Tomáš Trojek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tomáš Trojek has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
L. Musílek
3 shared publicationsLadislav Musílek
Department of Dosimetry and Application of Ionizing Radiation, Czech Technical University in Prague, Czech Republic
3 shared publicationsM. Hložek
3 shared publications- Gunther Kletetschka
Institute of Hydrogeology, Engineering Geology and Applied Geophysics, Faculty of Science, Charles University, Albertov 6, CZ-12800 Prague 2, Czech Republic
2 shared publications - Jan Adámek
Faculty of Nuclear Sciences and Physical Engineering, Czech Technical University in Prague, Břehová 7, Praha 1, 11519, Czech Republic, Czech Republic
2 shared publications - Jiří Mizera
Academy of Sciences of the Czech Republic
2 shared publications
Latest Publications
- Open Access
- 26 March 2024
- Published by MDPI AG in Preprints.org
Meteoritic Matter and Spherules in a Presumed Impact Crater at Emmerting, Germany
Bulk composition, mineralogy and microchemistry of various fractions of the filling of the Crater No. 4 at Emmerting were investigated. Here we present mainly the fine fractions, which, in contrast to pebbles larger than ca. 4 cm, are relatively poor in material affected by melting. A 0.1 mm long meteorite fragment without ablation features was found, and remelted fragments of the same body have been identified. The projectile was dominated by enstatite, also containing forsterite, basic plagioclase, Ni-rich pyrrhotite and troilite, kamacite, silica, and probably merrillite. The molten fragments contain porous Mg-rich glass (indicating temperature > 1500 °C), minor Fe oxides, and occasionally uncommon Ni-rich minerals. The bulk composition and electron microprobe show that the amount of meteoritic material is low (<< 1 %), and it is not unequivocally manifested even in platinum-group elements abundances and osmium isotope ratios (the latter, however, were only measured in two samples). This can be explained by dilution of the filling by particles brought after the crater formation, and by probably achondritic composition of the projectile. Relatively large hollow spheroid Fe oxide particles were observed in thin sections from the magnetic fraction. A Mn oxide hollow spherule has also been found. In magnetically separated filling from the nearby Crater No. 5, bulk chemical composition points to contamination with several metals and metalloids probably due to influence of recent alluvial sediments. Therefore, the extent of meteoritic contamination in this crater may be even smaller.
- 26 March 2024
- Published by MDPI AG in Preprints.org
Open AccessMeteoritic Matter and Spherules in a Presumed Impact Crater at Emmerting, Germany
Bulk composition, mineralogy and microchemistry of various fractions of the filling of the Crater No. 4 at Emmerting were investigated. Here we present mainly the fine fractions, which, in contrast to pebbles larger than ca. 4 cm, are relatively poor in material affected by melting. A 0.1 mm long meteorite fragment without ablation features was found, and remelted fragments of the same body have been identified. The projectile was dominated by enstatite, also containing forsterite, basic plagioclase, Ni-rich pyrrhotite and troilite, kamacite, silica, and probably merrillite. The molten fragments contain porous Mg-rich glass (indicating temperature > 1500 °C), minor Fe oxides, and occasionally uncommon Ni-rich minerals. The bulk composition and electron microprobe show that the amount of meteoritic material is low (<< 1 %), and it is not unequivocally manifested even in platinum-group elements abundances and osmium isotope ratios (the latter, however, were only measured in two samples). This can be explained by dilution of the filling by particles brought after the crater formation, and by probably achondritic composition of the projectile. Relatively large hollow spheroid Fe oxide particles were observed in thin sections from the magnetic fraction. A Mn oxide hollow spherule has also been found. In magnetically separated filling from the nearby Crater No. 5, bulk chemical composition points to contamination with several metals and metalloids probably due to influence of recent alluvial sediments. Therefore, the extent of meteoritic contamination in this crater may be even smaller.
