Daniel Lichtenwalner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Daniel Lichtenwalner has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Philipp Steinmann
Wolfspeed Inc., Durham, NC, USA
4 shared publications Edward Van Brunt
Wolfspeed Inc. , 4401 Silicon Drive, Durham, North Carolina 27703, USA
3 shared publications- Brett Hull
Wolfspeed, A Cree Company
2 shared publications Brett Hull
Wolfspeed Inc. , 4401 Silicon Drive, Durham, North Carolina, USA 27703
1 shared publicationCharles Van Brackle
Wolfspeed Inc., Research Triangle Park, NC, USA
1 shared publicationElizabeth Williams
Wolfspeed Inc., Research Triangle Park, NC, USA
1 shared publication
Latest Publications
- 30 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (2) , 939-942
Temperature Coefficients for Impact Ionization in Silicon Derived From Temperature Coefficients of Avalanche Voltage
Recently, a method to extract temperature coefficients of impact ionization (II) from the linear and quadratic temperature coefficients of avalanche voltage was successfully applied for 4H-SiC devices. We apply the same method here to Silicon by first providing new data for linear and quadratic temperature coefficients of avalanche voltages and using the method to derive new temperature coefficients for four different models of II coefficients.
- 30 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (2) , 939-942
Temperature Coefficients for Impact Ionization in Silicon Derived From Temperature Coefficients of Avalanche Voltage
Recently, a method to extract temperature coefficients of impact ionization (II) from the linear and quadratic temperature coefficients of avalanche voltage was successfully applied for 4H-SiC devices. We apply the same method here to Silicon by first providing new data for linear and quadratic temperature coefficients of avalanche voltages and using the method to derive new temperature coefficients for four different models of II coefficients.
- Open Access
- 15 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (23)
Erratum: “Temperature dependence of avalanche breakdown in 4H-SiC devices” [J. Appl. Phys. 133, 235705 (2023)]
Two inadvertent errors in our paper1 have been brought to our attention by our readers. We want to correct them here. The corrections do not affect the general
- 15 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (23)
Open AccessErratum: “Temperature dependence of avalanche breakdown in 4H-SiC devices” [J. Appl. Phys. 133, 235705 (2023)]
Two inadvertent errors in our paper1 have been brought to our attention by our readers. We want to correct them here. The corrections do not affect the general
- Open Access
- 16 June 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (23)
Temperature dependence of avalanche breakdown in 4H-SiC devices
We report new data on the temperature coefficient of the avalanche breakdown voltage (BV) in 4H-SiC devices. We compare avalanche in different device types (MOSFETs/Schottky diodes), different measurement types [Id(Vd)-sweeps and unclamped inductive switching stress], and avalanche directions (vertical and lateral) for a wide range of avalanche voltages. We fit the measured BV(T)-curves to the one-sided abrupt junction model and extract values for the temperature coefficients of impact ionization coefficients in their Chynoweth and Thornber forms for both holes and electrons.
- 16 June 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (23)
Open AccessTemperature dependence of avalanche breakdown in 4H-SiC devices
We report new data on the temperature coefficient of the avalanche breakdown voltage (BV) in 4H-SiC devices. We compare avalanche in different device types (MOSFETs/Schottky diodes), different measurement types [Id(Vd)-sweeps and unclamped inductive switching stress], and avalanche directions (vertical and lateral) for a wide range of avalanche voltages. We fit the measured BV(T)-curves to the one-sided abrupt junction model and extract values for the temperature coefficients of impact ionization coefficients in their Chynoweth and Thornber forms for both holes and electrons.
- Open Access
- 18 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (7) , 3848-3853
Improvements to the Analytical Model to Describe UIS Events
We generalize and refine an analytical model to describe unclamped inductive switching (UIS) events in power MOSFETs and derive a novel, fast method to extract thermal impedance and series resistance from the UIS waveform. We show excellent agreement between model and measurement for SiC MOSFETs. The method allows for the comparison of thermal impedance measurements of packaged parts to that of formerly not easily accessible waferlevel die. The model allows to evaluate UIS ruggedness and provides insight into the nature of ruggedness limitations. A figure of merit for UIS ruggedness is provided and different MOSFET architectures are compared with respect to UIS ruggedness.
- 18 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (7) , 3848-3853
Open AccessImprovements to the Analytical Model to Describe UIS Events
We generalize and refine an analytical model to describe unclamped inductive switching (UIS) events in power MOSFETs and derive a novel, fast method to extract thermal impedance and series resistance from the UIS waveform. We show excellent agreement between model and measurement for SiC MOSFETs. The method allows for the comparison of thermal impedance measurements of packaged parts to that of formerly not easily accessible waferlevel die. The model allows to evaluate UIS ruggedness and provides insight into the nature of ruggedness limitations. A figure of merit for UIS ruggedness is provided and different MOSFET architectures are compared with respect to UIS ruggedness.
- 16 June 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 92 (24) , 243506
Impact of elemental arsenic on electrical characteristics of metal-oxide-semiconductor capacitors on GaAs using atomic-layer deposited HfO2 gate dielectric
The interface between and sulfur-passivated GaAs was analyzed after atomic-layer deposition (ALD) and postdeposition annealing (PDA) using x-ray photoelectron spectroscopy. The ALD process resulted in elemental arsenic buildup at the interface. Electrical measurements confirmed that the elemental arsenic caused anomalously large values for equivalent oxide thickness (EOT), hysteresis, and frequency dispersion in accumulation. Arsenic outdiffusion after PDA lowered the EOT but increased the gate leakage. Annealing the -treated GaAs prior to ALD yielded an EOT of and leakage of at . This modified passivation scheme looks promising for achieving a high-quality interface.- 16 June 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 92 (24) , 243506
Impact of elemental arsenic on electrical characteristics of metal-oxide-semiconductor capacitors on GaAs using atomic-layer deposited HfO2 gate dielectric
The interface between and sulfur-passivated GaAs was analyzed after atomic-layer deposition (ALD) and postdeposition annealing (PDA) using x-ray photoelectron spectroscopy. The ALD process resulted in elemental arsenic buildup at the interface. Electrical measurements confirmed that the elemental arsenic caused anomalously large values for equivalent oxide thickness (EOT), hysteresis, and frequency dispersion in accumulation. Arsenic outdiffusion after PDA lowered the EOT but increased the gate leakage. Annealing the -treated GaAs prior to ALD yielded an EOT of and leakage of at . This modified passivation scheme looks promising for achieving a high-quality interface.