SCSi-Meng Chen

Si-Meng Chen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Si-Meng Chen has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Wide Memory Window of 10.3 V With Ferroelectric AlScN Layer In 2 O 3 FeFET

    by Jia-Hong Lin, Si-Meng Chen, An Li, Ting-Tzu Kuo, Hirofumi Nishida, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Ting-Chang Chang, Kuniyuki Kakushima

  • Polarity control of sputter-deposited wurtzite AlScN thin films by AlSc seed layer

    by K. Onimura, Y. Wu, H. Kobayashi, T. Hoshii, S.-M. Chen, H. Nishida, K. Kakushima

    The effect of a thin-AlSc seed layer on the polarity of the ferroelectric Al0.87Sc0.13N films was investigated. The polarity of AlScN films was evaluated through measuring capacitance responses of metal–ferroelectric–metal capacitors. A capacitance peak appeared in the first negative-voltage sweep, confirming N-polarity AlScN films formed on a Ta electrode. On the other hand, a capacitance peak was observed during the first positive voltage sweep with the insertion of the AlSc seed layer, suggesting that the films were in a metal-polar state. Piezoelectric force microscopy also confirmed the polarity change. The conditions of substrates for metal-polar AlScN are summarized. The AlSc seed layer with a hexagonal face turned out to be important for metal-polar AlScN. The present results give an insight into controlling the polarity of nitride-based dielectrics and semiconductors.

  • On the enhancement of capacitive memory window for ferroelectric AlScN films using metal-capping oxidation (MCO) process

    by Si-Meng Chen, Shun Komai, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Kuniyuki Kakushima

    The capacitive readout scheme with crossbar arrays and ferroelectric (FE) materials has enlightened the way of non-destructive operations to realize advanced memory technologies with better power efficiency and endurance. However, reports on wurtzite-based FE materials targeting this scheme are still lacking. In this study, we introduce a metal-capping oxidation (MCO) process to indirectly oxidize the AlScN FE thin film through an ultra-thin metal-capping layer. W and Ti were selected due to their suitable oxygen chemical potential and multivalent nature to transport O atoms to the FE layer. Improved breakdown strength, mitigated leakage, as well as remanent polarization restoration were demonstrated by MCO-treated AlScN FE thin films. The imprint effect was greatly promoted and remarkably led to over three-fold increment of capacitive memory window (MW). Besides, the FE films exhibited minimal variation in dielectric permittivity and capacitive MW after 100 cycles of endurance switching, further showcasing the feasibility of this approach.

  • Polarity-dependent asymmetric switching of ferroelectric AlScN thin films

    by Hirofumi Nishida, Si-Meng Chen, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Kuniyuki Kakushima

    Polarity-dependent ferroelectric switching of AlScN films on different electrode materials (TiN and Ta) was characterized by pulse measurements. The absolute coercive fields obtained with positive pulses were lower than those with negative pulses for both electrodes, suggesting a polarity-dependent energy barrier difference in ferroelectric switching. The switching with positive pulses follows nucleation-limited switching model, whereas the Kolmogorov–Avrami–Ishibashi model fits well for negative pulses. The asymmetry was modeled by assuming an unswitched region near the bottom electrodes, inferred from thickness-dependent capacitance measurements, forming an energetically less stable 180° ferroelectric domain wall.


  • Interpretation of ferroelectric behavior in AlScN films with TiN and Ta bottom electrodes

    by Ting-Tzu Kuo, Ting-Mao Feng, Si-Meng Chen, Hitomi Hasegawa, Jia-Hong Lin, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Ying-Chung Chen, Ting-Chang Chang, et al.

    Ferroelectric properties of 50-nm-thick Al0.88Sc0.12N films with different bottom electrodes (BEs) of TiN and Ta were characterized. Capacitance–voltage (C–V) curves of the capacitors indicate sharp switching with the Ta BE, whereas partial polarization can be obtained with the TiN BE. By analyzing the electric field distribution of the partial polarization obtained from positive-up negative-down measurements, two kinds of coercive field (Ec) with Lorentzian distributions can be extracted: one high Ec with AlScN domains and another low Ec with defect-incorporated domains. The distribution of the inverted nucleus becomes narrower with the Ta BE and appears to correlate with the degree of c-axis orientation evaluated by rocking-curve x-ray diffraction. The defect-incorporated domains were found to shift their mean Ec to a higher electric field by switching cycles, resulting in the fatigue effect. The present interpretation provides insight into understanding the ferroelectric behavior of AlScN films.

  • Area and polarity-dependent switching in AlScN ferroelectric capacitors

    by Hirofumi Nishida, Si-Meng Chen, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Kuniyuki Kakushima

    Area-dependent properties of ferroelectric AlScN capacitors were characterized. Capacitance-voltage (CV) measurements showed identical peak capacitance voltages across the electrode areas, and leakage current measurements showed negligible differences in insulating properties. However, positive-up negative-down (PUND) measurements revealed area dependence: higher remnant polarization (Pr) and lower coercive field (Ec) for smaller areas. As the electric-field-induced lateral distortion is the origin of the AlScN ferroelectricity, the piezoelectric effect of the AlScN film was used to explain the area-dependent behavior. Due to the fixed boundary condition at the electrode edge, lateral stress accumulation in AlScN films toward the center of the electrode increases the energy barrier to switching, thereby increasing Ec.


