Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nikolay Monarkin has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Numerical study of air distribution in apartment premises using compact regenerative heat exchangers

    by N. N. Monarkin, V. A. Iakovlev, T. V. Monarkina

    Численное исследование воздухораспределения в помещениях квартир при использовании компактных регенеративных теплоутилизаторов

  • Open Access

    Maintenance of the required indoor air exchange rate by using compact regenerative heat exchangers

    by Nikolay N. Monarkin

    Introduction. Ventilation systems of civil buildings experience problems of air exchange interruption and high heat losses. A solution to this problem is the use of compact decentralized ventilation units with the function of heat recovery from exhaust air. They are called stationary switching regenerative heat exchangers (SSRHEs). SSRHEs ensure high energy saving at low air flow rates. However, the required air exchange rate can be substantial even for one person. Therefore, a study was conducted to determine values of the energy efficiency coefficient of SSRHEs for the range of characteristic air flow rates. Materials and methods. The analysis of regulations and research papers, focused on determining the indoor air exchange required for one person was conducted. The air exchange rate is mainly determined through the recommended level of carbon dioxide concentration in a room. The energy efficiency coefficient of SSRHEs is determined by means of mathematical modeling of the heat exchange process in a single channel of a regenerative nozzle. Results. Values of the energy efficiency coefficient of SSRHEs are provided for a wide range of air flow rates. Efficiency reduction, accompanied by an increase in the rate of the air flow through the SSRHE, as well as a decrease in the nozzle length and an increase in the diameter of a single channel are shown. Recommendations are provided on the design of a regenerative nozzle that ensures extensive thermal energy savings at high air flow rates through the SSRHEs. Conclusions. Taking into account a wide range of values of the amount of air required per person, SSRHE capacity control is recommended. Research results can be used to modernize existing devices and develop new configurations of nozzles for such SSRHEs. The authors have found that experimental studies of the proposed configurations are needed to evaluate the level of noise generated by SSRHEs and the optimal nozzle design mitigating the risk of clogging.


  • Open Access

    Experimental Research of a Regenerative Heat Exchanger

    by Nikolay Monarkin, Tat’yana Monarkina

    Stationary switching regenerative heat exchangers (SSRHEs) are used for the ventilation of premises. The mathematical modeling of heat exchange between air and a regenerative nozzle is used to design the SSRHEs and determine their main parameters. The numerical solution of the proposed mathematical model has been experimentally tested for adequacy. The calculated and experimental values of the air temperature at the ends of the SSRHE are compared. It is determined that the proposed model is adequate and can be used in further research.


  • Open Access

    The influence of main parameters of regenerative heat exchanger on its energy efficiency

    by Nikolay Monarkin, Anton Sinitsyn, Mikhail Pavlov, Timur Akhmetov

    The influence of various parameters of stationary switching regenerative heat exchangers used for ventilation on its thermal efficiency was studied. Considered are the geometric (length, diameter and wall thickness of a single equivalent nozzle channel), thermophysical (density and heat capacity of the nozzle material) and operation (air flow through the regenerator and the time of one stage of accumulation/regeneration of thermal energy) parameters.


  • Open Access

    Assessment of energy efficiency of application heat-insulating paint for the needs of district heat supply systems

    by Mikhail Pavlov, Denis Karpov, Irina Akhmetova, Nikolay Monarkin

    Energy conservation is a priority for most of the nation states. Its relevance in modern world energy industry is growing every year. This problem acquires particular importance when a country is characterized by a lack of fuel and energy resources or adverse climatic conditions. The most effective way to reduce heat losses from heat network pipelines to environment is the use of heat insulation. This paper presents the results of application heat-insulating paint on the surface of main pipeline. The infrared thermometry devices (pyrometer and thermal imager) were used to evaluate the energy efficiency of modern high-tech insulation. The thermograms from thermal imager and the readings from pyrometer were analyzed, it was established that the absolute difference in temperatures of an isolated pipeline section and an unpainted section are 5-10 °C. The studies have also shown that when a 250×6 pipeline is coated with a 1 mm thick heat-insulating paint, it will save 126.1 m3 of natural gas per 1 running meter per year. In monetary terms it will be approximately 610 rubles or about $9 (for the first half of 2020). The payback period of this energy-saving measure should not exceed six months. Increasing the thickness of liquid heat insulation layer is not economically feasible. The equivalent fuel economy is approximately 65% when the heat-insulating paint is of 1 mm thickness, and it will increase by only 8% for a thickness of 1.5 mm.