- Open Access
- 22 March 2024
- Published by MDPI AG in Preprints.org
Comparison of Melting-Affected Rocks from Presumed Small Impact Craters and Old Limekilns in Bavaria, Germany
Depressions containing partially molten rocks were investigated in Quaternary pebbly sedi-ments in Alpine foreland in Bavaria, Germany. Ruins of limekilns from 18-19th centuries are abundant around Seeshaupt. They are usually associated with earthworks for fuel feeding and protection from wind. Depressions contain partially molten stones from furnace walls, with lime and burnt loam remnants. On the surface of pebbles (typically gneisses), green glass formed with chemical composition possibly affected by moderately volatile components of wood biomass, mainly K and Cu. Thermoplastic deformation of pebbles is limited and the sur-face melt deformation points to slow flow. At Emmerting, on the other hand, two walled circu-lar depressions which lack additional earthworks have been identified as possible impact cra-ters. Thermally affected pebbles show much more intense deformation. Colorless to greenish glass, also K and Cu enriched, usually forms only thin surface coatings, in places covered by younger melt extruded from pebble interior. Burnt loam is missing. At Grabenstätt-Kaltenbach, a depression of unclear origin was investigated. Morphologically, it matches craters rather than limekilns, but anthropogenic contamination (brick-like material) is probable. The rare molten samples do not display extreme deformation features. The thermally affected stones, mainly those from Emmerting, have elevated magnetic susceptibility.
- 22 March 2024
- Published by MDPI AG in Preprints.org
Open AccessComparison of Melting-Affected Rocks from Presumed Small Impact Craters and Old Limekilns in Bavaria, Germany
Depressions containing partially molten rocks were investigated in Quaternary pebbly sedi-ments in Alpine foreland in Bavaria, Germany. Ruins of limekilns from 18-19th centuries are abundant around Seeshaupt. They are usually associated with earthworks for fuel feeding and protection from wind. Depressions contain partially molten stones from furnace walls, with lime and burnt loam remnants. On the surface of pebbles (typically gneisses), green glass formed with chemical composition possibly affected by moderately volatile components of wood biomass, mainly K and Cu. Thermoplastic deformation of pebbles is limited and the sur-face melt deformation points to slow flow. At Emmerting, on the other hand, two walled circu-lar depressions which lack additional earthworks have been identified as possible impact cra-ters. Thermally affected pebbles show much more intense deformation. Colorless to greenish glass, also K and Cu enriched, usually forms only thin surface coatings, in places covered by younger melt extruded from pebble interior. Burnt loam is missing. At Grabenstätt-Kaltenbach, a depression of unclear origin was investigated. Morphologically, it matches craters rather than limekilns, but anthropogenic contamination (brick-like material) is probable. The rare molten samples do not display extreme deformation features. The thermally affected stones, mainly those from Emmerting, have elevated magnetic susceptibility.
- 9 February 2024
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 218
Quantitative X-ray fluorescence micro-analysis of wood samples and visualization of tree rings
- 9 February 2024
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 218
Quantitative X-ray fluorescence micro-analysis of wood samples and visualization of tree rings
- Open Access
Uncertainty of Quantitative X-ray Fluorescence Micro-Analysis of Metallic Artifacts Caused by Their Curved Shapes
This paper summarizes the effects of irregular shape on the results of a quantitative X-ray fluorescence (XRF) micro-analysis. These effects become relevant when an XRF analysis is performed directly on an investigated material. A typical example is XRF analyses of valuable and historical objects whose measurements should be performed non-destructively and non-invasively, without taking samples. Several measurements and computer simulations were performed for selected metallic materials and shapes to evaluate the accuracy and precision of XRF. The described experiments and the corresponding Monte Carlo simulations were related to the XRF device designed and utilized at the Czech Technical University. It was found that the relative uncertainty was typically about 5–10% or even higher in quantitative analyses of minor elements due to irregular shapes of surfaces. This must be considered in cases of the interpretation of XRF results, especially in the cultural heritage sciences. The conclusions also contain several recommendations on how to measure objects under hard-to-define geometric conditions with respect to reduction in the surface effect in quantitative or semi-quantitative XRF analyses.
Open AccessUncertainty of Quantitative X-ray Fluorescence Micro-Analysis of Metallic Artifacts Caused by Their Curved Shapes
This paper summarizes the effects of irregular shape on the results of a quantitative X-ray fluorescence (XRF) micro-analysis. These effects become relevant when an XRF analysis is performed directly on an investigated material. A typical example is XRF analyses of valuable and historical objects whose measurements should be performed non-destructively and non-invasively, without taking samples. Several measurements and computer simulations were performed for selected metallic materials and shapes to evaluate the accuracy and precision of XRF. The described experiments and the corresponding Monte Carlo simulations were related to the XRF device designed and utilized at the Czech Technical University. It was found that the relative uncertainty was typically about 5–10% or even higher in quantitative analyses of minor elements due to irregular shapes of surfaces. This must be considered in cases of the interpretation of XRF results, especially in the cultural heritage sciences. The conclusions also contain several recommendations on how to measure objects under hard-to-define geometric conditions with respect to reduction in the surface effect in quantitative or semi-quantitative XRF analyses.
