Shuhua Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Shuhua Yuan has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Dongzhou Zhang
Center for Advanced Radiation Sources The University of Chicago Chicago IL USA
2 shared publications - Haozhe Liu
Center for High Pressure Science and Technology Advanced Research
2 shared publications - Vitali B. Prakapenka
University of Chicago
2 shared publications Fuyang Liu
Center for High Pressure Science and Technology Advanced Research, Beijing 10094, People's Republic of China
1 shared publication- Fuyang Liu
Ctr High Pressure Sci & Technol Adv Res, Beijing 100094, Peoples R China
1 shared publication - Jianzong Wang
Center for High Pressure Science and Technology Advanced Research, Beijing 10094, People's Republic of China
1 shared publication
Latest Publications
- 20 July 2023
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 56 (4) , 1125-1130
Structure evolution of Bi4O7 under high pressure
X-ray diffraction and Raman spectroscopy measurements were used to study the structure evolution of Bi4O7 during compression. Two isostructural phase transitions were observed under high pressure, with the first transition to phase II occurring at approximately 3.0 (2) GPa and the second to phase III occurring at approximately 13.0 (5) GPa. The pressure–volume (P–V) curve was found to be discontinuous at those two pressure transition boundaries. By fitting the P–V curves in three different stages, the bulk moduli were estimated to be approximately 101 (2), 68 (2) and 172 (3) GPa. Such large differences in the bulk moduli confirm two isostructural phase changes in the three stages. An irreversible amorphization process was found to start at approximately 20 (1) GPa, and the sample gradually becomes fully amorphous during compression at 30 (1) GPa.
- 20 July 2023
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 56 (4) , 1125-1130
Structure evolution of Bi4O7 under high pressure
X-ray diffraction and Raman spectroscopy measurements were used to study the structure evolution of Bi4O7 during compression. Two isostructural phase transitions were observed under high pressure, with the first transition to phase II occurring at approximately 3.0 (2) GPa and the second to phase III occurring at approximately 13.0 (5) GPa. The pressure–volume (P–V) curve was found to be discontinuous at those two pressure transition boundaries. By fitting the P–V curves in three different stages, the bulk moduli were estimated to be approximately 101 (2), 68 (2) and 172 (3) GPa. Such large differences in the bulk moduli confirm two isostructural phase changes in the three stages. An irreversible amorphization process was found to start at approximately 20 (1) GPa, and the sample gradually becomes fully amorphous during compression at 30 (1) GPa.
- Open Access
- 1 February 2022
- Published by International Union of Crystallography (IUCr) in IUCrJ
- Vol. 9 (2) , 253-260
Negative linear compressibility in Se at ultra-high pressure above 120 GPa
A series of in situ synchrotron X-ray diffraction (XRD) measurements were carried out, combined with first-principles calculations, to study structural phase transitions of selenium at high pressures and room temperature. Several phase transitions were observed, among which an isostructural phase transition was found at around 120 GPa for the first time. Evolved from the rhombohedral (space group R 3 m) structure (Se-V), the new phase (Se-V′) exhibited an interesting increase of lattice parameter a at pressures from 120 to 148 GPa, known as negative linear compressibility (NLC). The discovery of NLC behavior observed in this work is mainly attributed to the accuracy and fine steps controlled by the membrane system for in situ XRD data collected with an exposure time of 0.5 s. After 140 GPa, a body-centered cubic (b.c.c.) structure Se-VI (space group Im 3 m) was formed, which remains stable up to 210 GPa, the highest pressure achieved in this study. The bulk moduli of phases Se-V, Se-V′ and Se-VI were estimated to be 83 ± 2, 321 ± 2 and 266 ± 7 GPa, respectively, according to the P–V curve fit by the third-order Birch–Murnaghan equation of state. The Se-V′ phase shows a bulk modulus almost 4 times larger than that of the Se-V phase, which is mainly due to the effect of its NLC. NLC in a higher pressure range is always more significant in terms of fundamental mechanism and new materials discovery, yet it has barely been reported at pressures above 100 GPa. This will hopefully inspire future studies on potential NLC behaviors in other materials at ultra-high pressure.
- 1 February 2022
- Published by International Union of Crystallography (IUCr) in IUCrJ
- Vol. 9 (2) , 253-260
Open AccessNegative linear compressibility in Se at ultra-high pressure above 120 GPa
A series of in situ synchrotron X-ray diffraction (XRD) measurements were carried out, combined with first-principles calculations, to study structural phase transitions of selenium at high pressures and room temperature. Several phase transitions were observed, among which an isostructural phase transition was found at around 120 GPa for the first time. Evolved from the rhombohedral (space group R 3 m) structure (Se-V), the new phase (Se-V′) exhibited an interesting increase of lattice parameter a at pressures from 120 to 148 GPa, known as negative linear compressibility (NLC). The discovery of NLC behavior observed in this work is mainly attributed to the accuracy and fine steps controlled by the membrane system for in situ XRD data collected with an exposure time of 0.5 s. After 140 GPa, a body-centered cubic (b.c.c.) structure Se-VI (space group Im 3 m) was formed, which remains stable up to 210 GPa, the highest pressure achieved in this study. The bulk moduli of phases Se-V, Se-V′ and Se-VI were estimated to be 83 ± 2, 321 ± 2 and 266 ± 7 GPa, respectively, according to the P–V curve fit by the third-order Birch–Murnaghan equation of state. The Se-V′ phase shows a bulk modulus almost 4 times larger than that of the Se-V phase, which is mainly due to the effect of its NLC. NLC in a higher pressure range is always more significant in terms of fundamental mechanism and new materials discovery, yet it has barely been reported at pressures above 100 GPa. This will hopefully inspire future studies on potential NLC behaviors in other materials at ultra-high pressure.