  • Open Access

    Methodology for assessing technological efficiency and safety at the enterprise for production of reinforced concrete structures

    by Anton Sinitsyn, Oleg Stratunov, Timur Akhmetov, Nikolay Monarkin

    This paper considers the main results of instrumental analysis of technological efficiency and safety, and suggestions for improving the working conditions of workers engaged in steaming of reinforced concrete products in steam curing chambers operating on saturated steam. This work is a part of comprehensive energy study of enterprise to find measures that increase the energy potential of not only the enterprise itself, but also reduce the cost of primary and auxiliary products by reducing costs in its production. An optimized scheme for delivery, transporting and consumption of water vapour was implemented in the real sector of the economy in Vologda (Russia).

  • Open Access

    Method for designing energy-efficient ventilation systems based on regenerative heat exchangers

    by Nikolay Monarkin, Anton Sinitsyn, Denis Karpov, Timur Akhmetov

    The method of designing ventilation systems based on stationary switching regenerative heat exchangers is presented. Recommendations for selection of rational device parameters are given and substantiated. The diameter and thickness of a single channel wall of regenerative nozzle; the total diameter and length of nozzle; the time of heat accumulation or regeneration stages; the heat capacity and density of nozzle material; air flow rate are considered.


  • Open Access

    FEATURES OF MOUNTED VENTILATED FACADE HEAT CONTROL SYSTEMS IN CONSTRUCTION PROJECTS

    by D. F. Karpov, M. V. Pavlov, A. A. Sinitsyn, N. N. Monarkin, A. G. Gudkov

    Abstract. Aim.An integral part of an energy audit of buildings and structures consists in thermal imaging diagnostics. This permits an evaluation of the heat-shielding properties of the enclosing structures of buildings in order to control the functional and operational status of engineering systems, as well as to identify implicit (invisible) and explicit (visible) defects in them. The aim of the work is to analyse some features and results of thermal control of an opaque hinged ventilated facade system and translucent enclosing structures in the form of window systems of a capital construction project.Method.Thermal imaging was used as a control for resolving issues of energy and resource conservation. The special importance of thermal control of translucent facade systems and non-translucent hinged ventilated facades of capital construction projects having various functional and operational purposes is highlighted.Results.A detailed algorithm is presented for supporting a comprehensive diagnosis of the heat engineering state of building envelopes for various construction projects by analysing thermograms, using thermal monitoring methods, to take into consideration engineering systems, building materials and finished products, along with technologies of full-scale thermal imaging inspection of translucent building envelopes. The obtained thermograms are presented and analysed.Conclusion.Current problems in the fields of energy efficiency and energy saving in the construction and energy industries are considered in the light of the latest technological developments. The proposed graph-analytical algorithm supporting a diagnosis of the heat engineering state of building envelopes based on the analysis of thermograms is the most comprehensive among known analogues and prototypes


  • Open Access

    Modelling the boundary temperature regime in a regenerative heat recovery unit using differential equations and artificial neurons

    by Nikolay Monarkin, Alizhon Naimov, T. R. Akhmetov

    The mathematical model of boundary temperature regime for accumulation and recovery of heat in a stationary switching regenerative heat recovery unit (SRHRU) is constructed. Modelling of the boundary regime in SRHRU is based on experimental data, and it is required to develop algorithms for calculating thermal constants and the general temperature regime. The boundary temperature regime is modelled by a system of nonlinear ordinary differential equations of the first order, which take into account the results of experimental observations and measurements. To determine the unknown parameters of the system of differential equations, artificial neurons are used: a two-layer perceptron is developed with three neurons on the first layer and with five neurons on the second layer.