Sophie Baron
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sophie Baron has a total of 146 co-authors. Here are the top co-authors by number of shared publications:
- Eduardo Mendes
Experimental Physics Department, CERN, Geneva, Switzerland
3 shared publications - Christophe Sigaud
CERN, Esplanade des Particules 1, 1211 Geneva 23, Switzerland
2 shared publications - Edoardo Orzes
CERN
2 shared publications - Francesco Martina
INFN Sezione di Lecce
2 shared publications - Francois Vasey
Experimental Physics Department, CERN, Geneva, Switzerland
2 shared publications - Jan Troska
CERN
2 shared publications
Latest Publications
- Open Access
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 73 (11) , 4190-4199
Sub-Picosecond Digital Phase Measurements and Compensation on Data Streams With Generalized Digital Dual Mixer Time Difference
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 73 (11) , 4190-4199
Open AccessSub-Picosecond Digital Phase Measurements and Compensation on Data Streams With Generalized Digital Dual Mixer Time Difference
- Open Access
- 1 February 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (02) , C02024
First results of an evaluation of 100Gb/s Ethernet as a future HEP readout link
This work presents first results from a feasibility study to qualify commercial 100 Gb/s Ethernet as a readout link for future high-energy physics detectors. The motivation for this work is to examine the possibility of reading out future detector front-ends directly via commercial, high bandwidth, cost-optimized data centers, without the need of the intermediate custom-link/hardware layer used for this purpose thus far. In an attempt to determine how well 100 Gb/s Ethernet is adapted to the readout of such systems, this paper examines the protocol on aspects such as unidirectional operation and radiation hardness. Initial work towards a complete demonstrator system is also presented.
- 1 February 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (02) , C02024
Open AccessFirst results of an evaluation of 100Gb/s Ethernet as a future HEP readout link
This work presents first results from a feasibility study to qualify commercial 100 Gb/s Ethernet as a readout link for future high-energy physics detectors. The motivation for this work is to examine the possibility of reading out future detector front-ends directly via commercial, high bandwidth, cost-optimized data centers, without the need of the intermediate custom-link/hardware layer used for this purpose thus far. In an attempt to determine how well 100 Gb/s Ethernet is adapted to the readout of such systems, this paper examines the protocol on aspects such as unidirectional operation and radiation hardness. Initial work towards a complete demonstrator system is also presented.
- Open Access
- 1 January 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (01) , C01003
An FPGA-agnostic system for achieving picosecond-level phase determinism in timing distribution links for High Energy Physics experiments
Picosecond-level phase determinism in timing distribution systems is a requirement for future detectors in High Energy Physics. FPGA transceivers traditionally used to propagate timing signals generally do not meet this stringent requirement, suffering from phase jumps at startup and from drifts due to temperature variations. While ad hoc solutions have been developed using FPGA features to measure and correct for phase shifts, they remain FPGA specific and therefore cannot be generalized to all types of timing links. This paper presents a study using discrete components to monitor and correct for phase drift, allowing for an implementation of a generic deterministic link.
- 1 January 2025
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 20 (01) , C01003
Open AccessAn FPGA-agnostic system for achieving picosecond-level phase determinism in timing distribution links for High Energy Physics experiments
Picosecond-level phase determinism in timing distribution systems is a requirement for future detectors in High Energy Physics. FPGA transceivers traditionally used to propagate timing signals generally do not meet this stringent requirement, suffering from phase jumps at startup and from drifts due to temperature variations. While ad hoc solutions have been developed using FPGA features to measure and correct for phase shifts, they remain FPGA specific and therefore cannot be generalized to all types of timing links. This paper presents a study using discrete components to monitor and correct for phase drift, allowing for an implementation of a generic deterministic link.
- Open Access
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (1) , 24-37
lpGBT: Low-Power Radiation-Hard Multipurpose High-Speed Transceiver ASIC for High-Energy Physics Experiments
Commissioning of detector systems for the High-Luminosity Large Hadron Collider (HL-LHC) is scheduled to take place between 2026 and 2028 at CERN. Application Specific Integrated Circuits (ASICs) for those systems have been in intense development over the past ten years. Some of those ASICs, as is the case of the Low Power GigaBit Transceiver (lpGBT) described in this work, have now been produced in industrial quantities and have been fully qualified for operation in the HL-LHC environments that require, where the innermost detectors are concerned, radiation hardness in excess of 1 MGy. The lpGBT is a multi-functional device, enabling data transmission between the off-detector and the on-detector systems. Data can be transmitted from the detector at 5.12 Gbit s −1 and 10.24 Gbit s −1 and to the detector at 2.56 Gbit s −1 . It implements data rate-configurable electrical links to communicate with the front-end ASICs and low-speed serial and parallel buses for experiment control. A set of analog functions for monitoring and control of the physics detectors is also included. This paper describes the functionality and the architecture of the lpGBT ASIC and reports on its radiation hardness characterization.
