Fedor S. Khorobrykh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fedor S. Khorobrykh has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Mikhail Yu. Popov
Prokhorov General Physics Institute of the Russian Academy of Sciences Moscow Russia
2 shared publications - Valentin Churkin
Technological Institute for Superhard and Novel Carbon Materials, 7a Tsentralnaya, 108840 Troitsk, Moscow, Russia
2 shared publications - Alexander Kvashnin
Skolkovo Institute of Science and Technology, Bolshoy Boulevard 30, bld. 1, 121025 Moscow, Russia
1 shared publication - Boris A. Kulnitskiy
National Research Centre «Kurchatov Institute», Centralnaya Str. 7a, Troitsk 108840, Russia
1 shared publication Churkin V.D.
1 shared publication- Danila A. Ovsyannikov
Технологический институт сверхтвердых и новых углеродных материалов
1 shared publication
Latest Publications
- Open Access
- 10 February 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (4) , 696
Surface Tamm States of 2–5 nm Nanodiamond via Raman Spectroscopy
We observed resonance effects in the Raman scattering of nanodiamonds with an average size of 2–5 nm excited at a wavelength of 1064 nm (1.16 eV). The resonant Raman spectrum of the 2–5 nm nanodiamonds consists of bands at wavelengths of 1325 and 1600 cm−1, a band at 1100–1250 cm−1, and a plateau in the range from 1420 to 1630 cm−1. When excited away from the resonance (at a wavelength of 405 nm, 3.1 eV), the Raman spectrum consists of only three bands at 1325, 1500, and 1600 cm−1. It is important to note that the additional lines (1500 and 1600 cm−1) belong to the sp3-hybridized carbon bonds. The phonon density of states for the nanodiamonds (~1 nm) was calculated using moment tensor potentials (MTP), a class of machine-learning interatomic potentials. The presence of these modes in agreement with the lattice dynamics indicates the existence of bonds with force constants higher than in single-crystal diamonds. The observed resonant phenomena of the Raman scattering and the increase in the bulk modulus are explained by the presence of Tamm states with an energy of electronic transitions of approximately 1 eV, previously observed on the surface of single-crystal diamonds.
- 10 February 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (4) , 696
Open AccessSurface Tamm States of 2–5 nm Nanodiamond via Raman Spectroscopy
We observed resonance effects in the Raman scattering of nanodiamonds with an average size of 2–5 nm excited at a wavelength of 1064 nm (1.16 eV). The resonant Raman spectrum of the 2–5 nm nanodiamonds consists of bands at wavelengths of 1325 and 1600 cm−1, a band at 1100–1250 cm−1, and a plateau in the range from 1420 to 1630 cm−1. When excited away from the resonance (at a wavelength of 405 nm, 3.1 eV), the Raman spectrum consists of only three bands at 1325, 1500, and 1600 cm−1. It is important to note that the additional lines (1500 and 1600 cm−1) belong to the sp3-hybridized carbon bonds. The phonon density of states for the nanodiamonds (~1 nm) was calculated using moment tensor potentials (MTP), a class of machine-learning interatomic potentials. The presence of these modes in agreement with the lattice dynamics indicates the existence of bonds with force constants higher than in single-crystal diamonds. The observed resonant phenomena of the Raman scattering and the increase in the bulk modulus are explained by the presence of Tamm states with an energy of electronic transitions of approximately 1 eV, previously observed on the surface of single-crystal diamonds.
- 1 January 2022
- Published by Ioffe Institute Russian Academy of Sciences in Physics of the Solid State
- Vol. 64 (2) , 217
Features of dependence of Raman spectra of cluster structures of three-dimensionally polymerized fullerite on pressure
We study the effect of high hydrostatic pressure on 3D polymerized fullerite C60. We do not observe further structural changes until 150 GPa after a formation of 3D C60 under hydrostatic pressure 28 GPa. It is experimentally shown that the obtained samples consist of different clusters formed by sp3 bonds with a different set of force constants, the values of which vary within 20% and exceed the diamond force constants by the factor of 1.3-1.5. The influence of the exposure of laser radiation on the process of 3D polymerization of C60 under pressure was found. Increasing of the exposure by the factor of 15 leads to a decrease in the bulk modulus of 3D C60 from 610 GPa to 504 GPa. Keywords: bulk modulus, ultrahard fullerite, high pressures, Raman spectroscopy.
