Ali Merwan Shakor
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ali Merwan Shakor has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Saffet Ayasun
Department of Electrical and Electronics Engineering, Gazi University, Ankara, Turkey
2 shared publications - Najimaldin M. Abbas
University of Kirkuk
1 shared publication - Suud Ademnur Hasen
Department of Electrical and Computer Engineering Adigrat University Adigrat Ethiopia
1 shared publication
Latest Publications
- Open Access
- 9 May 2026
- Published by Elsevier in Ain Shams Engineering Journal
- Vol. 17 (7)
Enhancement in robust stability delay margins of microgrids with superconducting magnetic energy storage system
- 9 May 2026
- Published by Elsevier in Ain Shams Engineering Journal
- Vol. 17 (7)
Open AccessEnhancement in robust stability delay margins of microgrids with superconducting magnetic energy storage system
- Open Access
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 3505433
Robust Stability Regions for Time‐Delayed Microgrid With Superconducting Magnetic Energy Storage System Using Kharitonov’s Theorem
Growing use of intermittent and low‐inertia renewable energy sources (RES) makes it very hard to control the frequency in current power systems. Additionally, there are unavoidable time delays when utilizing communication networks for coordination and control, and parametric uncertainties further exacerbate the stability concern. This work presents a detailed evaluation of the robust delay‐dependent stability (DDS) of a microgrid (MG) equipped with a superconducting magnetic energy storage (SMES) component. To determine the robust stability regions (RSRs) in the proportional–integral (PI) controller parameter space, a new frequency‐domain method combining Kharitonov’s theorem (KT) alongside stability boundary locus (SBL) procedure is proposed. The consequences of communication time delays (CTDs) and percentages of parametric uncertainty on the RSRs are also examined. The simulation results show that the RSRs become smaller as the time delay and parametric uncertainty increase. This reduction suggests that the robustness of the MG–SMES system deteriorates under these conditions. Nevertheless, the inclusion of SMES improves the overall stability and frequency response of the system. Finally, the theoretical outcomes are corroborated via the quasi‐polynomial mapping‐based root‐finder (QPmR) method and time‐domain simulations. The close agreement among the results confirms the accuracy and effectiveness of the proposed method.
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 3505433
Open AccessRobust Stability Regions for Time‐Delayed Microgrid With Superconducting Magnetic Energy Storage System Using Kharitonov’s Theorem
Growing use of intermittent and low‐inertia renewable energy sources (RES) makes it very hard to control the frequency in current power systems. Additionally, there are unavoidable time delays when utilizing communication networks for coordination and control, and parametric uncertainties further exacerbate the stability concern. This work presents a detailed evaluation of the robust delay‐dependent stability (DDS) of a microgrid (MG) equipped with a superconducting magnetic energy storage (SMES) component. To determine the robust stability regions (RSRs) in the proportional–integral (PI) controller parameter space, a new frequency‐domain method combining Kharitonov’s theorem (KT) alongside stability boundary locus (SBL) procedure is proposed. The consequences of communication time delays (CTDs) and percentages of parametric uncertainty on the RSRs are also examined. The simulation results show that the RSRs become smaller as the time delay and parametric uncertainty increase. This reduction suggests that the robustness of the MG–SMES system deteriorates under these conditions. Nevertheless, the inclusion of SMES improves the overall stability and frequency response of the system. Finally, the theoretical outcomes are corroborated via the quasi‐polynomial mapping‐based root‐finder (QPmR) method and time‐domain simulations. The close agreement among the results confirms the accuracy and effectiveness of the proposed method.
- Open Access
- 25 February 2022
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 1 (2(115)) , 85-95
Experimental evaluation for fluxes, currents and speed estimation of induction motor
Induction motor drive control and estimation is a wide subject. The market for variable speed drives has grown dramatically in the last few years. Manufacturers have recognized the importance of not only managing the speed or torque range, but also reducing power consumption. This necessitates the development of new control algorithms and schemes to include these solutions. Indeed, the speed estimate must be employed in one or more regions of the control scheme, depending on the control objective. This concept, as well as the most common speed estimation methodologies, is investigated. Currently, many tools can be used for the evaluation of the rotor speed without a speed sensor. By modern signal processing methods, it is possible to implement an estimation scheme with the possibility of monitoring currents and voltages. Therefore, in this paper, the concept of currents, speed and fluxes estimation based on the extended Kalman filter is proposed. By monitoring the ratio of the theoretical residual to the actual residual, the measured noise covariance matrix is recursively corrected online to make it gradually approach the real noise level. So that the filter performs the optimal estimation, improves the accuracy of the speed estimation. The effect of the load change on the currents, fluxes and speed estimation was also studied. Simulation and experimental results show that the proposed improved adaptive extended Kalman estimator has a strong ability to suppress random measurement noise. The experimental and simulation results prove the accuracy of the proposed scheme towards the state estimation of an induction motor at different load levels. It can accurately estimate the speed of the motor and has a good anti-error ability to meet the actual needs of the project.
- 25 February 2022
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 1 (2(115)) , 85-95
Open AccessExperimental evaluation for fluxes, currents and speed estimation of induction motor
Induction motor drive control and estimation is a wide subject. The market for variable speed drives has grown dramatically in the last few years. Manufacturers have recognized the importance of not only managing the speed or torque range, but also reducing power consumption. This necessitates the development of new control algorithms and schemes to include these solutions. Indeed, the speed estimate must be employed in one or more regions of the control scheme, depending on the control objective. This concept, as well as the most common speed estimation methodologies, is investigated. Currently, many tools can be used for the evaluation of the rotor speed without a speed sensor. By modern signal processing methods, it is possible to implement an estimation scheme with the possibility of monitoring currents and voltages. Therefore, in this paper, the concept of currents, speed and fluxes estimation based on the extended Kalman filter is proposed. By monitoring the ratio of the theoretical residual to the actual residual, the measured noise covariance matrix is recursively corrected online to make it gradually approach the real noise level. So that the filter performs the optimal estimation, improves the accuracy of the speed estimation. The effect of the load change on the currents, fluxes and speed estimation was also studied. Simulation and experimental results show that the proposed improved adaptive extended Kalman estimator has a strong ability to suppress random measurement noise. The experimental and simulation results prove the accuracy of the proposed scheme towards the state estimation of an induction motor at different load levels. It can accurately estimate the speed of the motor and has a good anti-error ability to meet the actual needs of the project.