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (1) , 24-37
Open AccesslpGBT: Low-Power Radiation-Hard Multipurpose High-Speed Transceiver ASIC for High-Energy Physics Experiments
Commissioning of detector systems for the High-Luminosity Large Hadron Collider (HL-LHC) is scheduled to take place between 2026 and 2028 at CERN. Application Specific Integrated Circuits (ASICs) for those systems have been in intense development over the past ten years. Some of those ASICs, as is the case of the Low Power GigaBit Transceiver (lpGBT) described in this work, have now been produced in industrial quantities and have been fully qualified for operation in the HL-LHC environments that require, where the innermost detectors are concerned, radiation hardness in excess of 1 MGy. The lpGBT is a multi-functional device, enabling data transmission between the off-detector and the on-detector systems. Data can be transmitted from the detector at 5.12 Gbit s −1 and 10.24 Gbit s −1 and to the detector at 2.56 Gbit s −1 . It implements data rate-configurable electrical links to communicate with the front-end ASICs and low-speed serial and parallel buses for experiment control. A set of analog functions for monitoring and control of the physics detectors is also included. This paper describes the functionality and the architecture of the lpGBT ASIC and reports on its radiation hardness characterization.
- Open Access
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (2) , 156-163
TCLink: A Fully Integrated Open Core for Timing Compensation in FPGA-Based High-Speed Links
The high luminosity expected in the second phase of the upgrades of the Large Hadron Collider (LHC phase-2 upgrades) will pose unprecedented challenges to its four experiments in terms of collisions density – also known as pileup – per beam crossing. Disentangling the vertices of 200 simultaneous collisions every 25 ns requires high granularity in the detectors, as well as extremely precise and stable timing. While short-term timing stability is usually a concern addressed in timing distribution systems, long-term variations due to changing environmental conditions can accumulate through distribution chains and can dominate the overall timing stability of the systems they serve. Timing distribution systems in LHC experiments typically use high-speed links and clock recovery. This paper presents a logic core that can be used to mitigate long-term temperature variations in high-speed links. The Timing Compensated Link (TCLink) is an open-source firmware core fully integrated in Xilinx Ultrascale Field Programmable Gate Arrays (FPGAs). It demonstrates picosecond-level phase precision over timing distribution systems, improving the overall timing stability in physics experiments.
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (2) , 156-163
Open AccessTCLink: A Fully Integrated Open Core for Timing Compensation in FPGA-Based High-Speed Links
The high luminosity expected in the second phase of the upgrades of the Large Hadron Collider (LHC phase-2 upgrades) will pose unprecedented challenges to its four experiments in terms of collisions density – also known as pileup – per beam crossing. Disentangling the vertices of 200 simultaneous collisions every 25 ns requires high granularity in the detectors, as well as extremely precise and stable timing. While short-term timing stability is usually a concern addressed in timing distribution systems, long-term variations due to changing environmental conditions can accumulate through distribution chains and can dominate the overall timing stability of the systems they serve. Timing distribution systems in LHC experiments typically use high-speed links and clock recovery. This paper presents a logic core that can be used to mitigate long-term temperature variations in high-speed links. The Timing Compensated Link (TCLink) is an open-source firmware core fully integrated in Xilinx Ultrascale Field Programmable Gate Arrays (FPGAs). It demonstrates picosecond-level phase precision over timing distribution systems, improving the overall timing stability in physics experiments.
