Yuchen Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yuchen Wang has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Chupeng Yi
Xidian University
5 shared publications - Xiaohua Ma
Xidian University
4 shared publications - Yang Lu
Xidian University
3 shared publications - Yue Hao
Guangzhou Wide Bandgap Semiconductor Innovation Center, Guangzhou Institute of Technology, Xidian University 1 , Guangzhou 510555
3 shared publications - Ziyue Zhao
State Key Discipline Laboratory of Wide Bandgap Semiconductor Technology, School of Microelectronics, Xidian University, Xian, China
3 shared publications - Heng-Shuang Zhang
China Academy of Space Technology (Xian), Xian, China
2 shared publications
Latest Publications
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (3) , 331-334
High Linear and Temperature Insensitive GaAs Power Amplifier Operating at 3.3–3.6 GHz Using a Multi-Feedback Branch Bias Circuit
This letter describes a design of a 3.3–3.6-GHz GaAs heterojunction bipolar transistor (HBT) power amplifier (PA) with high linearity and temperature insensitivity for the fifth-generation (5G) of new radios (NRs). By involving a multi-feedback branches bias circuit, the voltage at the feedback node of the bias circuit can achieve dynamic self-tuning to stabilize the base voltage as the amplifier’s input power grows and stabilize the bias current as the temperature increases as well. A three-stage common source structure PA in the form of a monolithic microwave integrated circuit (MMIC) is designed using a multi-feedback branch bias circuit with a size of 1.5 $\times$ 1.2 mm. Measured with continuous wave (CW) signals, the output 1-dB compression point at 3.3–3.6 GHz is 34 dBm. The linearity of the PA is also evaluated using a 5G-NR 100-MHz 64-quadratic-amplitude modulated (QAM)-orthogonal frequency division multiplexing (OFDM) signal with a 7-dB peak-to-average-power ratio (PAPR). The proposed PA achieves an adjacent channel power ratio (ACPR) less than $-$ 49.5 dBc at an average power of 28 dBm with a power-added efficiency (PAE) of 20% without the use of digital pre-distortion (DPD). In the temperature range of $-$ 40 $^{\circ}$ C to 120 $^{\circ}$ C, the variance of bias current, small signal gain, PAE, output power at 1-dB compression point (OP1dB), and ACPR is relatively minor. This design is ideally suited for 5G communication systems due to its high linearity and temperature insensitivity.
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (3) , 331-334
High Linear and Temperature Insensitive GaAs Power Amplifier Operating at 3.3–3.6 GHz Using a Multi-Feedback Branch Bias Circuit
This letter describes a design of a 3.3–3.6-GHz GaAs heterojunction bipolar transistor (HBT) power amplifier (PA) with high linearity and temperature insensitivity for the fifth-generation (5G) of new radios (NRs). By involving a multi-feedback branches bias circuit, the voltage at the feedback node of the bias circuit can achieve dynamic self-tuning to stabilize the base voltage as the amplifier’s input power grows and stabilize the bias current as the temperature increases as well. A three-stage common source structure PA in the form of a monolithic microwave integrated circuit (MMIC) is designed using a multi-feedback branch bias circuit with a size of 1.5 $\times$ 1.2 mm. Measured with continuous wave (CW) signals, the output 1-dB compression point at 3.3–3.6 GHz is 34 dBm. The linearity of the PA is also evaluated using a 5G-NR 100-MHz 64-quadratic-amplitude modulated (QAM)-orthogonal frequency division multiplexing (OFDM) signal with a 7-dB peak-to-average-power ratio (PAPR). The proposed PA achieves an adjacent channel power ratio (ACPR) less than $-$ 49.5 dBc at an average power of 28 dBm with a power-added efficiency (PAE) of 20% without the use of digital pre-distortion (DPD). In the temperature range of $-$ 40 $^{\circ}$ C to 120 $^{\circ}$ C, the variance of bias current, small signal gain, PAE, output power at 1-dB compression point (OP1dB), and ACPR is relatively minor. This design is ideally suited for 5G communication systems due to its high linearity and temperature insensitivity.
- 4 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (12) , 6624-6632
Influence of Fin-Like Configuration on Small-Signal Performance of AlGaN/GaN HEMTs
In this work, a new small-signal model (SSM), which is called the distributes intrinsic subdevice model (DISDM), is established for AlGaN/gallium nitride (GaN) Fin-like high-electron mobility transistors (HEMTs) according to the device structure feature. Perfect agreements between the measured and simulated scattering parameters (S-parameters) illustrated the validity of the DISDM and the accuracy of parameters extracted from the new model. Then, the characteristics of Fin-like HEMTs are analyzed using the DISDM theoretically. Different from the traditional model, the DISDM can accurately show the characteristics of the Fin-like HEMTs, especially the “double-peak” of the intrinsic transconductance. Compared with the planar HEMTs, the Fin-like HEMTs exhibit a higher linearity in direct current and small-signal parameters. For Fin-like HEMTs with different recess depths and duty ratios, the variation of the small-signal parameters and the linearity of devices were characterized to evaluate the performance of devices and optimize the process in the end.