- 22 August 2022
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 198 (9-11) , 654-660
DETERMINATION OF URANIUM AND THORIUM SURFACE DISTRIBUTION IN GEOLOGICAL SAMPLES: COMPARISON OF TABLETOP MACRO AND MICRO-XRF SCANNING
This paper describes the identification and quantification of uranium, thorium and other chemical elements in a low-grade uranium ore, using macro and micro-X-ray fluorescence scanning. The result of such scanning is their surface distribution determined in flat samples. The basic parameters of both setups are described. The investigation was focused mainly on the improvement of the lateral resolution in the laboratory tabletop macro-XRF and its comparison with micro-XRF scanning. A standard reference material NIST 610 was used as a homogeneous reference silicate material of a known composition. The measurements have demonstrated how the macro-XRF with a quite wide X-ray beam can be competitive with the micro-XRF scanning. The capabilities of both devices were established, utilizing measurements of selected uranium-bearing sediments samples, from the Břevniště deposit in the Czech Republic.
- 22 August 2022
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 198 (9-11) , 654-660
DETERMINATION OF URANIUM AND THORIUM SURFACE DISTRIBUTION IN GEOLOGICAL SAMPLES: COMPARISON OF TABLETOP MACRO AND MICRO-XRF SCANNING
This paper describes the identification and quantification of uranium, thorium and other chemical elements in a low-grade uranium ore, using macro and micro-X-ray fluorescence scanning. The result of such scanning is their surface distribution determined in flat samples. The basic parameters of both setups are described. The investigation was focused mainly on the improvement of the lateral resolution in the laboratory tabletop macro-XRF and its comparison with micro-XRF scanning. A standard reference material NIST 610 was used as a homogeneous reference silicate material of a known composition. The measurements have demonstrated how the macro-XRF with a quite wide X-ray beam can be competitive with the micro-XRF scanning. The capabilities of both devices were established, utilizing measurements of selected uranium-bearing sediments samples, from the Břevniště deposit in the Czech Republic.
- Open Access
X-ray Fluorescence Analysis of Pigments in Gothic Frescoes, Coats of Arms, and Polychromy on Sculptures on the Triforium in St. Vitus Cathedral on the Territory of the Czech Kingdom in the 14th Century
Pigments in the paints used for the coats of arms, polychromy on sculptures, and pigments in frescoes characterize not only the epoch but also individual creators or groups of artists involved in their creation. X-ray fluorescence analysis is a non-destructive method suitable for determining the chemical composition of these artifacts. This article covers the results of measurements of selected objects, and compares them with similar objects from the territory of the Czech Kingdom in the 14th century.
Open AccessX-ray Fluorescence Analysis of Pigments in Gothic Frescoes, Coats of Arms, and Polychromy on Sculptures on the Triforium in St. Vitus Cathedral on the Territory of the Czech Kingdom in the 14th Century
Pigments in the paints used for the coats of arms, polychromy on sculptures, and pigments in frescoes characterize not only the epoch but also individual creators or groups of artists involved in their creation. X-ray fluorescence analysis is a non-destructive method suitable for determining the chemical composition of these artifacts. This article covers the results of measurements of selected objects, and compares them with similar objects from the territory of the Czech Kingdom in the 14th century.
- 2 May 2022
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 200
Confocal XRF imaging for determination of arsenic distribution in a sample of historic plaster
- 2 May 2022
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 200
Confocal XRF imaging for determination of arsenic distribution in a sample of historic plaster
- 1 February 2020
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 167, 108344
Techniques for identifying depth inhomogeneities of elemental distribution in materials
- 1 February 2020
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 167, 108344
Techniques for identifying depth inhomogeneities of elemental distribution in materials
- 1 November 2017
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 140, 161-166
Determination of U, Th and K in bricks by gamma-ray spectrometry, X-ray fluorescence analysis and neutron activation analysis
- 1 November 2017
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 140, 161-166
Determination of U, Th and K in bricks by gamma-ray spectrometry, X-ray fluorescence analysis and neutron activation analysis
- 1 August 2017
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 137, 230-233
X-ray fluorescence – a non-destructive tool in investigation of Czech fine and applied art objects
- 1 August 2017
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 137, 230-233
X-ray fluorescence – a non-destructive tool in investigation of Czech fine and applied art objects