Nursaid Polater
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nursaid Polater has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Pietro Tricoli
Department of Electronic, Electrical and Systems Engineering, University of Birmingham, Edgbaston Campus, Birmingham B15 2TT, UK
3 shared publications - Tamer Kamel
School of Engineering, Computing and Mathematics, The University of Plymouth, Plymouth PL4 8AA, UK
2 shared publications Francesco Maggiulli
Department of Energy, Politecnico di Milano, Milan, Italy
1 shared publication- Giovanni Maria Foglia
Department of Energy, Politecnico di Milano, Milano, Italy
1 shared publication Peter Amor
1 shared publicationPietro Tricoli
1 shared publication
Latest Publications
- Open Access
- 30 January 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 23279-23289
A New Traction System With Asymmetrical Six-Phase Permanent Magnet Synchronous Motors for Hydrogen Trains
This paper proposes a new traction system with asymmetrical six-phase permanent magnet synchronous motors to replace traditional induction and permanent magnet machines for hydrogen trains. The main benefit of the proposed traction system is the elimination of the boost converters of the fuel cells (FCs) and the battery. The proposed traction system has two three-phase inverters feeding separately the six-phase machine and controlled to achieve optimal power sharing between the FC and the battery. The model of the system and its control has been implemented on a micro-controller and validated with a hardware-in-the-loop simulator. A comparison of the proposed topology with traditional motor drives has shown a mass reduction of 85% and a volume reduction of around 14% for basic components. Therefore, the proposed traction configuration and power-sharing strategy is a very interesting candidate for hydrogen trains.
- 30 January 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 23279-23289
Open AccessA New Traction System With Asymmetrical Six-Phase Permanent Magnet Synchronous Motors for Hydrogen Trains
This paper proposes a new traction system with asymmetrical six-phase permanent magnet synchronous motors to replace traditional induction and permanent magnet machines for hydrogen trains. The main benefit of the proposed traction system is the elimination of the boost converters of the fuel cells (FCs) and the battery. The proposed traction system has two three-phase inverters feeding separately the six-phase machine and controlled to achieve optimal power sharing between the FC and the battery. The model of the system and its control has been implemented on a micro-controller and validated with a hardware-in-the-loop simulator. A comparison of the proposed topology with traditional motor drives has shown a mass reduction of 85% and a volume reduction of around 14% for basic components. Therefore, the proposed traction configuration and power-sharing strategy is a very interesting candidate for hydrogen trains.
- Open Access
- 17 February 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 52, 559-576
Development of a smart hybrid drive system with advanced logistics for railway applications
- 17 February 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 52, 559-576
Open AccessDevelopment of a smart hybrid drive system with advanced logistics for railway applications
- Open Access
- 29 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
State of Charge-Based Power Sharing Algorithm for Hydrogen and Battery Cells Supplying Double-Three Phase Permanent Magnet Synchronous Motor
This paper presents a new power sharing algorithm for a hybrid power source of hydrogen fuel cells (HFC) and Li-ion battery cells (LiBC) based on state of charge (SOC) of the LiBC to supply a dual three-phase machine in light railways. HFCs are good energy sources to provide reliable power at a steady rate, while, LiBC have fast dynamics that can respond appropriately to the fast load transients. Double three phase permanent magnet synchronous machines (DTPMSM) have been nominated in this research since they provide high reliability in which the fault-tolerant operation can be implemented. Additionally, they provide lower power losses and harmonic distortion along with higher power density. Accordingly, this paper establishes a new SOC -based power sharing algorithm to employ the two power sources to supply DTPMSM. The average traction demand along with the SOC of the LiBC are used as two main inputs for the proposed approach. The system under study has been modelled and evaluated in the Typhoon HIL real time simulator. Comparative analysis is demonstrated at the end of the paper to validate the proposed algorithm.
- 29 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Open AccessState of Charge-Based Power Sharing Algorithm for Hydrogen and Battery Cells Supplying Double-Three Phase Permanent Magnet Synchronous Motor
This paper presents a new power sharing algorithm for a hybrid power source of hydrogen fuel cells (HFC) and Li-ion battery cells (LiBC) based on state of charge (SOC) of the LiBC to supply a dual three-phase machine in light railways. HFCs are good energy sources to provide reliable power at a steady rate, while, LiBC have fast dynamics that can respond appropriately to the fast load transients. Double three phase permanent magnet synchronous machines (DTPMSM) have been nominated in this research since they provide high reliability in which the fault-tolerant operation can be implemented. Additionally, they provide lower power losses and harmonic distortion along with higher power density. Accordingly, this paper establishes a new SOC -based power sharing algorithm to employ the two power sources to supply DTPMSM. The average traction demand along with the SOC of the LiBC are used as two main inputs for the proposed approach. The system under study has been modelled and evaluated in the Typhoon HIL real time simulator. Comparative analysis is demonstrated at the end of the paper to validate the proposed algorithm.
- Open Access
Technical Review of Traction Drive Systems for Light Railways
Due to environmental concerns, governments around the world are taking measures to decarbonise railway transport by replacing diesel traction systems with cleaner alternatives. While the electrification of railway systems is spreading rapidly, it is unlikely that all routes will be electrified as the volume of passengers will not justify the high infrastructure costs. Therefore, it is expected that, for several lines, a combination of hydrogen and electric traction will be used, with the latter partly provided by fixed infrastructure and partly by batteries. Railway traction drives will then need to change to accommodate these new types of power supply. A detailed review of the available traction motors and drives is provided with this review, given application to the new hybrid-electric systems. In particular, permanent magnet synchronous motors with multiphase windings are evaluated in comparison with traditional three-phase machines. Additionally, low and medium-voltage multisource power converters have been reviewed, taking into account the introduction of wide band-gap semiconductor devices.
Open AccessTechnical Review of Traction Drive Systems for Light Railways
Due to environmental concerns, governments around the world are taking measures to decarbonise railway transport by replacing diesel traction systems with cleaner alternatives. While the electrification of railway systems is spreading rapidly, it is unlikely that all routes will be electrified as the volume of passengers will not justify the high infrastructure costs. Therefore, it is expected that, for several lines, a combination of hydrogen and electric traction will be used, with the latter partly provided by fixed infrastructure and partly by batteries. Railway traction drives will then need to change to accommodate these new types of power supply. A detailed review of the available traction motors and drives is provided with this review, given application to the new hybrid-electric systems. In particular, permanent magnet synchronous motors with multiphase windings are evaluated in comparison with traditional three-phase machines. Additionally, low and medium-voltage multisource power converters have been reviewed, taking into account the introduction of wide band-gap semiconductor devices.