addition, a good agreement between the measurement and simulation results is observed, which validates the effectiveness and feasibility of the proposed design.

  • Open Access

    A Compact On-Chip Ka-Band Bandpass Filter Using Folded Crossed Interdigital Coupling Structure

    by Ming-An Chung, Chia-Wei Lin, Bing-Ruei Chuang

    This paper proposes a millimeter-wave miniature on-chip bandpass filter (BPF) implemented using a 0.18 μm CMOS process. To address the issues of insufficient coupling capability, limited control of transmission zeros, and excessive chip area in traditional on-chip filters, a folded cross-interdigital coupling structure is proposed to enhance coupling efficiency and reduce size. The design incorporates metal–insulator–metal (MIM) capacitors to increase the coupling capacitance between resonators without increasing the area, and utilizes a defected ground structure (DGS) to modify the current distribution at the ground plane, generating additional transmission zeros to improve selectivity. An LC equivalent circuit model was established and verified through full-wave electromagnetic simulation, and the design was validated through chip fabrication and on-wafer measurements. The measurement results show an insertion loss of 3.36 dB and a fractional bandwidth of 49.1% at 32 GHz, with two transmission zeros. The core dimensions are 0.25 mm × 0.18 mm. This design achieves a good balance between miniaturization, selectivity, and insertion loss, making it suitable for millimeter-wave SoC applications.

  • Open Access

    Smart Community Energy Forecasting and Management System Based on Two-Layer Model Architecture

    by Ming-An Chung, Jun-Hao Zhang, Zhi-Xuan Zhang, Chia-Chun Hsu, Yi-Ju Yao, Jin-Hong Chou, Pin-Han Chen, Ming-Chun Hsieh, Chia-Wei Lin, Yun-Han Shen, et al.

    Here, we develop a digital community management application (APP) and an energy prediction and analysis system for smart communities. The system integrates the internet of things (IoT) technology and multiple prediction models to improve the intelligence and automation of community energy management. The developed APP has the following functions: user classification, announcement notification, express delivery management, GPS positioning navigation, calendar, and energy forecast. The hardware architecture of the system consists of a voltage/current sensing module, a Wireless Fidelity (Wi-Fi) module, and an Arduino platform, allowing real-time feedback and display of power consumption data. The energy forecasting part proposes a two-layer hybrid model architecture. This architecture combines Seasonal Trend decomposition using Loess (STL) time series decomposition, extreme gradient boosting (XGBoost), and Seasonal Autoregressive Integrated Moving Average (SARIMA) models to predict residential electricity consumption trends over the next 3 years. The results of the model prediction are verified using the data on Taiwan’s electricity consumption. The model accurately predicts the average monthly residential electricity consumption with a relative error of 5.8%, an acceptable energy management accuracy. This system integrates APP applications and efficient prediction models, demonstrating its great potential in smart community energy management and enhanced resident interaction.

  • Open Access

    Mild Cognitive Impairment Identification System Based on Physiological Characteristics and Interactive Games

    by Ming-An Chung, Zhi-Xuan Zhang, Jun-Hao Zhang, Chia-Chun Hsu, Yi-Ju Yao, Jin-Hong Chou, Ming-Chun Hsieh, Sung-Yun Chai, Shang-Jui Huang, Kai-Xiang Chen, et al.

    As the global aging population increases, the early detection and prevention of Alzheimer’s disease (AD) have become important in public health. To solve the problems of subjectivity and low timeliness of traditional assessment methods, this paper proposes a multimodal dementia prevention system that combines physiological sensing, a gamification interface, and a classification model. The system includes an interactive joystick to measure pulse and blood pressure. A Chinese music game app increases the participation of the elderly and reduces their sense of rejection through gamification interaction. After the physiological data were standardized by Z-score, they were input into three small sample classifiers (Gaussian Naïve Bayes, Fisher Linear Discriminant Analysis, and Logistic Regression) for the binary classification of AD. The system performance was evaluated using the Leave-One-Out cross-validation method. Experimental results show that Logistic Regression performed best in situations with extremely small samples and class imbalance, with an F1-score of 0.700, which was higher than the other two. Dynamic features and model fusion technologies need to be integrated to further enhance the clinical application potential of the system in the early prediction of dementia.

  • Open Access

    On-Chip Yagi Antenna Design at 38 GHz with 0.18 μm CMOS Techniques

    by Chia-Wei Lin, Ming-An Chung, Bing-Ruei Chuang

    In this study, a 38 GHz millimeter wave Yagi antenna was designed and fabricated on a chip using a 0.18 μm CMOS process. The radiation performance of the antenna is improved by using a Yagi antenna with end-fire. The proposed antenna chip measures the reflection coefficient at less than −10 dB over a bandwidth range from 36.6 to 39.8 GHz, covering the 5G n260 band. The CMOS antenna chip has a size of 1.2×1.2 mm2. This study also proposes a solution for the easy measurement of the radiation characteristics to verify the performance in millimeter wave applications. For this purpose, the chip antenna uses bonding wire technology and is verified in a millimeter wave test system. Finally, the simulation and measurement results of the antenna pattern of the bondline technique yield similar radiation patterns.