- 4 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (12) , 6624-6632
Influence of Fin-Like Configuration on Small-Signal Performance of AlGaN/GaN HEMTs
In this work, a new small-signal model (SSM), which is called the distributes intrinsic subdevice model (DISDM), is established for AlGaN/gallium nitride (GaN) Fin-like high-electron mobility transistors (HEMTs) according to the device structure feature. Perfect agreements between the measured and simulated scattering parameters (S-parameters) illustrated the validity of the DISDM and the accuracy of parameters extracted from the new model. Then, the characteristics of Fin-like HEMTs are analyzed using the DISDM theoretically. Different from the traditional model, the DISDM can accurately show the characteristics of the Fin-like HEMTs, especially the “double-peak” of the intrinsic transconductance. Compared with the planar HEMTs, the Fin-like HEMTs exhibit a higher linearity in direct current and small-signal parameters. For Fin-like HEMTs with different recess depths and duty ratios, the variation of the small-signal parameters and the linearity of devices were characterized to evaluate the performance of devices and optimize the process in the end.
- 5 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-9
A Broadband Amplifier With Flat Bandwidth for Modulator and Measurement Driver Circuits
This article presents a broadband amplifier for high-speed modulators and measurement driver circuits using distributed amplifiers (DAs) configuration. The flat low-frequency performance of the conventional DAs is limited by termination impedance. This article shows that on- chip low-frequency extension can be achieved by optimizing the capacitively coupled circuit and impedance termination. Although capacitively coupled circuit has been introduced in previous studies to extend the high-frequency gain, sufficient analysis has not been studied. Furthermore, a novel broadband equalizer termination applying for distributed configuration is introduced, which can be employed to balance the rising gain. This DA features the lowest cutoff frequency among broadband amplifiers using the on- chip circuit. The amplifier provides a comparable low-frequency performance of megahertz (MHz) with greater than 15-dB gain and benchmarks the first demonstration of a flat MHz performance monolithic microwave integrated circuit (MMIC) using on- chip passive components. The proposed amplifier achieves a 17-dBm output 1-dB compression point (OP1dB) covering eight-octave bandwidth verified using a 0.15- $\mu \text{m}$ GaAs pseudomorphic high-electron-mobility transistor (pHEMT) technology. The new design architecture combined with the broadband equalizer characteristics and gate series network can provide performance benefits for optic modulators, instrumentations, and advanced broadband transmitters.
- 5 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-9
A Broadband Amplifier With Flat Bandwidth for Modulator and Measurement Driver Circuits
This article presents a broadband amplifier for high-speed modulators and measurement driver circuits using distributed amplifiers (DAs) configuration. The flat low-frequency performance of the conventional DAs is limited by termination impedance. This article shows that on- chip low-frequency extension can be achieved by optimizing the capacitively coupled circuit and impedance termination. Although capacitively coupled circuit has been introduced in previous studies to extend the high-frequency gain, sufficient analysis has not been studied. Furthermore, a novel broadband equalizer termination applying for distributed configuration is introduced, which can be employed to balance the rising gain. This DA features the lowest cutoff frequency among broadband amplifiers using the on- chip circuit. The amplifier provides a comparable low-frequency performance of megahertz (MHz) with greater than 15-dB gain and benchmarks the first demonstration of a flat MHz performance monolithic microwave integrated circuit (MMIC) using on- chip passive components. The proposed amplifier achieves a 17-dBm output 1-dB compression point (OP1dB) covering eight-octave bandwidth verified using a 0.15- $\mu \text{m}$ GaAs pseudomorphic high-electron-mobility transistor (pHEMT) technology. The new design architecture combined with the broadband equalizer characteristics and gate series network can provide performance benefits for optic modulators, instrumentations, and advanced broadband transmitters.
- 17 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (7) , 871-874
A 10-W High-Power Amplifier Using Input Nonlinearity for K-Band Satcom Applications
This letter presents a ${K}$ -band 0.1- $\mu \text{m}$ GaN on Si 10-W high-power amplifier (HPA) for the downlink of the satellite communication system. The proposed HPA uses the driver-stage transistor to generate a half-sinusoidal waveform that is delivered to the power-stage transistor. The half-sinusoidal waveform combines the input nonlinearity of the power-stage transistor to simultaneously improve the efficiency and expand the design space of the input harmonic impedance. A simple and compact interstage matching network (ISMN) design is used to match the harmonic impedance of both driver and power-stage transistors to create the corresponding waveforms. The proposed HPA has a small size of 3.5 mm $\times3.2$ mm and operates in the frequency range of 17–20.5 GHz achieving a 22-dB gain, an average output power ( ${P}_{\mathbf {out}}$ ) of 42 dBm, and 41% power-added efficiency (PAE) in the pulsed measurement. Moreover, the proposed HPA maintains a PAE of more than 33% and output power of 40.4 dBm in continuous wave (CW) measurement.
- 17 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (7) , 871-874
A 10-W High-Power Amplifier Using Input Nonlinearity for K-Band Satcom Applications
This letter presents a ${K}$ -band 0.1- $\mu \text{m}$ GaN on Si 10-W high-power amplifier (HPA) for the downlink of the satellite communication system. The proposed HPA uses the driver-stage transistor to generate a half-sinusoidal waveform that is delivered to the power-stage transistor. The half-sinusoidal waveform combines the input nonlinearity of the power-stage transistor to simultaneously improve the efficiency and expand the design space of the input harmonic impedance. A simple and compact interstage matching network (ISMN) design is used to match the harmonic impedance of both driver and power-stage transistors to create the corresponding waveforms. The proposed HPA has a small size of 3.5 mm $\times3.2$ mm and operates in the frequency range of 17–20.5 GHz achieving a 22-dB gain, an average output power ( ${P}_{\mathbf {out}}$ ) of 42 dBm, and 41% power-added efficiency (PAE) in the pulsed measurement. Moreover, the proposed HPA maintains a PAE of more than 33% and output power of 40.4 dBm in continuous wave (CW) measurement.