Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ryuichi Sugie has a total of 146 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Nondestructive estimation of defect-depth distribution in processed β -Ga 2 O 3 using plan-view cathodoluminescence

    by Ryuichi Sugie, Tomoyuki Uchida, Shinya Honda, Tsutomu Araki

    We propose a nondestructive method for estimating damage depth in processed β -Ga 2 O 3 using plan-view cathodoluminescence (CL). To estimate the depth distribution of nonradiative recombination centers, a model describing the beam-energy dependence of the CL intensity was developed by incorporating a depth-dose function and surface recombination. When applied to silicon (Si)-ion implanted β -Ga 2 O 3 , the estimated defect distributions reasonably agreed with those derived from the cross-sectional CL measurements. In dry-etched samples, defects were concentrated at shallower depths than those in the ion‐implanted samples. This method enables nondestructive estimation of the defect-depth distributions and is applicable to device‐process optimization and device‐failure analysis.

  • Influence of implantation and annealing temperatures on electrical property of low-dose implanted/annealed SiC

    by Kotaro Ishiji, Ryuichi Sugie, Shinichiro Mouri, Tsutomu Araki, Takashi Fujii, Toshiyuki Iwamoto

    Terahertz time-domain ellipsometry was used to examine the electrical properties of low-dose implanted/annealed silicon carbide (SiC) subjected to different implantation and annealing temperatures. P- and Al-implantations were performed at a dose of 2 × 1013 cm−2 and at implantation temperatures of 30 and 500 °C, and the samples were subsequently annealed at 1200 and 1600 °C. For both the P- and Al-implanted/annealed SiC, resistivity was halved when the implantation temperature was increased from 30 to 500 °C. The decrease in resistivity is attributed to the suppression of implantation-induced damage at 500 °C. The resistivity of the P-implanted/annealed SiC decreased drastically as the annealing temperature was increased from 1200 to 1600 °C owing to electrical activation. However, for the Al-implanted/annealed SiC, the resistivity showed little change with increasing annealing temperature. The high ionization energy of Al is considered to have inhibited the reduction in resistivity. These results demonstrate the importance of controlling the implantation and annealing temperatures, even for low-dose implantation.

  • Open Access

    Nanoscale direct patterning in ultrathin silicon nanosheets utilizing helium ion microscopy

    by Yukinori Morita, Kensuke Inoue, Ryuichi Sugie, Shinichi Ogawa

    Using focused helium-ion irradiation by helium-ion microscopy (HIM), we demonstrated the formation of nanosized hole arrays (nanopore arrays) on ultrathin (< 3.6 nm) silicon nanosheets. Nanoscale patterning was conducted by setting the helium ion (He+) acceleration energy to 30 keV and modulating the ion dose to the irradiated area from 1×1017 to 1019 cm-1. The He+ irradiated area was observed as a bright spot on the HIM image at a low dose, which changed to an etch pit-like shape as the dose increased. Cross-sectional transmission electron microscopy (XTEM) observations indicated that the nanosheet where the He+ was irradiated vanished under the increased dose condition, and the area without irradiation was preserved. Simultaneously, blistering was observed over the entire area where the nanopore array was formed. In the XTEM image, a space was formed between the buried oxide film and the Si layer owing to ion implantation.


  • Open Access

    Effect of carbon coating on surface structure in annealing process of high-dose implanted/annealed SiC

    by Kotaro Ishiji, Makoto Arita, Mariko Adachi, Ryuichi Sugie, Yukihiro Morita, Tsutomu Araki

    The effect of carbon coating on a surface structure of a high-dose implanted/annealed silicon carbide (SiC) during annealing was examined using scanning probe microscopy (SPM), deep-ultraviolet (DUV) Raman spectroscopy, and transmission electron microscopy (TEM). In SPM, the surfaces of 500- and 30 °C-implanted/annealed SiC samples without coating exhibited a periodic-step structure and granular structure, respectively. The difference between these surfaces is attributed to the absence or presence of residual implantation damage. In contrast, surface flatness was maintained in the 500 °C-implanted/annealed SiC sample with carbon coating. However, the surface of the coated 30 °C-implanted/annealed SiC sample exhibited a geometric structure with a lattice pattern parallel to the ⟨112¯0⟩ axes. The DUV Raman spectra and TEM images indicated that the implanted layer of this sample metamorphosed into a mixture of 3C-SiC twin domains and amorphous-SiC regions. During the cooling process after annealing, the 3C-SiC region was more raised than the amorphous-SiC region owing to the difference in the thermal expansion coefficients, thus resulting in the generation of a geometric surface structure. In the metamorphosed implanted layer, the carbon coating does not completely prevent surface roughening.


  • 3D structure of threading screw dislocation at a deep location in 4H-SiC using 3D micro-X-ray topography

    by Kotaro Ishiji, Akio Yoneyama, Masayuki Inaba, Kazunori Fukuda, Atsushi Sakaki, Shinya Ohmagari, Ryuichi Sugie

    We used 3D micro-X-ray topography (3D μ-XRT) to construct a 3D structure of the threading screw dislocations (TSDs) in 4H-SiC. The 00012 diffraction condition, which can observe the strain field at a deep location in the sample, was employed in the 3D μ-XRT geometry. The dislocation core-lines of TSDs propagating from the surface to the interior of the sample were successfully captured spatially, and TSDs parallel to and inclined from the 〈0001〉 axis were both confirmed. Either the component 〈 1 ¯ 1 ¯ 20 〉 or 〈 1 ¯ 100 〉 of the Burgers vector is considered to be mixed in the inclined TSD. To verify this suggestion, scanning electron microscopy (SEM) and cathodoluminescence (CL) spectroscopy were performed on the molten-alkali-etched TSDs. Both the SEM shapes and CL intensities of the TSD etch pits with inclination showed the features of the mixed component, supporting the correlation between the inclination and mixed component in TSD.


