Anisha Arora
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Anisha Arora has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Harshita Pant
Department of Manufacturing Engineering, School of Mechanical Engineering, Vellore Institute of Technology, Vellore, India
2 shared publications - Utkarsh Chadha
Department of Materials Science and Engineering, Faculty of Applied Sciences and Engineering, University of Toronto
2 shared publications - Albert E. Patterson
Texas A&M University
1 shared publication Amir Saeidi
Department of Engineering Technology and Industrial Distribution, Texas A &M University, College Station, USA
1 shared publication- Arisha Chadha
Prakash Higher Secondary School, Ahmedabad 380059, Gujarat, India
1 shared publication - Divyansh Srivastava
Technische Universität Darmstadt, Darmstadt, Germany
1 shared publication
Latest Publications
- Top Cited Papers
- 10 July 2023
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 127 (11-12) , 4995-5011
Applications of wire arc additive manufacturing (WAAM) for aerospace component manufacturing
- 10 July 2023
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 127 (11-12) , 4995-5011
Top Cited PapersApplications of wire arc additive manufacturing (WAAM) for aerospace component manufacturing
- Open Access
- 4 February 2022
- Published by Hindawi Limited in Advances in Materials Science and Engineering
- Vol. 2022, 1-14
Phase Change Materials in Metal Casting Processes: A Critical Review and Future Possibilities
Phase change materials are the category of materials that release or absorb enough energy during phase change transformation to provide heating or cooling. Divided into two principal classes of organic and inorganic, these materials find a wide range of uses in commercial applications of casting where stable temperature and heat storage are a requirement. In this research work, application of inorganic phase change materials having significantly elevated temperature zone, especially within metal casting processes, has been discussed. Phase change material with high enthalpy of fusion and high melting point can be used for metal casting, but in a limited temperature range (between 200°C and 1300°C). In sand casting, inorganic PCM has the potential to be used as chills to provide directional solidification. Despite having advantages, inorganic PCM comes with major disadvantages, that is, toxicity, corrosivity, supercooling, and low thermal expansion. Few solutions to overcome these problems have been discussed in this research paper. Future research is required to reduce the disadvantage to a low level, so that PCM can be used in application where elevated temperature is achieved.
- 4 February 2022
- Published by Hindawi Limited in Advances in Materials Science and Engineering
- Vol. 2022, 1-14
Open AccessPhase Change Materials in Metal Casting Processes: A Critical Review and Future Possibilities
Phase change materials are the category of materials that release or absorb enough energy during phase change transformation to provide heating or cooling. Divided into two principal classes of organic and inorganic, these materials find a wide range of uses in commercial applications of casting where stable temperature and heat storage are a requirement. In this research work, application of inorganic phase change materials having significantly elevated temperature zone, especially within metal casting processes, has been discussed. Phase change material with high enthalpy of fusion and high melting point can be used for metal casting, but in a limited temperature range (between 200°C and 1300°C). In sand casting, inorganic PCM has the potential to be used as chills to provide directional solidification. Despite having advantages, inorganic PCM comes with major disadvantages, that is, toxicity, corrosivity, supercooling, and low thermal expansion. Few solutions to overcome these problems have been discussed in this research paper. Future research is required to reduce the disadvantage to a low level, so that PCM can be used in application where elevated temperature is achieved.