Zinaida Pobedennaya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zinaida Pobedennaya has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Irina V. Kireeva
National Research Tomsk State University , Novosobornaya Sq.1, Tomsk 634050
6 shared publications Dmitriy Kuksgauzen
Siberian Physical Technical Institute, National Research Tomsk State University, Tomsk, 634050 Russia
2 shared publicationsIrina Bessonova
Siberian Physical Technical Institute, National Research Tomsk State University, Tomsk, 634050 Russia
2 shared publicationsY.I. Chumlyakov
2 shared publicationsYu.I. Chumlyakov
2 shared publications- Анастасия Александровна Сараева
National Research Tomsk State University , Novosobornaya Sq.1, Tomsk 634050
2 shared publications
Latest Publications
- 27 April 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (17)
Effect of silicon and carbon content on shape memory in a single crystals of Fe–Mn–Cr–Ni–Si-based shape memory alloys
The effect of the Si concentration (2.8 and 3.89 wt. %) and carbon alloying 0.18 wt. % on the reversible FCC ↔ HCP martensitic transformation (MT) in a free state and under stress, as well as on the magnitude of the shape memory effect (SME), was studied in [1¯44]-oriented single crystals of Fe–Mn–Cr–Ni–Si-based shape memory alloys. Upon cooling and subsequent heating in a free state, a reversible FCC ↔ HCP MT occurred with a wide thermal hysteresis ΔTh = Af–Ms = 170–195 K, and the alloys exhibited an SME. For the first time, an SME of 17.5% was obtained at 77 K under tension in a carbon-doped alloy, equal in magnitude to the theoretical lattice deformation ε0=17.5% for the FCC–HCP MT. An SME with an ε0 = 17.5% was ensured by strengthening the FCC phase and developing one predominant variant of HCP martensite under stress, while suppressing the formation of irreversible BCT martensite inside the plates of reversible HCP martensite from the onset of transformation and with an increasing strain of up to 20%.
- 27 April 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (17)
Effect of silicon and carbon content on shape memory in a single crystals of Fe–Mn–Cr–Ni–Si-based shape memory alloys
The effect of the Si concentration (2.8 and 3.89 wt. %) and carbon alloying 0.18 wt. % on the reversible FCC ↔ HCP martensitic transformation (MT) in a free state and under stress, as well as on the magnitude of the shape memory effect (SME), was studied in [1¯44]-oriented single crystals of Fe–Mn–Cr–Ni–Si-based shape memory alloys. Upon cooling and subsequent heating in a free state, a reversible FCC ↔ HCP MT occurred with a wide thermal hysteresis ΔTh = Af–Ms = 170–195 K, and the alloys exhibited an SME. For the first time, an SME of 17.5% was obtained at 77 K under tension in a carbon-doped alloy, equal in magnitude to the theoretical lattice deformation ε0=17.5% for the FCC–HCP MT. An SME with an ε0 = 17.5% was ensured by strengthening the FCC phase and developing one predominant variant of HCP martensite under stress, while suppressing the formation of irreversible BCT martensite inside the plates of reversible HCP martensite from the onset of transformation and with an increasing strain of up to 20%.
- 1 January 2022
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 832
Orientation dependence and tension-compression asymmetry of shape memory effect in Ti50Ni40Cu10 single crystals
- 1 January 2022
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 832
Orientation dependence and tension-compression asymmetry of shape memory effect in Ti50Ni40Cu10 single crystals
- 1 December 2020
- Published by Elsevier in Materials Letters
- Vol. 281, 128646
Superelasticity and two-way shape memory effect in [0 0 1]-oriented TiNiCu single crystals under compression
- 1 December 2020
- Published by Elsevier in Materials Letters
- Vol. 281, 128646
Superelasticity and two-way shape memory effect in [0 0 1]-oriented TiNiCu single crystals under compression
- 19 November 2019
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2167 (1) , 020159
Effect of particles on the mechanical behaviour of CoCrFeNiAl0.3 high-entropy alloy single crystals
The effect of γ′-phase particles on the mechanical behaviour was studied in single crystals of the fcc CoCrFeNiAl0.3 (at %) high-entropy alloy (HEA) under tensile strain. It was shown that ageing of the CoCrFeNiAl0.3 HEA single crystals at a temperature of 823 K for 150 hours and at 893 K for 50 hours, results in the precipitation of γ′-phase particles of size d < 5 nm, with L12-type ordering. In the [ ]-oriented crystals, precipitation of γ′-phase particles leads to an increase in critical shear stresses τcr by 25–30 MPa in the temperature range T = 77–873 K, a decrease in the strain hardening coefficient Θ = dσ/dε and an increase in plasticity of 11–14% relative to the initial crystals without particles. The decrease in Θ = dσ/dε and the increase in plasticity are associated with the influence of the γ′-phase particles on the localization of the deformation, predominantly in one system.- 19 November 2019
