MKMobin Safarzadeh Khosrowshahi

Mobin Safarzadeh Khosrowshahi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mobin Safarzadeh Khosrowshahi has a total of 27 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Green synthesis of ZnS/MoS2-decorated porous carbon for photocatalytic degradation of tetracycline under visible light

    by Zahra Amiri, Hosein Banna Motejadded Emrooz, Mobin Safarzadeh Khosrowshahi

    This study investigated a one-step green pyrolysis method inspired by chemical vapor deposition, utilizing melamine and zinc nitrate precursors with varying sulfur content for degradation and adsorption of tetracycline. The method effectively synthesized a ZnS/MoS2 heterojunction composite supported on a porous carbon substrate. It takes advantage of the gases (such as CO2, CO, and H2O) naturally released during pyrolysis to serve as internal activating agents. In contrast to traditional techniques that rely on inert atmospheres, chemical additives, or complicated high-temperature setups, this method minimizes both the ecological footprint and procedural complexity. The optimal composite, PCS2 (synthesized with 2 g of sulfur), exhibited the lowest band gap of 2.91 eV and the highest specific surface area of 216.83 m2 g−1, making it the most effective among the tested samples. This composite achieved 55% adsorption of pollutants and demonstrated a total removal efficiency of 81% for tetracycline. The addition of scavengers revealed that the primary active species in the reaction were holes. This synthesized method shows great promise for preparing heterojunction structures, making it highly suitable for removing organic pollutants from contaminated water.


  • Open Access

    Removal of organic contamination from wastewater using granular activated carbon modified—Polyethylene glycol: Characterization, kinetics and isotherm study

    by Leila Choopani, Mohammad Mehdi Salehi, Hossein Mashhadimoslem, Mobin Safarzadeh Khosrowshahi, Mashallah Rezakazemi, Ali A. AlHammadi, Ali Elkamel, Ali Maleki

    To effectively remove Diazinon (DZ), Amoxicillin (AMX), and Crystal Violet (CV) from aquatic environments, a novel granular activated carbon (GAC) modified with Polyethylene glycol 600 (PEG) was created and manufactured. The chemical properties were investigated using a variety of characteristic analyses, including FT-IR, XRD, FESEM, and N2 adsorption/desorption. The effectiveness of GAC-PEG’s adsorption for the removal of DZ, AMX, and CV was assessed under a variety of conditions, including a pH of 4–9 for the solution, 0.003–0.05 g doses of adsorbent, 50–400 ppm starting concentration, and a reaction time of 5–25 min. For DZ, AMX, and CV adsorption, the maximum adsorption capacity (Qmax) was 1163.933, 1163.100, and 1150.300 mg g-1, respectively. The Langmuir isotherm described all of the data from these adsorption experiments, and the pseudo-second-order well explains all-adsorption kinetics. Most contacts between molecules, electrostatic interactions, π–π interactions, hydrogen bonding, and entrapment in the modified CAG network were used to carry out the DZ, AMX, and CV adsorption on the GAC-PEG. The retrievability of the prepared adsorbent was successfully investigated in studies up to two cycles without loss of adsorption efficiency, and it was shown that it can be efficiently separated.


  • Recent progress on advanced solid adsorbents for CO2 capture: From mechanism to machine learning

    by Mobin Safarzadeh Khosrowshahi, Amirhossein Afshari Aghajari, Mohammad Rahimi, Farid Maleki, Elahe Ghiyabi, Armin Rezanezhad, Ali Bakhshi, Ehsan Salari, Hadi Shayesteh, Hadi Mohammadi


  • Effect of multi-walled carbon nanotube/Porous Carbon/SiO2 on reinforcing of cement mortar matrix: Modeling studies of effective parameters

    by Amirhossein Afshari Aghajari, Mobin Safarzadeh Khosrowshahi, Sina Akhyani, Elahe Ghiyabi, Hosein Banna Motejadded Emrooz, Amir Mohammad Ramezanianpour, Farid Maleki, Hadi Mohammadi


  • Yield prediction and optimization of biomass-based products by multi-machine learning schemes: Neural, regression and function-based techniques

    by Mohammad Rahimi, Hossein Mashhadimoslem, Hung Vo Thanh, Benyamin Ranjbar, Mobin Safarzadeh Khosrowshahi, Abbas Rohani, Ali Elkamel


  • Open Access

    Durable superhydrophobic/superoleophilic melamine foam based on biomass-derived porous carbon and multi-walled carbon nanotube for oil/water separation

    by Hadi Shayesteh, Mobin Safarzadeh Khosrowshahi, Hossein Mashhadimoslem, Farid Maleki, Yahya Rabbani, Hosein Banna Motejadded Emrooz

