Andrea Fantini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Andrea Fantini has a total of 79 co-authors. Here are the top co-authors by number of shared publications:
- Daniele Garbin
IMEC, Leuven, Belgium
3 shared publications - Robin Degraeve
IMEC
3 shared publications - Sergiu Clima
IMEC, Kapeldreef 75, Leuven, Belgium
3 shared publications Gabriele Luca Donadio
Semiconductor Technology and Systems imec Kapeldreef 75 Leuven 3001 Belgium
2 shared publicationsGouri Sankar Kar
Semiconductor Technology and Systems imec Kapeldreef 75 Leuven 3001 Belgium
2 shared publications- Gouri Sankar Kar
IMEC
2 shared publications
Latest Publications
- 15 January 2023
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 17 (8)
Polarity‐Induced Threshold Voltage Shift in Ovonic Threshold Switching Chalcogenides and the Impact of Material Composition
Amorphous chalcogenide‐based ovonic threshold switch (OTS) selectors are an important part of the crosspoint memory arrays. It is known that the threshold voltage (Vth) of the OTS device can be affected by operating conditions, such as pulse amplitude and ramp rate. Herein, the impact of pulse polarity on OTS parameters is investigated. Recent findings on the polarity‐induced Vth shift observed in SiGeAsTe and SiGeAsSe materials are summarized. This effect is manifested as a stable and reversible change in Vth resulting from the reversal of applied pulse polarity, thus allowing Vth to be electrically controlled. Herein, for the first time exceptionally large polarity‐induced Vth shift in GeSe OTS is reported. The behavior observed in binary GeSe and quaternary SiGeAs(Te/Se) material systems is compared and the dependence of polarity effects on the composition of OTS devices is discussed. The impact of film thickness, interface, and stoichiometry in GeSe OTS is investigated.
- 15 January 2023
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 17 (8)
Polarity‐Induced Threshold Voltage Shift in Ovonic Threshold Switching Chalcogenides and the Impact of Material Composition
Amorphous chalcogenide‐based ovonic threshold switch (OTS) selectors are an important part of the crosspoint memory arrays. It is known that the threshold voltage (Vth) of the OTS device can be affected by operating conditions, such as pulse amplitude and ramp rate. Herein, the impact of pulse polarity on OTS parameters is investigated. Recent findings on the polarity‐induced Vth shift observed in SiGeAsTe and SiGeAsSe materials are summarized. This effect is manifested as a stable and reversible change in Vth resulting from the reversal of applied pulse polarity, thus allowing Vth to be electrically controlled. Herein, for the first time exceptionally large polarity‐induced Vth shift in GeSe OTS is reported. The behavior observed in binary GeSe and quaternary SiGeAs(Te/Se) material systems is compared and the dependence of polarity effects on the composition of OTS devices is discussed. The impact of film thickness, interface, and stoichiometry in GeSe OTS is investigated.
- 3 May 2022
- Published by Elsevier in Thin Solid Films
- Vol. 753
A combinatorial study of SiGeAsTe thin films for application as an Ovonic threshold switch selector
- 3 May 2022
- Published by Elsevier in Thin Solid Films
- Vol. 753
A combinatorial study of SiGeAsTe thin films for application as an Ovonic threshold switch selector
- Open Access
- 1 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. P10-1
Degradation mechanism of amorphous IGZO-based bipolar metal-semiconductor-metal selectors
To enable high-density cross-point arrays of magnetic memory a suitable access device is necessary. A promising candidate for this role is a metal-semiconductor-metal (MSM) tunneling device. In this work, the operation of an ultrathin Pt\6nm a-IGZO\Pt stack as an MSM selector is discussed. The focus is given to understanding the breakdown mechanism at high current regime, which prevents it from reaching the target current density. The breakdown is preceded by a gradual degradation process, which is manifested as an increase in high-field current after prolonged stress. This effect is recoverable – current returns to original value after sufficient delay time. Based on these observations, we propose a mechanism, where increased high-field current can be explained as a decrease in Schottky barrier height arising from stress-induced increase in oxygen vacancies.
