Jingcheng Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Jingcheng Liu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Dayong Li
1 shared publication- Geng Wang
Key Laboratory of Testing Technology for Manufacturing Process of Ministry of Education, Southwest University of Science and Technology, Mianyang 621010, China
1 shared publication - Ke Li
School of Mechanical and Power Engineering, Henan Polytechnic University, Jiaozuo 454000, China
1 shared publication - Maolin Cai
School of Automation Science and Electrical Engineering, Beihang University, Beijing 100191, China
1 shared publication Qian-Jian Guo
Shandong Provincial Key Laboratory of Precision Manufacturing and Non-traditional Machining, Shandong University of Technology, Zibo, People’s Republic of China
1 shared publication- Xiuting Wei
School of Mechanical Engineering, Shandong University of Technology, Zibo, China
1 shared publication
Latest Publications
- 20 October 2021
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 58 (5) , 835-847
Fluid flow and heat transfer characteristics in plate-fin heat exchanger with irregular-shaped hole leading flow structure
- 20 October 2021
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 58 (5) , 835-847
Fluid flow and heat transfer characteristics in plate-fin heat exchanger with irregular-shaped hole leading flow structure
- Open Access
Nonlinear Model Establishment and Experimental Verification of a Pneumatic Rotary Actuator Position Servo System
In order to accurately reflect the characteristics and motion states of a pneumatic rotary actuator position servo system, an accurate non-linear model of the valve-controlled actuator system is proposed, and its parameter identification and experimental verification are carried out. Firstly, in the modeling of this system, the mass flow rate of the gas flowing through each port of the proportional directional control valve is derived by taking into account the clearance between the valve spool and the sleeve, the heat transfer formula is used to the derivation of the energy equation, and the Stribeck model is applied to the friction model of the pneumatic rotary actuator. Then, the flow coefficient, the heat transfer coefficient and the friction parameters are identified by the model and pneumatic test circuits. After the verification experiment of the mass flow rate equations, the charging and discharging experiment reveals that the model can clearly show the effect of clearances on gas pressure changes and describe the effect of heat transfer on gas temperature changes. Finally, the results of model verification indicate that the simulation curves of rotation angle and two-chamber pressures are consistent with their experimental values, and the non-linear model shows high accuracy.
Open AccessNonlinear Model Establishment and Experimental Verification of a Pneumatic Rotary Actuator Position Servo System
In order to accurately reflect the characteristics and motion states of a pneumatic rotary actuator position servo system, an accurate non-linear model of the valve-controlled actuator system is proposed, and its parameter identification and experimental verification are carried out. Firstly, in the modeling of this system, the mass flow rate of the gas flowing through each port of the proportional directional control valve is derived by taking into account the clearance between the valve spool and the sleeve, the heat transfer formula is used to the derivation of the energy equation, and the Stribeck model is applied to the friction model of the pneumatic rotary actuator. Then, the flow coefficient, the heat transfer coefficient and the friction parameters are identified by the model and pneumatic test circuits. After the verification experiment of the mass flow rate equations, the charging and discharging experiment reveals that the model can clearly show the effect of clearances on gas pressure changes and describe the effect of heat transfer on gas temperature changes. Finally, the results of model verification indicate that the simulation curves of rotation angle and two-chamber pressures are consistent with their experimental values, and the non-linear model shows high accuracy.