- Open Access
- 16 March 2022
- Published by The Royal Society in Royal Society Open Science
- Vol. 9 (3) , 211519
The HEV Ventilator: at the interface between particle physics and biomedical engineering
A high-quality, low-cost ventilator, dubbed HEV, has been developed by the particle physics community working together with biomedical engineers and physicians around the world. The HEV design is suitable for use both in and out of hospital intensive care units, provides a variety of modes and is capable of supporting spontaneous breathing and supplying oxygen-enriched air. An external air supply can be combined with the unit for use in situations where compressed air is not readily available. HEV supports remote training and post market surveillance via a Web interface and data logging to complement standard touch screen operation, making it suitable for a wide range of geographical deployment. The HEV design places emphasis on the ventilation performance, especially the quality and accuracy of the pressure curves, reactivity of the trigger, measurement of delivered volume and control of oxygen mixing, delivering a global performance which will be applicable to ventilator needs beyond the COVID-19 pandemic. This article describes the conceptual design and presents the prototype units together with a performance evaluation.
- 16 March 2022
- Published by The Royal Society in Royal Society Open Science
- Vol. 9 (3) , 211519
Open AccessThe HEV Ventilator: at the interface between particle physics and biomedical engineering
A high-quality, low-cost ventilator, dubbed HEV, has been developed by the particle physics community working together with biomedical engineers and physicians around the world. The HEV design is suitable for use both in and out of hospital intensive care units, provides a variety of modes and is capable of supporting spontaneous breathing and supplying oxygen-enriched air. An external air supply can be combined with the unit for use in situations where compressed air is not readily available. HEV supports remote training and post market surveillance via a Web interface and data logging to complement standard touch screen operation, making it suitable for a wide range of geographical deployment. The HEV design places emphasis on the ventilation performance, especially the quality and accuracy of the pressure curves, reactivity of the trigger, measurement of delivered volume and control of oxygen mixing, delivering a global performance which will be applicable to ventilator needs beyond the COVID-19 pandemic. This article describes the conceptual design and presents the prototype units together with a performance evaluation.
- Open Access
- 1 February 2019
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 14 (02) , P02001
Effect of repetitive reset, temperature variation and frequency offset on the performance of PLL for the LHC experiments
The Large Hadron Collider (LHC) uses timing, trigger and control (TTC) system backbone to distribute the bunch clock and other critical timing signals to all the participating experiments. The clock signal is directly derived from the radio frequency (RF) driving the beams in the accelerator. The whole range of electronic systems from an ADC to high-speed transmission link works in synchronous to the clock signal and are sensitive to jitter. Throughout the clock distribution chain, high-frequency components increase the jitter. Multiple Phase-Locked Loops (PLLs) are used in the entire chain to maintain the jitter noise at a minimum level. Si5344 PLL by Silicon Labs is chosen as one of the candidate PLLs for jitter cleaning of the embedded clock in LHC gigabit serial link transmission. The article aims to highlight the qualification tests conducted to characterize the PLL component. Laboratory test setup is built to emulate the thermal variation of the LHC as in run-time condition. The present research study investigates the influence of temperature variation on PLL jitter-cleaning performance when operated in different configuration modes needed in TTC distribution chain. Stability of the PLL circuitry to lock correctly with repetitive reset assertion, power on/off cycle and marginal frequency swing about the LHC bunch clock mean frequency value is also studied.
- 1 February 2019
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 14 (02) , P02001
Open AccessEffect of repetitive reset, temperature variation and frequency offset on the performance of PLL for the LHC experiments
The Large Hadron Collider (LHC) uses timing, trigger and control (TTC) system backbone to distribute the bunch clock and other critical timing signals to all the participating experiments. The clock signal is directly derived from the radio frequency (RF) driving the beams in the accelerator. The whole range of electronic systems from an ADC to high-speed transmission link works in synchronous to the clock signal and are sensitive to jitter. Throughout the clock distribution chain, high-frequency components increase the jitter. Multiple Phase-Locked Loops (PLLs) are used in the entire chain to maintain the jitter noise at a minimum level. Si5344 PLL by Silicon Labs is chosen as one of the candidate PLLs for jitter cleaning of the embedded clock in LHC gigabit serial link transmission. The article aims to highlight the qualification tests conducted to characterize the PLL component. Laboratory test setup is built to emulate the thermal variation of the LHC as in run-time condition. The present research study investigates the influence of temperature variation on PLL jitter-cleaning performance when operated in different configuration modes needed in TTC distribution chain. Stability of the PLL circuitry to lock correctly with repetitive reset assertion, power on/off cycle and marginal frequency swing about the LHC bunch clock mean frequency value is also studied.
- Open Access
- 1 January 2014
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 9 (01) , C01015
Metrics and methods for TTC-PON system characterization
- 1 January 2014
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 9 (01) , C01015
Open AccessMetrics and methods for TTC-PON system characterization