Chao Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chao Gao has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Hao Yao
School of Civil Engineering, Central South University, Changsha 410075, China
1 shared publication - Jing Liu
China Academy of Railway Sciences Railway Engineering Research Institute, Beijing 100081, China
1 shared publication - Kai Zhang
China Railway No. 10 Engineering Group Co., Ltd., Jinan 250101, China
1 shared publication - Qiang Yuan
Central South University
1 shared publication - Shenghao Zuo
School of Civil Engineering, Central South University, Changsha 410075, China
1 shared publication - Tingjie Huang
Xiamen Univ, Sch Architecture & Civil Engn, Fujian Key Lab Digital Simulat Coastal Civil Engn, Xiamen 361005, Peoples R China
1 shared publication
Latest Publications
- Open Access
Factors Influencing the Properties of Extrusion-Based 3D-Printed Alkali-Activated Fly Ash-Slag Mortar
The mix proportioning of extrusion-based 3D-printed cementitious material should balance printability and hardened properties. This paper investigated the effects of three key mix proportion parameters of 3D-printed alkali-activated fly ash/slag (3D-AAFS) mortar, i.e., the sand to binder (s/b) ratio, fly ash/ground granulated blast-furnace slag (FA/GGBS) ratio, and silicate modulus (Ms) of the activator, on extrudability, buildability, interlayer strength, and drying shrinkage. The results showed that the loss of extrudability and the development of buildability were accelerated by increasing the s/b ratio, decreasing the FA/GGBS ratio, or using a lower Ms activator. A rise in the s/b ratio improved the interlayer strength and reduces the drying shrinkage. Although increasing the FA/GGBS mass ratio from 1 to 3 led to a reduction of 35% in the interlayer bond strength, it decreased the shrinkage strain by half. A larger silicate modulus was beneficial to the interlayer bond strength, but it made shrinkage more serious. Moreover, a simple centroid design method was developed for optimizing the mix proportion of 3D-AAFS mortar to simultaneously meet the requirements of printability and hardened properties.
Open AccessFactors Influencing the Properties of Extrusion-Based 3D-Printed Alkali-Activated Fly Ash-Slag Mortar
The mix proportioning of extrusion-based 3D-printed cementitious material should balance printability and hardened properties. This paper investigated the effects of three key mix proportion parameters of 3D-printed alkali-activated fly ash/slag (3D-AAFS) mortar, i.e., the sand to binder (s/b) ratio, fly ash/ground granulated blast-furnace slag (FA/GGBS) ratio, and silicate modulus (Ms) of the activator, on extrudability, buildability, interlayer strength, and drying shrinkage. The results showed that the loss of extrudability and the development of buildability were accelerated by increasing the s/b ratio, decreasing the FA/GGBS ratio, or using a lower Ms activator. A rise in the s/b ratio improved the interlayer strength and reduces the drying shrinkage. Although increasing the FA/GGBS mass ratio from 1 to 3 led to a reduction of 35% in the interlayer bond strength, it decreased the shrinkage strain by half. A larger silicate modulus was beneficial to the interlayer bond strength, but it made shrinkage more serious. Moreover, a simple centroid design method was developed for optimizing the mix proportion of 3D-AAFS mortar to simultaneously meet the requirements of printability and hardened properties.