Jianfeng Li

Jianfeng Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jianfeng Li has a total of 170 co-authors. Here are the top co-authors by number of shared publications:

  • Yong Liu

    University of Electronic Science and Technology of China (UESTC)

    46 shared publications
  • Hongyu Luo

    38 shared publications
  • Fei Liu

    Southwest Institute of Technical Physics

    16 shared publications
  • Hongyu Luo

    State Key Laboratory of Electronic Thin Films and Integrated Devices, School of Optoelectronic Science and Engineering, University of Electronic Science and Technology of China (UESTC), Chengdu, Sichuan, China

    9 shared publications
  • Yazhou Wang

    State Key Laboratory of Electronic Thin Films and Integrated Devices, School of Optoelectronic Information, University of Electronic Science and Technology of China (UESTC), Chengdu 610054, China

    9 shared publications
  • Francois Ouellette

    School of Electronic Information and Electrical Enginering, Chengdu University, Chengdu 130012, China

    7 shared publications

Latest Publications

  • Open Access

    Power-Scaled Mode-Locked Femtosecond Pulses from an All-Polarization-Maintaining Tm-Doped Figure-9 Fiber Laser

    by Mingrui Jiang, Ting Wen, Yuhang Wei, Liang Zhao, Senyu Wang, Jinlong Wan, Hongyu Luo, Jianfeng Li

    We demonstrate an all-polarization-maintaining (PM) mode-locked thulium-doped fiber laser operating in the net-normal-dispersion regime based on a figure-9 nonlinear amplifying loop mirror (NALM) configuration. A chirped fiber Bragg grating (CFBG) and a commercial PM dispersion-compensating fiber (PM-DCF) are incorporated into the figure-9 cavity, providing a large normal net dispersion and enabling stable dissipative-soliton mode-locking. Under stable dissipative-soliton operation, the laser delivers a maximum output power of 53.6 mW at a repetition rate of 12.31 MHz, corresponding to a pulse energy of 4.3 nJ. The output spectrum has a central wavelength of ~1952 nm with a 3 dB bandwidth of ~11 nm. The all-PM laser oscillator directly generates a fs pulse without extra-cavity compression, achieving a pulse duration of 545 fs at the CFBG arm. Moreover, stable fundamental mode-locking is verified by a high radio-frequency signal-to-noise ratio (SNR) exceeding 82 dB and a long-term root-mean-square (RMS) power fluctuation of 0.45% over two hours. To the best of our knowledge, this represents the highest output power generated from an all-PM-fiber figure-9 laser oscillator in the 2 μm band, alongside fs-pulse operation. This high-power, compact, stable and environment-insensitive fs-pulsed laser source shows great potential as an ideal seed for biomedical imaging and mid-infrared frequency combs.

  • Open Access

    Ppt-level volatile organic compounds detection via microsecond-pulse-enhanced mid-infrared photoacoustic

    by Senyu Wang, Liang Zhao, Hongyu Luo, Xiangyu Zhao, Jianfeng Li, Wei Wang, Hao Lei, Mingrui Jiang, Jinlong Wan, Binxing Zhao, et al.

  • Open Access

    Machine learning multitarget optimization for ultrashort pulse nonlinear dynamics in optical fibers

    by Liang Zhao, Senyu Wang, Hao Lei, Hongyu Luo, Jianfeng Li, Yong Liu

    The nonlinear propagation of ultrashort laser pulses in optical fibers is an important fundamental aspect of researching nonlinear fiber laser sources, underpinning phenomena such as soliton dynamics and broadband light generation. The advancement of computational methods over the past decade, significantly accelerated by machine learning, has ushered in a new era for researching these complex nonlinear systems. The application of deep learning (DL) technology has demonstrated significant potential in the characterization and prediction of ultrashort pulse nonlinear propagation in optical fibers.1 – 11 The trained deep neural network (DNN) can be utilized to replace the generalized nonlinear Schrödinger equation (GNLSE) physical system in the specific data space, thereby achieving the objective of “concealing the underlying physical model” and significantly enhancing computational efficiency. It is extensively employed in the prediction of nonlinear propagation phenomena, such as ultrashort pulse modulation instability,4 optical soliton propagation,5 and supercontinuum (SC) generation.6 In addition, it is expected to be applied to the exploration of more advanced soliton molecules (such as vector dark-anti-dark solitons and vector anti-dark solitons12).