  • Three-dimensional structure of threading screw dislocation at deep location in 4H-SiC using step-scanning X-ray section topography

    by Kotaro Ishiji, Akio Yoneyama, Masayuki Inaba, Kazunori Fukuda, Atsushi Sakaki, Shinya Ohmagari, Ryuichi Sugie

    2023 International Conference on Solid State Devices and Materials ,Three-dimensional structure of threading screw dislocation at deep location in 4H-SiC using step-scanning X-ray section topography

  • Thermal stress analysis in die-attached β-Ga2O3 using Raman spectroscopy

    by Tomoyuki Uchida, Ryuichi Sugie

    We determine the stress deformation potentials using micro-Raman spectroscopy and evaluate thermal stress in a (−201) plane β-Ga2O3 mounted on a Cu plate with a Pb-free solder. We conduct four-point bending tests and thermomechanical experiments to experimentally determine the stress deformation potentials of Ag(4), Ag(5) and Ag(6) modes. Based on experimental results, we estimate the suitable phonon modes for evaluating the stress, and we apply confocal Raman measurements to a β-Ga2O3 chip mounted on a Cu plate with a Pb-free solder. In accordance with the theoretical relation between the phonon frequency shifts and the stress, we obtain the stress components in the (−201) plane β-Ga2O3 using the peak frequency shift of Ag(4) and Ag(5) modes. The stress components in the (−201) plane is almost same, regardless of the thermal expansion anisotropy of β-Ga2O3, and the results are consistent with those of the finite element method.


  • Direct growth of GaN film on ScAlMgO4 substrate by radio-frequency plasma-excited molecular beam epitaxy

    by Tsutomu Araki, Seiya Kayamoto, Yuuichi Wada, Yuuya Kuroda, Daiki Nakayama, Naoki Goto, Momoko Deura, Shinichiro Mouri, Takashi Fujii, Tsuguo Fukuda, et al.

    ScAlMgO4 (SAM) has attracted attention as a substrate for nitride semiconductor crystal growth owing to its small a-axis lattice mismatch with GaN and InGaN. In this study, we investigated GaN growth on a SAM substrate via radio-frequency plasma-excited molecular beam epitaxy. By optimizing the growth conditions, GaN with the following epitaxial orientation relations (0001)GaN//(0001)SAM and [11–20]GaN//[11–20]SAM was successfully grown directly on the SAM substrate. The atomically flat and abrupt interface of GaN directly grown on the SAM substrate was observed via high-resolution transmission electron microscopy, and uniform GaN growth on a two-inch SAM substrate was also demonstrated.


  • Minority-carrier dynamics in β-gallium oxide probed by depth-resolved cathodoluminescence

    by Ryuichi Sugie, Tomoyuki Uchida

    The behavior of hole polarons in β-gallium oxide (Ga2O3) has attracted significant attention. Depth-resolved cathodoluminescence (CL) was used to investigate the minority carrier dynamics in β-Ga2O3. First, a model describing CL intensity was proposed by considering the depth-dose function and surface recombination. A universal depth-dose function for β-Ga2O3, which has the form of a third-degree polynomial, was presented based on Monte Carlo simulation by introducing a normalized depth, which is the depth normalized by the electron beam range. Second, two experimental approaches, plan-view and cross-sectional CL measurements, were applied to unintentionally doped β-Ga2O3 (−201) wafers, and the experimental results were compared with those of the proposed model. The hole diffusion length was estimated to be within the range of 200–400 nm through the plan-view measurement, whereas a hole diffusion length of 250 nm was obtained through the cross-sectional measurement. The values were consistent with each other, and the model reproduced the experimental results well. This indicates that the nonequilibrium minority hole in the unintentionally doped β-Ga2O3 is mobile and forms a ‘weak’ polaron. The reduced recombination velocity of the (−201) face was estimated to be approximately ten for the plan-view measurement, whereas that of ten or more was assumed for the cross-sectional measurement. No inconsistency was observed, but the low-energy plan-view measurement is considered more suitable for investigating the surface recombination velocity.


  • Weak metastability of Al x Ga1−x N (x = 13/24, 15/24, 17/24) shown by analyzing AlGaN grown on AlN with dense macrosteps

    by Akira Hirano, Yosuke Nagasawa, Masamichi Ippommatsu, Hideki Sako, Ai Hashimoto, Ryuichi Sugie, Yoshio Honda, Hiroshi Amano, Kazunobu Kojima, Shigefusa F. Chichibu

    Energy-dispersive X-ray signals calibrated by Rutherford backscattering indicated the generation of Al13/24Ga11/24N in Ga-rich stripes in a nonflat Al0.58Ga0.42N layer. Also, the CL peak wavelengths of ∼259 and 272 nm also showed the generation of Al15/24Ga9/24N and Al13/24Ga11/24N in Al-rich zones and Ga-rich stripes, respectively. The wavelength of a strong CL peak at ∼246 nm, which was observed from the Al0.7Ga0.3N layer in our previous study, is also considered to correspond to the near-band-emission wavelengths of Al17/24Ga7/24N. In particular, the stronger reproducibility of metastable Al15/24Ga9/24N generation was confirmed, in agreement with the computed predictions by other research groups.