- 1 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. P10-1
Open AccessDegradation mechanism of amorphous IGZO-based bipolar metal-semiconductor-metal selectors
To enable high-density cross-point arrays of magnetic memory a suitable access device is necessary. A promising candidate for this role is a metal-semiconductor-metal (MSM) tunneling device. In this work, the operation of an ultrathin Pt\6nm a-IGZO\Pt stack as an MSM selector is discussed. The focus is given to understanding the breakdown mechanism at high current regime, which prevents it from reaching the target current density. The breakdown is preceded by a gradual degradation process, which is manifested as an increase in high-field current after prolonged stress. This effect is recoverable – current returns to original value after sufficient delay time. Based on these observations, we propose a mechanism, where increased high-field current can be explained as a decrease in Schottky barrier height arising from stress-induced increase in oxygen vacancies.
- 31 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (2) , 505-511
Modeling and Demonstration of Oxygen Vacancy-Based RRAM as Probabilistic Device for Sequence Learning
- 31 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (2) , 505-511
Modeling and Demonstration of Oxygen Vacancy-Based RRAM as Probabilistic Device for Sequence Learning
- Open Access
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 35.2.1-35.2.4
Endurance improvement of more than five orders in GexSe1-x OTS selectors by using a novel refreshing program scheme
Selector device is critical in high-density cross-point resistive switching memory arrays for suppressing the sneak leakage current path. Ge x Se 1-x based ovonic threshold switch (OTS) selectors have recently demonstrated strong performance with high on-state current, nonlinearity and endurance. Detailed study of its reliability is still lacking and the understanding on the responsible mechanisms is limited. In this work, for the first time, the endurance degradation mechanism of Ge-rich Ge x Se 1-x OTS is identified. Accumulation of slow defects that remain delocalized at off-state and GeSe segregation/crystallization during cycling lead to the recoverable and non-recoverable leakage current, respectively. Most importantly, a refreshing program scheme is developed to recover and prevent the OTS degradation and the endurance can be therefore improved by more than five orders without adding additional material elements or process steps.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 35.2.1-35.2.4
Open AccessEndurance improvement of more than five orders in GexSe1-x OTS selectors by using a novel refreshing program scheme
Selector device is critical in high-density cross-point resistive switching memory arrays for suppressing the sneak leakage current path. Ge x Se 1-x based ovonic threshold switch (OTS) selectors have recently demonstrated strong performance with high on-state current, nonlinearity and endurance. Detailed study of its reliability is still lacking and the understanding on the responsible mechanisms is limited. In this work, for the first time, the endurance degradation mechanism of Ge-rich Ge x Se 1-x OTS is identified. Accumulation of slow defects that remain delocalized at off-state and GeSe segregation/crystallization during cycling lead to the recoverable and non-recoverable leakage current, respectively. Most importantly, a refreshing program scheme is developed to recover and prevent the OTS degradation and the endurance can be therefore improved by more than five orders without adding additional material elements or process steps.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 20.5.1-20.5.4
Temporal sequence learning with a history-sensitive probabilistic learning rule intrinsic to oxygen vacancy-based RRAM
Widely spread and low value resistance distributions inhibit the use of filamentary resistive RAM (RRAM) at low currents for deep learning training and inference. An entirely different approach which employs RRAM as active computational elements is proposed. For this means, the history-sensitive probabilistic reset in Tantalum-Oxide (TaOx)-based RRAM is characterized and explained. This intrinsic RRAM effect is used as a local learning rule in a novel temporal sequence learning algorithm.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 20.5.1-20.5.4
Temporal sequence learning with a history-sensitive probabilistic learning rule intrinsic to oxygen vacancy-based RRAM
Widely spread and low value resistance distributions inhibit the use of filamentary resistive RAM (RRAM) at low currents for deep learning training and inference. An entirely different approach which employs RRAM as active computational elements is proposed. For this means, the history-sensitive probabilistic reset in Tantalum-Oxide (TaOx)-based RRAM is characterized and explained. This intrinsic RRAM effect is used as a local learning rule in a novel temporal sequence learning algorithm.