    In the present study, fabrications of two eco-friendly superhydrophobic/superoleophilic recyclable foamy-based adsorbents for oil/water mixture separation were developed. Hierarchically biomass (celery)-derived porous carbon (PC) and multi-walled carbon nanotube (MWCNT) were firstly synthesized and loaded on pristine melamine foam (MF) by the simple dip-coating approach by combining silicone adhesive to create superhydrophobic/superoleophilic, recyclable, and reusable three-dimensional porous structure. The prepared samples have a large specific surface area of 240 m2/g (MWCNT), 1126 m2/g (PC), and good micro-mesoporous frameworks. The water contact angle (WCA) values of the as-prepared foams, PC/MF and MWCNT/MF, not only were 159.34° ± 1.9° and 156.42° ± 1.6°, respectively but also had oil contact angle (OCA) of equal to 0° for a wide range of oils and organic solvents. Therefore, PC/MF and MWCNT/MF exhibited superhydrophobicity and superoleophilicity properties, which can be considered effective adsorbents in oil/water mixture separations. In this context, superhydrophobic/superoleophilic prepared foams for kind of different oils and organic solvents were shown to have superior separation performance ranges of 54–143 g/g and 46–137 g/g for PC/MF and MWCNT/MF, respectively, suggesting a new effective porous material for separating oil spills. Also, outstanding recyclability and reusability of these structures in the ten adsorption-squeezing cycles indicated that the WCA and sorption capacity has not appreciably changed after soaking into acidic (pH = 2) and alkaline (pH = 12) as well as saline (3.5% NaCl) solutions. More importantly, the reusability and chemical durability of the superhydrophobic samples made them good opportunities for use in different harsh conditions for oil-spill cleanup.


  • Open Access

    Adsorption Equilibrium, Thermodynamic, and Kinetic Study of O2/N2/CO2 on Functionalized Granular Activated Carbon

    by Hossein Mashhadimoslem, Mobin Safarzadeh Khosrowshahi, Mohammad Jafari, Ahad Ghaemi, Ali Maleki

    A volumetric system was used to assess carbon-based adsorbents for evaluation of the gas separation, equilibrium, and kinetics of oxygen (O2), nitrogen (N2), and carbon dioxide (CO2) adsorption on granular activated carbon (GAC) and functionalized GAC at 298, 308, and 318 K under pressures up to 10 bar. The effects of ZnCl2, pH, arrangement of the pores, and heat-treatment temperature on the adsorptive capabilities of O2, N2, and CO2 were evaluated. High-performance O2 adsorption resulted with a fine sample (GAC-10-500) generated with a 0.1 wt % loading of ZnCl2. The optimal sample structure and morphology were characterized by field-emission scanning electron microscopy, Fourier transform infrared spectroscopy, and powder X-ray diffraction. On the basis of the adsorption–desorption results, the fine GAC provides a surface area of 719 m2/g. Moreover, it possessed an average pore diameter of 1.69 nm and a micropore volume of 0.27 m3/g. At 298 K, the adsorption capacity of the GAC-10-500 adsorbent improved by 19.75% for O2 but was not significantly increased for N2 and CO2. Isotherm and kinetic adsorption models were applied to select the model best matching the studied O2, N2, and CO2 gas uptake on GAC-10-500 adsorbent. At 298 K and 10 bar, the sip isotherm model with the highest potential adsorption difference sequence and gas adsorption difference compared with pure GAC adsorbent as O2 > N2 > CO2 follows well for GAC-10-500. Eventually, the optimal sample is more effective for O2 adsorption than other gases.


  • Open Access

    Oxygen and nitrogen enriched pectin-derived micro-meso porous carbon for CO 2 uptake

    by Milad Vafaeinia, Mobin Safarzadeh Khosrowshahi, Hossein Mashhadimoslem, Hosein Banna Motejadded Emrooz, Ahad Ghaemi

    Oxygen and nitrogen enriched micro–meso porous carbon powders have been prepared from pectin and melamine as oxygen and nitrogen containing organic precursors, respectively. The synthesis process has been performed following a solvothermal approach in an alkaline solution during which Pluronic F127 was added to the solution as the soft template. Following the solvothermal treatment, the carbonization process has been performed at 700, 850 and 950 °C. The synthesized porous carbons have been characterized by X-ray diffraction (XRD), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), nitrogen adsorption–desorption isotherms and Fourier transform infrared spectroscopy (FTIR). The surface area of 499.5 m2 g−1, total pore volume of 0.35 cm3 g−1, and a high nitrogen and oxygen content of 9.3 and 29.1 wt% are displayed for the fine sample. The optimal porous carbon had CO2 adsorption of up to 3.1 mmol g−1 at 273 K at 1 bar owing to abundant basic nitrogen-containing functionalities and the valuable micro–meso porous structure. Despite the absence of any reagent and also having a relatively moderate specific surface area, compared to similar materials, a very high ratio of adsorption capacity to specific surface area (6.2 μmol m−2) was observed. The Elovich kinetic model was found to be the best and the physisorption process was reported.