  • Ultra-low limit of detection of a carcinoembryonic antigen fiber sensor based on microfiber

    by Jinlong Wan, Senyu Wang, Sirong Zhou, Hongxiao Qiu, Rongpei Lu, Mingrui Jiang, Jianfeng Li, Yi Huang, Lulu Cai

    Fiber optic sensors have been widely applied to address issues such as cardiovascular diseases, pathogen detection, and cancer biomarker detection. In this work, an ultra-low limit of detection, high-specificity, and label-free optical fiber biosensor for the detection of carcinoembryonic antigen (CEA) was proposed and experimentally demonstrated. A microfiber interferometer with refractive index sensitivity of up to 1915.955 nm/RIU was employed as the sensor head. The sensitivity of the sensor was further enhanced by the incorporation of molybdenum disulfide (MoS2), which facilitated the immobilization of CEA antibodies as specific detection markers on the microfiber surface. Experimental results showed that the proposed sensor achieved a detection limit of 15.86 fg/mL. The sensitivity of the biosensor was 4.727 nm/log(mg/mL). Notably, this biosensor demonstrated excellent specificity and label-free operation and enabled the detection of low-concentration CEA in approximately 15 minutes. The proposed micro fiber CEA sensor provided a highly sensitive and low-cost method for the early diagnosis of cancer.


  • Open Access

    Ultraflat, Monolithic, Highly Stable Supercontinuum Source Based on Fluorotellurite Fiber

    by Hao Lei, Yadong Jiao, XinSheng Zhao, Kunlin Xie, Junsheng Chen, Wenbo Zhong, Xiaohui Guo, Hongyu Luo, Jianfeng Li, Zhixu Jia, et al.

    Supercontinuum (SC) sources covering near‐infrared and midinfrared region have attracted enormous interest and found significant applications in tissue imaging, sensing, spectroscopy, defense, and environmental monitoring. Herein, an 8.45 W all‐fiber ultraflat SC source with a spectral range of 1.01–4.05 μm using a flat high‐power 1.9–2.7 μm SC fiber source to pump a piece of fluorotellurite fiber is presented. The SC spectrum exhibits a 3 dB bandwidth of 1850 nm, ranging from 1870 to 3720 nm, and a 10 dB bandwidth of 2770 nm, ranging from 1120 to 3890 nm. The measured power stability is 0.19% (root mean square) for 5 h of continuous operation, proving the excellent power stability of the system. To the best of knowledge, the SC spectrum exhibits the widest reported 3 and 10 dB bandwidths for 1–4 μm SC sources.

  • Open Access

    5.3 W/265 μJ Mid-IR All-Fiber Er3+:ZBLAN Gain-Switched Laser Based on Dielectric Fiber Mirror and Fiber-Tip Protection

    by Tingting Chen, Jue Su, Wenbo Zhong, Yu Ding, Lu Huang, Yikun Bu, Jianfeng Li, Zhengqian Luo

    We report a 2.8 μm all-fiber high-power and high-energy gain-switched Er3+:ZBLAN laser based on dielectric fiber mirror and fiber-tip protection. The fiber pigtail mirror, specifically designed for dichroic operation (i.e., anti-reflection at 976 nm pump wavelength and high-reflection around 2.8 μm laser wavelength), shows high damage density of >10 MW/cm2. An anti-reflection protective film is coated on the input tip of Er3+:ZBLAN fiber and an AlF3 endcap is spliced to the output tip of Er3+:ZBLAN fiber for mitigating the fiber-tip photodegradation and high-power catastrophic failure at 2.8 μm. The compact all-fiber cavity is formed by efficiently connecting the Er3+:ZBLAN fiber with dielectric fiber mirror using the standard FC/PC fiber adaptor. When the 976 nm pump operates in pulsed regime, the all-fiber mid-infrared gain-switched laser can be attained with two states of single-pulse and pulse-burst output. The extracted maximum pulse energy is 4.8 μJ in the single-pulse state, and the shortest pulse width is 426 ns. The pulse-burst mode can generate a maximum average power of 5.291 W and burst energy of 264.55 μJ. This work may offer a promising way to realize the low-cost, all-fiber, high-power and high-energy gain-switched laser at MIR wavelengths.