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2167 (1) , 020159
Effect of particles on the mechanical behaviour of CoCrFeNiAl0.3 high-entropy alloy single crystals
The effect of γ′-phase particles on the mechanical behaviour was studied in single crystals of the fcc CoCrFeNiAl0.3 (at %) high-entropy alloy (HEA) under tensile strain. It was shown that ageing of the CoCrFeNiAl0.3 HEA single crystals at a temperature of 823 K for 150 hours and at 893 K for 50 hours, results in the precipitation of γ′-phase particles of size d < 5 nm, with L12-type ordering. In the [ ]-oriented crystals, precipitation of γ′-phase particles leads to an increase in critical shear stresses τcr by 25–30 MPa in the temperature range T = 77–873 K, a decrease in the strain hardening coefficient Θ = dσ/dε and an increase in plasticity of 11–14% relative to the initial crystals without particles. The decrease in Θ = dσ/dε and the increase in plasticity are associated with the influence of the γ′-phase particles on the localization of the deformation, predominantly in one system.- 19 November 2019
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2167 (1) , 020190
Two-way shape memory effect and its cyclic stability in [001]-oriented CoNiGa single crystal
Two-way shape memory effect (TWSME) and its stability under cooling/heating cycling through the martensitic transformation (MT) temperatures in stress-free condition were investigated in mono-phase [001]-oriented single crystals of the ferromagnetic Co49Ni21Ga30 (at %) alloy. TWSME is induced by thermomechanical training– cooling under different external compressive stress and subsequent stress-free heating. It is shown that the TWSME strain εTWSME depends on the applied stress in the training cycle. The maximum of the εTWSME equal to 4.2(±0.2)% is achieved after training under σext=125 MPa and then decreases with increase of σext. The value of εTWSME = 4.2(±0.2)% is equal to the theoretical transformation strain for [001]-orientation at B2-L10 MT in compression. In crystals after training under σext=125 MPa with maximum εTWSME, the stability of the TWSME strain and martensitic start temperature Ms is observed up to 150 cooling/heating cycling. From 150 to 300 thermocycle, TWSME strain decreases from 4.1(±0.2)% to 3.5(±0.2)%, and the Ms temperature decreases from 251 to 242 K.
- 19 November 2019
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2167 (1) , 020190
Two-way shape memory effect and its cyclic stability in [001]-oriented CoNiGa single crystal
Two-way shape memory effect (TWSME) and its stability under cooling/heating cycling through the martensitic transformation (MT) temperatures in stress-free condition were investigated in mono-phase [001]-oriented single crystals of the ferromagnetic Co49Ni21Ga30 (at %) alloy. TWSME is induced by thermomechanical training– cooling under different external compressive stress and subsequent stress-free heating. It is shown that the TWSME strain εTWSME depends on the applied stress in the training cycle. The maximum of the εTWSME equal to 4.2(±0.2)% is achieved after training under σext=125 MPa and then decreases with increase of σext. The value of εTWSME = 4.2(±0.2)% is equal to the theoretical transformation strain for [001]-orientation at B2-L10 MT in compression. In crystals after training under σext=125 MPa with maximum εTWSME, the stability of the TWSME strain and martensitic start temperature Ms is observed up to 150 cooling/heating cycling. From 150 to 300 thermocycle, TWSME strain decreases from 4.1(±0.2)% to 3.5(±0.2)%, and the Ms temperature decreases from 251 to 242 K.
- 1 February 2009
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 35 (2) , 186-189
Effect of orientation on the high-temperature superelasticity in Co49Ni21Ga30 single crystals
The temperature interval ΔT SE of superelasticity in [001]-, [ $ \bar 1 $ 23]-, and [ $ \bar 1 $ 24]-oriented Co40Ni21Ga30 (at. %) single crystals strained at compression has been studied. It is established that ΔT SE in the [001]-oriented single crystal amounts to 441 K and the reversible B2-L10 martensite transformations in loaded samples take place at T 2 = 698 K. In [ $ \bar 1 $ 23]- and [ $ \bar 1 $ 24]-oriented samples, ΔT SE decreases to 233 K and the superelasticity is observed up to T 2 = 523 K.- 1 February 2009
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 35 (2) , 186-189
Effect of orientation on the high-temperature superelasticity in Co49Ni21Ga30 single crystals
The temperature interval ΔT SE of superelasticity in [001]-, [ $ \bar 1 $ 23]-, and [ $ \bar 1 $ 24]-oriented Co40Ni21Ga30 (at. %) single crystals strained at compression has been studied. It is established that ΔT SE in the [001]-oriented single crystal amounts to 441 K and the reversible B2-L10 martensite transformations in loaded samples take place at T 2 = 698 K. In [ $ \bar 1 $ 23]- and [ $ \bar 1 $ 24]-oriented samples, ΔT SE decreases to 233 K and the superelasticity is observed up to T 2 = 523 K.