- 26 July 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (31) , 20176-20184
Transient Thermometry and High-Resolution Transmission Electron Microscopy Analysis of Filamentary Resistive Switches
We present data on the filament size and temperature distribution in Hf0.82Al0.18Ox-based Resistive Random Access Memory (RRAM) devices obtained by transient thermometry and high-resolution transmission electron microscopy (HRTEM). The thermometry shows that the temperature of the nonvolatile conducting filament can reach temperatures as high as 1600 K at the onset of RESET at voltage of 0.8 V and power of 40 μW. The size of the filament was estimated at about 1 nm in diameter. Hot filament increases the temperature of the surrounding high resistivity oxide, causing it to conduct and carry a significant fraction of the total current. The current spreading results in slowing down the filament temperature increase at higher power. The results of thermometry have been corroborated by HRTEM analysis of the as-fabricated and switched RRAM devices. The functional HfAlOx layer in as-fabricated devices is amorphous. In devices that were switched, we detected a small crystalline region 10-15 nm in size. The crystallization temperature of the HfAlOx was determined to be 850 K in an independent annealing experiment. The size of the crystalline region agrees with thermal modeling based on the thermometry data. Scanning TEM coordinated with electron energy loss spectroscopy could not detect changes in the chemical make up of the filament.
- 26 July 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (31) , 20176-20184
Transient Thermometry and High-Resolution Transmission Electron Microscopy Analysis of Filamentary Resistive Switches
We present data on the filament size and temperature distribution in Hf0.82Al0.18Ox-based Resistive Random Access Memory (RRAM) devices obtained by transient thermometry and high-resolution transmission electron microscopy (HRTEM). The thermometry shows that the temperature of the nonvolatile conducting filament can reach temperatures as high as 1600 K at the onset of RESET at voltage of 0.8 V and power of 40 μW. The size of the filament was estimated at about 1 nm in diameter. Hot filament increases the temperature of the surrounding high resistivity oxide, causing it to conduct and carry a significant fraction of the total current. The current spreading results in slowing down the filament temperature increase at higher power. The results of thermometry have been corroborated by HRTEM analysis of the as-fabricated and switched RRAM devices. The functional HfAlOx layer in as-fabricated devices is amorphous. In devices that were switched, we detected a small crystalline region 10-15 nm in size. The crystallization temperature of the HfAlOx was determined to be 850 K in an independent annealing experiment. The size of the crystalline region agrees with thermal modeling based on the thermometry data. Scanning TEM coordinated with electron energy loss spectroscopy could not detect changes in the chemical make up of the filament.
- 1 September 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308876,p. 313-316
Carbon-doped GeTe Phase-Change Memory featuring remarkable RESET current reduction
In this paper we present a study of Phase-Change non-volatile Memory (PCM) devices integrating carbon-doped GeTe as chalcogenide material. Carbon-doped GeTe, named GeTeC, remarkably lowers the RESET current and features very good data retention properties as well. In particular, GeTe PCM with 10% carbon inclusions (named GeTeC10%) yields about 30% of RESET current reduction with respect to pure GeTe and GST. Furthermore, our GeTeC10% memory cells are expected to guarantee a 10-years-lifetime-temperature of about 127°C, which is one of the highest ever reported for PCM. The outstanding properties of GeTeC make this material promising for non-volatile memory technologies.
- 1 September 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308876,p. 313-316
Carbon-doped GeTe Phase-Change Memory featuring remarkable RESET current reduction
In this paper we present a study of Phase-Change non-volatile Memory (PCM) devices integrating carbon-doped GeTe as chalcogenide material. Carbon-doped GeTe, named GeTeC, remarkably lowers the RESET current and features very good data retention properties as well. In particular, GeTe PCM with 10% carbon inclusions (named GeTeC10%) yields about 30% of RESET current reduction with respect to pure GeTe and GST. Furthermore, our GeTeC10% memory cells are expected to guarantee a 10-years-lifetime-temperature of about 127°C, which is one of the highest ever reported for PCM. The outstanding properties of GeTeC make this material promising for non-volatile memory technologies.
- 1 April 1990
- Published by Elsevier in International Journal of Cardiology
- Vol. 27 (1) , 107-116
Abnormalities of left ventricular shape in patients with stable angina
- 1 April 1990
- Published by Elsevier in International Journal of Cardiology
- Vol. 27 (1) , 107-116
Abnormalities of left ventricular shape in patients with stable angina