  • Open Access

    Oxygen-Atom Incorporated Ferroelectric AlScN Capacitors for Multi-Level Operation

    by Si-Meng Chen, Hirofumi Nishida, Sung-Lin Tsai, Takuya Hoshii, Kazuo Tsutsui, Hitoshi Wakabayashi, Edward Yi Chang, Kuniyuki Kakushima

    The effect of oxygen-atom incorporation in 50-nm-thick ferroelectric Al0.89Sc0.11N films was investigated. The fabricated films exhibited a high remanent polarization ( ${P}_{\text {r}})$ exceeding $100~\mu $ C/cm2, irrespective of the oxygen content studied. An increase in oxygen content led to a decrease in coercive field ( ${E}_{\text {c}})$ from 5.2 to 4.4 MV/cm and an increase in the static dielectric constant ( $\varepsilon _{\text {i}})$ from 15 to 19. This was likely due to the formation of substitute O and Al vacancy complex defects to ease N-atom displacement. Additionally, higher oxygen content resulted in imprint effect elimination, leakage current reduction, and breakdown field ( ${E}_{\text {BD}})$ enhancement, which are beneficial for ferroelectric memory applications. The gentle and linear relationship between ${P}_{\text {r}}$ and the electric field ( ${E})$ enabled precise control of partial polarization switching, supporting multi-level operation. Although issues related to fatigue and endurance cycles remain to be addressed, the high ${P}_{\text {r}}$ and potential for multi-level operation are suitable for crossbar-based analog in-memory computing.


  • Reactive sputtering of ferroelectric AlScN films with H2 gas flow for endurance improvement

    by Si-Meng Chen, Takuya Hoshii, Hitoshi Wakabayashi, Kazuo Tsutsui, Edward Yi Chang, Kuniyuki Kakushima

    The impact of H2 gas flow in the reactive sputtering process to 60 nm-thick ferroelectric Al1−x Sc x N films is investigated with x of 0.26 (high-Sc) and 0.12 (low-Sc). Al1−x Sc x N films exhibit clear ferroelectric switching, confirming the robustness against reducing ambient. The dielectric constants (ε i) as well as the leakage current decrease, and the breakdown field (E BD) increases with H2 flow. Although the remanent polarization (P r) decreases with H2 flow, the wake-up effect is suppressed for the high-Sc film, and the fatigue effect is weakened for the low-Sc film. By probing the change in the coercive field (E c) after the switching cycle test, we anticipate oxygen impurities bonded to Sc and Al atoms are the source of wake-up and fatigue effects, respectively. As a result, a high endurance cycle of 2 × 107 times was achieved for low-Sc films with H2 flow.


  • Electrical Characteristics of In0.53Ga0.47As Gate-All-Around MOSFETs With Different Nanowire Shapes

    by Hua-Lun Ko, Quang Ho Luc, Ping Huang, Si-Meng Chen, Jing-Yuan Wu, Nhan-Ai Tran, Edward Yi Chang

    In this article, we investigate the electrical properties of In $_{\text{0.53}}$ Ga $_{\text{0.47}}$ As gate-all-around (GAA) MOSFETs with different nanowire shapes. InGaAs GAA MOSFETs with trapezoid and triangle nanowire shapes have been fabricated and characterized. Improved output performance was observed as the nanowire top width reduces from 20 to 11 nm. It was found that the electrical characteristics degraded as the nanowire top width was decreased to nearly 0 nm. To explain the carrier transport mechanism in ultralow-scale devices, TCAD simulation has been performed to study the electron density distribution for different nanowire widths and explain the transport mechanism in these ultralow-scale transistor devices.


  • GaN high electron mobility transistors (HEMTs) with self-upward-polarized AlScN gate dielectrics toward enhancement-mode operation

    by Si-Meng Chen, Sung-Lin Tsai, Kazuto Mizutani, Takuya Hoshii, Hitoshi Wakabayashi, Kazuo Tsutsui, Edward Yi Chang, Kuniyuki Kakushima

    A threshold voltage ( V th ) shifting method for GaN high electron mobility transistors using self-upward polarized Al 1- x Sc x N gate dielectrics was proposed. The direction of the spontaneous polarization was controlled by the insertion of an Al 2 O 3 layer between the Al 1- x Sc x N and the AlGaN layers. A V th shift of 8 V was found by changing the direction of the polarization. The thickness scaling in the Al 1- x Sc x N layer from 40 to 30 nm showed a linear relationship to the V th , revealing to retain a high spontaneous polarization. A high positive V th for enhancement-mode (E-mode) operation is feasible with the method in combination with a recess process.