Baodui Chai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Baodui Chai has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Junhu Yang
School of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou 730050, China
2 shared publications - Xiaohui Wang
School of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou 730050, China
2 shared publications - Bingxiao Jiang
School of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou, China
1 shared publication - Hanqing Chen
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, China
1 shared publication - Lu Ma
School of Chemistry and Chemical Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China
1 shared publication - Ruqi Yan
School of Chemistry and Chemical Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China
1 shared publication
Latest Publications
- Open Access
- 23 August 2024
- Published by MDPI AG in Lubricants
- Vol. 12 (9) , 298
Dynamic Coefficient Investigation for Supercritical Carbon Dioxide Dry Gas Seal Based on Complete Variable Perturbation Model
In this work, a new model to analyse the dynamic characteristic coefficient of the S-CO2 dry gas seal was reported. Taking into account that the flow within the S-CO2 dry gas seal is close to adiabatic flow, the impact of the temperature change on the dynamic characteristic coefficient of the gas film cannot be ignored. To address this issue, a complete variable perturbation model (CVPM) under the adiabatic flow process was established using the frequency perturbation method while considering multiple complex effects. Then, the finite difference method was used to solve the CVPM. The gas film’s dynamic stiffness and damping coefficients were calculated and analysed for different conditions, operating parameters, and frequency ratios. From our analysis, it was demonstrated that the dynamic coefficient of the gas film exhibited frequency dependence. The turbulence coefficient perturbation had the most remarkable influence on the gas film’s dynamic coefficient, compared to the temperature, viscosity, and centrifugal inertia force perturbations. The isothermal flow, adiabatic flow, inlet pressure, and inlet temperature also affected the magnitude of the dynamic characteristic coefficient of the gas film. However, no significant impact on their tendency to vary with the frequency ratio was found. Our work provides new theoretical support for the dynamic analysis of S-CO2 dry gas seals, which is of great importance for future applications.
- 23 August 2024
- Published by MDPI AG in Lubricants
- Vol. 12 (9) , 298
Open AccessDynamic Coefficient Investigation for Supercritical Carbon Dioxide Dry Gas Seal Based on Complete Variable Perturbation Model
In this work, a new model to analyse the dynamic characteristic coefficient of the S-CO2 dry gas seal was reported. Taking into account that the flow within the S-CO2 dry gas seal is close to adiabatic flow, the impact of the temperature change on the dynamic characteristic coefficient of the gas film cannot be ignored. To address this issue, a complete variable perturbation model (CVPM) under the adiabatic flow process was established using the frequency perturbation method while considering multiple complex effects. Then, the finite difference method was used to solve the CVPM. The gas film’s dynamic stiffness and damping coefficients were calculated and analysed for different conditions, operating parameters, and frequency ratios. From our analysis, it was demonstrated that the dynamic coefficient of the gas film exhibited frequency dependence. The turbulence coefficient perturbation had the most remarkable influence on the gas film’s dynamic coefficient, compared to the temperature, viscosity, and centrifugal inertia force perturbations. The isothermal flow, adiabatic flow, inlet pressure, and inlet temperature also affected the magnitude of the dynamic characteristic coefficient of the gas film. However, no significant impact on their tendency to vary with the frequency ratio was found. Our work provides new theoretical support for the dynamic analysis of S-CO2 dry gas seals, which is of great importance for future applications.
- Open Access
Force Characteristics of Centrifugal Pump as Turbine during Start-Up Process under Gas–Liquid Two-Phase Conditions
The start-up process of a centrifugal pump as turbine (PAT) under gas–liquid two-phase conditions was simulated based on Fluent, and the evolution mechanism of the internal flow field and the variation law of force characteristics were studied in its start-up process under gas–liquid two-phase conditions. The results show that the area with high gas phase concentration corresponds to a strong vortex at the beginning of the start-up. The vortex intensity in the impeller gradually decreases with an increase in rotational speed. The gas volume fraction of the blade suction surface is more significant than that of the blade pressure surface. The higher the inlet gas volume fraction (IGVF) is, the more severely the blade load will fluctuate during the start-up process. As the rotational speed increases, the fluctuation of the blade load gradually weakens, and the maximum load is distributed near the inner edge of the blade after the rotational speed is stable. The periodic unbalanced radial force is produced in the start-up process. From the pure liquid conditions to the gas–liquid two-phase conditions with increasing IGVF, the dominant frequency amplitude of radial force shows a similar trend of decreasing first but then increasing. After the rotational speed tends to be stable, the dominant frequency of radial force is equal to the rotational frequency of the blade. With the increase in rotational speed, the dominant frequency amplitude of axial force decreases gradually. The higher the IGVF, the greater the dominant frequency amplitude of axial force at the same time.