  • Efficient, Tunable 1.7-μm All-Fiber Pulsed Raman Laser Pumped by L-Band DSR Pulses

    by Zhuang Wang, Mingxin Wang, Heping Li, Jianfeng Li, Yong Liu

    We demonstrate a highly efficient, wavelength-adjustable 1.7- $\mu \text{m}$ all-fiber Raman pulse laser, utilizing dissipative-soliton-resonance (DSR) rectangular pulses as the pump. A 50-m GeO2-doped silica fiber serves as the Raman gain medium. When pumped at 1580.2 nm, the 1st-order Raman pulse at 1698.5 nm exhibits a spectral purity as high as 97.7% and a Raman optical conversion efficiency of 59.4%, marking the highest levels ever achieved in a 1.7- $\mu \text{m}$ all-silica-fiber pulsed Raman laser, to the best of our knowledge. The output Raman pulses exhibit a pulse width of approximately 10 ns and achieve a maximum average power of 325.3 mW. By adjusting the central wavelength of DSR pulses, the Raman laser can be continuously tuned across a range of 31.5 nm (1676.4~1707.9 nm). This is the widest tunable range yet reported for an all-silica-fiber pulsed Raman laser operating at $1.7 ~\mu \text{m}$ . Our system offers a simple and attractive solution for the realization of efficient, tunable all-fiber pulse lasers within the 1.7- $\mu \text{m}$ band.


  • High-Power Flat Supercontinuum Generation by Using UHNA7 Fiber With Spectrum of 1.77-3.31 μm

    by Kunlin Xie, Hao Lei, Xuehan Wang, Xinsheng Zhao, Senyu Wang, Hongyu Luo, Jianfeng Li

    In this work, we demonstrated a high-power flat mid-infrared (MIR) supercontinuum (SC) source based on a piece of UHNA7 fiber which pumped by a flat 1.9- $2.6~\mu \text{m}$ SC source. The SC spectrum with a coverage of 1.77- $3.31~\mu \text{m}$ and a maximal average output power of 12.01 W was obtained by optimizing seed pulse parameters and UHNA7 fiber length. The 5 dB spectral bandwidth of SC spectrum was close to ~1000 nm, spanning 1925 to 2894 nm. To the best of our knowledge, this is a MIR SC source that combines high-power and flatness based on low GeO2 doped fiber to date. Furthermore, we investigated the SC power stability, corresponding to the root-mean-square (RMS) value of 0.074% in 1 hour. The set-up has an all-fiber structure and therefore offers excellent portability and stability, making it an ideal light source for fiber optic sensing and spectral imaging technology.


  • Aim at High-Power ∼3.9 μm Lasing: Design of a Lightly-Ho3+-Doped InF$_{\text{3}}$ Fiber Laser via Cascaded Pumping and Transitions

    by Hongyu Luo, Biao Wang, Shiyuan Zhou, Junchuan Shi, Jianfeng Li, Yong Liu

    Rare-earth-doped fluoride fiber provides a compact and robust platform for getting mid-infrared laser at 3∼5 μm that can find direct applications in the fields of spectroscopy, polymer processing, and infrared countermeasures. Based on this strategy, the longest wavelength has been experimentally pushed to ∼3.9 μm, from an 888 nm pumped 10 mol.% heavily-Ho 3+ -doped InF 3 fiber laser [Optica, vol. 5, no. 7, pp. 761-764, 2018]. Its great heat load however, limits the output to ∼200 mW. To solve this problem, we theoretically propose a novel scheme, enabling high-power output with significantly reduced heat load, in which both the concepts of cascaded pumping and transitions have been simultaneously used. Specifically, the dual-wavelength pumping at 1950 nm and 1650 nm (i.e., 5 I 8 → 5 I 7 → 5 I 5 ) is exploited to excite a 1 mol.% lightly-Ho 3+ - doped InF 3 fiber, and the cascaded transitions at ∼3.9 μm and ∼2.9 μm (i.e., 5 I 5 → 5 I 6 → 5 I 7 ) are activated. Consequently, >10 W ∼3.9 μm and >12 W ∼2.9 μm laser outputs have been predicted with the optical-to-optical efficiencies of 31.69% and 40.13%, respectively, indicating at least 50 times power enhancement at ∼3.9 μm. More importantly, the heat load of the pumped fiber end, which is most easily damaged, is only 12.6% of the aforementioned heavily-Ho 3+ -doped system. Further power scaling is mainly hampered by the potential optical damage of InF 3 glass material. On the whole, our work has offered a promising scheme for significantly improving the performance of Ho 3+ -doped InF 3 fiber laser at ∼3.9 μm, hence paving the way for developing high-power fiber laser technique in this band.