Irene Díaz-Herrezuelo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Irene Díaz-Herrezuelo has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Alma D. Salazar-Aguilar
Departamento de Ingeniería Química, Tecnológico Nacional de México, Instituto Tecnológico de Celaya, Av. García Cubas Pte # 600 esq. Avenida Tecnológico, Celaya 38010, Mexico
1 shared publication - Asuncion Quintanilla
Department of Chemical Engineering, Universidad Autónoma de Madrid, Campus de Cantoblanco, C/Francisco Tomás y Valiente 7, 28049 Madrid, Spain
1 shared publication - Jose Antonio Casas
Departamento de Ingeniería Química, Universidad Autónoma de Madrid, Ctra. Colmenar km 15 (28049), Madrid, Spain
1 shared publication - Manuel Belmonte
Institute of Ceramics and Glass (ICV-CSIC), Campus de Cantoblanco, C/Kelsen 5, 28049 Madrid, Spain
1 shared publication - Pablo López
Chemical Engineering Department, Universidad Autónoma de Madrid, Ctra. Colmenar km 15, 28049 Madrid, Spain
1 shared publication - Sofía Magdalena Vega-Díaz
Shinshu University
1 shared publication
Latest Publications
- Open Access
Monolithic Stirrer Reactors for the Sustainable Production of Dihydroxybenzenes over 3D Printed Fe/γ-Al2O3 Monoliths: Kinetic Modeling and CFD Simulation
The aim of this work is to evaluate the performance of the stirring 3D Fe/Al2O3 monolithic reactor in batch operation applied to the liquid-phase hydroxylation of phenol by hydrogen peroxide (H2O2). An experimental and numerical investigation was carried out at the following operating conditions: CPHENOL,0 = 0.33 M, CH2O2,0 = 0.33 M, T = 75–95 °C, P = 1 atm, ω = 200–500 rpm and WCAT ~ 1.1 g. The kinetic model described the consumption of the H2O2 by a zero-order power-law equation, while the phenol hydroxylation and catechol and hydroquinone production by Eley–Rideal model; the rate determining step was the reaction between the adsorbed H2O2, phenol in solution with two active sites involved. The 3D CFD model, coupling the conservation of mass, momentum and species together with the reaction kinetic equations, was experimentally validated. It demonstrated a laminar flow characterized by the presence of an annular zone located inside and surrounding the monoliths (u = 40–80 mm s−1) and a central vortex with very low velocities (u = 3.5–8 mm s−1). The simulation study showed the increasing phenol selectivity to dihydroxybenzenes by the reaction temperature, while the initial H2O2 concentration mainly affects the phenol conversion.
Open AccessMonolithic Stirrer Reactors for the Sustainable Production of Dihydroxybenzenes over 3D Printed Fe/γ-Al2O3 Monoliths: Kinetic Modeling and CFD Simulation
The aim of this work is to evaluate the performance of the stirring 3D Fe/Al2O3 monolithic reactor in batch operation applied to the liquid-phase hydroxylation of phenol by hydrogen peroxide (H2O2). An experimental and numerical investigation was carried out at the following operating conditions: CPHENOL,0 = 0.33 M, CH2O2,0 = 0.33 M, T = 75–95 °C, P = 1 atm, ω = 200–500 rpm and WCAT ~ 1.1 g. The kinetic model described the consumption of the H2O2 by a zero-order power-law equation, while the phenol hydroxylation and catechol and hydroquinone production by Eley–Rideal model; the rate determining step was the reaction between the adsorbed H2O2, phenol in solution with two active sites involved. The 3D CFD model, coupling the conservation of mass, momentum and species together with the reaction kinetic equations, was experimentally validated. It demonstrated a laminar flow characterized by the presence of an annular zone located inside and surrounding the monoliths (u = 40–80 mm s−1) and a central vortex with very low velocities (u = 3.5–8 mm s−1). The simulation study showed the increasing phenol selectivity to dihydroxybenzenes by the reaction temperature, while the initial H2O2 concentration mainly affects the phenol conversion.