DHDavid Holst

David Holst

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


David Holst has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Repetitive model predictive control for load alleviation on a research wind turbine using trailing edge flaps

    by Sirko Bartholomay, Sascha Krumbein, Victoria Deichmann, Maik Gentsch, Sebastian Perez‐Becker, Rodrigo Soto‐Valle, David Holst, Christian N. Nayeri, Christian O. Paschereit, Kilian Oberleithner

    Summary: This paper presents the results of an advanced control strategy that employs active trailing edge flaps to reduce the fatigue loads of an experimental wind turbine. The strategy, called repetitive model predictive control, is a multiple‐input multiple‐output controller that aims at the alleviation of out‐of‐plane blade root bending moments. The strategy incorporates the control commands, output errors, and state deviation from the previous rotation. This way, the time lag in the strain sensor input due to the blade inertia is compensated. Additionally, a strategy to limit the computational costs is presented. The load alleviation performance is evaluated at different yaw cases and compared with different individual flap control strategies. The repetitive model predictive control is able to reduce the fatigue loads by up to 23% compared with the better performing individual flap control strategy. This improvement in load reduction is accompanied by an increase in flap travel of up to 7% compared with the individual flap control strategies.


  • Combined Numerical and Experimental Study on the Use of Gurney Flaps for the Performance Enhancement of NACA0021 Airfoil in Static and Dynamic Conditions

    by Francesco Balduzzi, David Holst, Pier Francesco Melani, Felix Wegner, Christian Navid Nayeri, Giovanni Ferrara, Christian Oliver Paschereit, Alessandro Bianchini

    The use of power augmentation devices in wind energy applications has been receiving increasing interest from both the scientific and the industrial community. In particular, Gurney Flaps (GFs) showed a great potential thanks to the passive functioning, the simple construction and the possibility to add them as a retrofit to existing rotors. The possibility of having a high quality set of airfoil data for a wide range of both angle of attack (AoA) and Reynolds number is pivotal in the design phase of newly developed machines. Such data are usually available in the technical literature for smooth airfoils, while there is a lack of generalized results in case of airfoils with GFs. Within this context, the authors have performed an extended investigation on the lift increase capabilities of GFs for the well-known NACA 0021 airfoil, which has been used in several wind energy applications up to now. The present paper shows the results of a combined experimental and numerical analysis considering different geometrical configurations of the flaps under both static and dynamic conditions. Experimental data were first obtained for the AoA range of 180 degrees at a low value of Reynolds number (i.e. Re = 180 k) to analyze the impact of three different geometrical configurations of the GF on the aerodynamic behavior for the full range of incidence angles. The geometrical configurations were defined by varying the length of the flap (i.e. 1.4% and 2.5% of the chord length) and its inclination angle with respect to the blade chord (i.e. 90 degrees and 45 degrees). The experimental investigation involved also dynamic sinusoidal pitching movements at multiple reduced frequencies to evaluate the stall hysteresis cycle. Subsequently, an unsteady CFD numerical model was first calibrated against wind tunnel data at low values of the Reynolds number. Then, the virtual model was exploited to extend the investigation to a wider range of Reynolds number for dynamic AoA rates of change typical for example of vertical-axis wind turbines, i.e. characterized by higher reduced frequencies with a non-sinusoidal motion law.