  • Open Access

    A Feasibility Study on Enhanced Mobility and Comfort: Wheelchairs Empowered by SSVEP BCI for Instant Noise Cancellation and Signal Processing in Assistive Technology

    by Chih-Tsung Chang, Kai-Jun Pai, Ming-An Chung, Chia-Wei Lin

    Steady-state visual evoked potential (SSVEP)-based brain–computer interface (BCI) technology offers a promising solution for wheelchair control by translating neural signals into navigation commands. A major challenge—signal noise caused by eye blinks—is addressed in this feasibility study through real-time blink detection and correction. The proposed design utilizes sensors to capture both SSVEP and blink signals, enabling the isolation and compensation of interference, which improves control accuracy by 14.68%. Real-time correction during blinks significantly enhances system reliability and responsiveness. Furthermore, user data and global positioning system (GPS) trajectories are uploaded to the cloud via Wi-Fi 6E for continuous safety monitoring. This approach not only restores mobility for users with physical disabilities but also promotes independence and spatial autonomy.


  • Open Access

    Advancing ESG and SDGs Goal 11: Enhanced YOLOv7-Based UAV Detection for Sustainable Transportation in Cities and Communities

    by Ming-An Chung, Tze-Hsun Wang, Chia-Wei Lin

    Environmental, social, and governance issues have gained significant prominence recently, particularly with a growing emphasis on environmental protection. In the realm of heightened environmental concerns, unmanned aerial vehicles have emerged as pivotal assets in addressing transportation challenges with a sustainable perspective. This study focuses on enhancing unmanned aerial vehicles’ object detection proficiency within the realm of sustainable transportation. The proposed method refines the YOLOv7 E-ELAN model, tailored explicitly for traffic scenarios. Leveraging strides in deep learning and computer vision, the adapted model demonstrates enhancements in mean average precision, outperforming the original on the VisDrone2019 dataset. This approach, encompassing model component enhancements and refined loss functions, establishes an efficacious strategy for precise unmanned aerial vehicles object detection. This endeavor aligns seamlessly with environmental, social, and governance principles. Moreover, it contributes to the 11th Sustainable Development Goal by fostering secure urban spaces. As unmanned aerial vehicles have become integral to public safety and surveillance, enhancing detection algorithms cultivates safer environments for residents. Sustainable transport encompasses curbing traffic congestion and optimizing transportation systems, where unmanned aerial vehicle-based detection plays a pivotal role in managing traffic flow, thereby supporting extended Sustainable Development Goal 11 objectives. The efficient utilization of unmanned aerial vehicles in public transit significantly aids in reducing carbon footprints, corresponding to the “Environmental Sustainability” facet of Environmental, Social, and Governance principles.


  • Open Access

    Near Field Sensing Applications with Tunable Beam Millimeter Wave Antenna Sensors in an All-in-One Chip Design

    by Ming-An Chung, Chia-Wei Lin, Wei-Jen Lo

    In this paper, a single-band beam control antenna is designed with a parallel coupler to realize a microstrip patch antenna passive wireless sensor in the form of a chip. It has a phase shift characteristic of the antenna radiation direction in the positive and negative directions. The antenna includes an orthogonal direction coupler design with a 90° parallel coupler in phase using a special structure that allows the whole chip area to be miniaturized while allowing the main beam angle to have a directivity function. The coupler is designed for the 28 GHz millimeter wave band. After feeding the patch antenna at the output port of the coupler and simultaneously feeding the excitation at the input port, the beam phase changes to +45° and +135° with a phase difference of 90°. The designed antenna size is 1160 μm × 790 μm, and the overall IC size is 1.2 mm × 1.2 mm. The power density simulation shows that the maximum power density is only 0.00797 W/kg for a 1 cm2 human sampling area, which means that the antenna sensor is suitable for use on human surfaces.


  • Open Access

    Sound Localization Based on Acoustic Source Using Multiple Microphone Array in an Indoor Environment

    by Ming-An Chung, Hung-Chi Chou, Chia-Wei Lin

    Sound signals have been widely applied in various fields. One of the popular applications is sound localization, where the location and direction of a sound source are determined by analyzing the sound signal. In this study, two microphone linear arrays were used to locate the sound source in an indoor environment. The TDOA is also designed to deal with the problem of delay in the reception of sound signals from two microphone arrays by using the generalized cross-correlation algorithm to calculate the TDOA. The proposed microphone array system with the algorithm can successfully estimate the sound source’s location. The test was performed in a standardized chamber. This experiment used two microphone arrays, each with two microphones. The experimental results prove that the proposed method can detect the sound source and obtain good performance with a position error of about 2.0~2.3 cm and angle error of about 0.74 degrees. Therefore, the experimental results demonstrate the feasibility of the system.


  • Open Access

    The Human—Unmanned Aerial Vehicle System Based on SSVEP—Brain Computer Interface

    by Ming-An Chung, Chia-Wei Lin, Chih-Tsung Chang

    The brain–computer interface (BCI) is a mechanism for extracting information from the brain, with this information used for various applications. This study proposes a method to control an unmanned aerial vehicle (UAV) flying through a BCI system using the steady-state visual evoked potential (SSVEP) approach. The UAV’s screen emits three frequencies for visual stimulation: 15, 23, and 31 Hz for the UAV’s left-turn, forward-flight, and right-turn functions. Due to the requirement of immediate response to the UAV flight, this paper proposes a method to improve the accuracy rate and reduce the time required to correct instruction errors in the resolution of brainwave signals received by UAVs. This study tested ten subjects and verified that the proposed method has a 10% improvement inaccuracy. While the traditional method can take 8 s to correct an error, the proposed method requires only 1 s, making it more suitable for practical applications in UAVs. Furthermore, such a BCI application for UAV systems can achieve the same experience of using the remote control for physically challenged patients.