Open AccessForce Characteristics of Centrifugal Pump as Turbine during Start-Up Process under Gas–Liquid Two-Phase Conditions
The start-up process of a centrifugal pump as turbine (PAT) under gas–liquid two-phase conditions was simulated based on Fluent, and the evolution mechanism of the internal flow field and the variation law of force characteristics were studied in its start-up process under gas–liquid two-phase conditions. The results show that the area with high gas phase concentration corresponds to a strong vortex at the beginning of the start-up. The vortex intensity in the impeller gradually decreases with an increase in rotational speed. The gas volume fraction of the blade suction surface is more significant than that of the blade pressure surface. The higher the inlet gas volume fraction (IGVF) is, the more severely the blade load will fluctuate during the start-up process. As the rotational speed increases, the fluctuation of the blade load gradually weakens, and the maximum load is distributed near the inner edge of the blade after the rotational speed is stable. The periodic unbalanced radial force is produced in the start-up process. From the pure liquid conditions to the gas–liquid two-phase conditions with increasing IGVF, the dominant frequency amplitude of radial force shows a similar trend of decreasing first but then increasing. After the rotational speed tends to be stable, the dominant frequency of radial force is equal to the rotational frequency of the blade. With the increase in rotational speed, the dominant frequency amplitude of axial force decreases gradually. The higher the IGVF, the greater the dominant frequency amplitude of axial force at the same time.
- Open Access
Pressure Fluctuation Characteristics Analysis of Centrifugal Pump as Turbine in Its Start-Up Process
In order to study pressure fluctuation characteristics of a centrifugal pump as turbine (PAT) in its start-up process, Fluent was used to do numerical simulation of the PAT start-up process. Time and frequency domain analyses were performed on the data acquired at different positions and different heads. The results show that a large number of low-pressure areas and strong vortexes are formed within the impeller at the initial time of start-up. With the increase in rotating speed, the vortexes rapidly decrease and are concentrated on the blade non-working face. The pressure fluctuation amplitude is the maximum at the start-up initial instant; with increase in rotating speed, it reduces rapidly at the volute spiral part. The pressure fluctuation number within one impeller rotation cycle is consistent with blade number, and the dominant frequency of pressure fluctuation is 6 times the impeller rotational frequency. The dominant frequency amplitude of radial pressure fluctuation increases with decrease in radial size in the volute. The pressure fluctuation in the impeller is much more intensive than that in the volute, and its maximum dominant frequency amplitude occurs in the middle of the impeller towards the inner edge. With the increase in head, the number of pressure fluctuation and the amplitude of dominant frequency increase at the same time during the start-up process.
Open AccessPressure Fluctuation Characteristics Analysis of Centrifugal Pump as Turbine in Its Start-Up Process
In order to study pressure fluctuation characteristics of a centrifugal pump as turbine (PAT) in its start-up process, Fluent was used to do numerical simulation of the PAT start-up process. Time and frequency domain analyses were performed on the data acquired at different positions and different heads. The results show that a large number of low-pressure areas and strong vortexes are formed within the impeller at the initial time of start-up. With the increase in rotating speed, the vortexes rapidly decrease and are concentrated on the blade non-working face. The pressure fluctuation amplitude is the maximum at the start-up initial instant; with increase in rotating speed, it reduces rapidly at the volute spiral part. The pressure fluctuation number within one impeller rotation cycle is consistent with blade number, and the dominant frequency of pressure fluctuation is 6 times the impeller rotational frequency. The dominant frequency amplitude of radial pressure fluctuation increases with decrease in radial size in the volute. The pressure fluctuation in the impeller is much more intensive than that in the volute, and its maximum dominant frequency amplitude occurs in the middle of the impeller towards the inner edge. With the increase in head, the number of pressure fluctuation and the amplitude of dominant frequency increase at the same time during the start-up process.