- 1 January 2022
- Published by Ioffe Institute Russian Academy of Sciences in Physics of the Solid State
- Vol. 64 (2) , 217
Features of dependence of Raman spectra of cluster structures of three-dimensionally polymerized fullerite on pressure
We study the effect of high hydrostatic pressure on 3D polymerized fullerite C60. We do not observe further structural changes until 150 GPa after a formation of 3D C60 under hydrostatic pressure 28 GPa. It is experimentally shown that the obtained samples consist of different clusters formed by sp3 bonds with a different set of force constants, the values of which vary within 20% and exceed the diamond force constants by the factor of 1.3-1.5. The influence of the exposure of laser radiation on the process of 3D polymerization of C60 under pressure was found. Increasing of the exposure by the factor of 15 leads to a decrease in the bulk modulus of 3D C60 from 610 GPa to 504 GPa. Keywords: bulk modulus, ultrahard fullerite, high pressures, Raman spectroscopy.
- 1 January 2021
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 64 (12) , 71-75
EFFECT OF THE LASER RADIATION EXPOSURE ON MECHANICAL PROPERTIES OF 3D C60
The effect of hydrostatic pressure up to 80 GPa and laser radiation exposure on the bulk modulus of 3D C-60 three-dimensional polymerized states is investigated. The sample C-60 was loaded in a chamber with diamond anvils surrounded by NaCl, which was used as a pressure transmitting medium. In the process of loading under pressure, Raman spectra were recorded. The 3D polymerization process was observed using Raman spectra, it is characterized by broadening and merging of high-frequency C-60 modes. The 3D C-60 spectrum consists of two wide bands of about 1560 cm(-1) and 600 cm(-1). In our work, the process of 3D C-60 formation was recorded at a pressure of 28 GPa. To study the effect of laser radiation exposure on the structure of 3D C-60 obtained under pressure, two series of experiments were conducted in which C-60 samples were undergone to exposures varying by 15 times at a laser radiation wavelength of 532 nm in the pressure range from 20 to 80 GPa. The effect of exposure on the pressure at which 3D C-60 formation was observed was not detected. It has been experimentally established that the bulk modulus of 3D C-60 decreases from 571 GPa to 454 GPa with an increase in radiation exposure by 15 times. The module was calculated from the dependence of the Raman frequency 1560-1580 cm(-1) 3D C-60 on pressure. Study of the obtained 3D C-60 samples using transmission electron microscopy showed that there is no long-range order in the samples. At the same time, no significant structural features were revealed, which may be associated with the observed difference in the bulk modulus of samples obtained at different exposures at high pressure.
- 1 January 2021
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 64 (12) , 71-75
EFFECT OF THE LASER RADIATION EXPOSURE ON MECHANICAL PROPERTIES OF 3D C60
The effect of hydrostatic pressure up to 80 GPa and laser radiation exposure on the bulk modulus of 3D C-60 three-dimensional polymerized states is investigated. The sample C-60 was loaded in a chamber with diamond anvils surrounded by NaCl, which was used as a pressure transmitting medium. In the process of loading under pressure, Raman spectra were recorded. The 3D polymerization process was observed using Raman spectra, it is characterized by broadening and merging of high-frequency C-60 modes. The 3D C-60 spectrum consists of two wide bands of about 1560 cm(-1) and 600 cm(-1). In our work, the process of 3D C-60 formation was recorded at a pressure of 28 GPa. To study the effect of laser radiation exposure on the structure of 3D C-60 obtained under pressure, two series of experiments were conducted in which C-60 samples were undergone to exposures varying by 15 times at a laser radiation wavelength of 532 nm in the pressure range from 20 to 80 GPa. The effect of exposure on the pressure at which 3D C-60 formation was observed was not detected. It has been experimentally established that the bulk modulus of 3D C-60 decreases from 571 GPa to 454 GPa with an increase in radiation exposure by 15 times. The module was calculated from the dependence of the Raman frequency 1560-1580 cm(-1) 3D C-60 on pressure. Study of the obtained 3D C-60 samples using transmission electron microscopy showed that there is no long-range order in the samples. At the same time, no significant structural features were revealed, which may be associated with the observed difference in the bulk modulus of samples obtained at different exposures at high pressure.