Nolwenn Le Biavan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Nolwenn Le Biavan has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Adrian Hierro
ISOM Universidad Politécnica de Madrid Madrid Spain
3 shared publications - Jean Michel Chauveau
Université Côte d’Azur, CNRS, CRHEA, 06560 Valbonne, France
3 shared publications - Maxime Hugues
Université Côte d'Azur, CNRS, CRHEA, rue Bernard Grégory , Valbonne 06560
3 shared publications - Miguel Montes Bajo
ISOM Universidad Politécnica de Madrid Madrid Spain
3 shared publications - Jose María Ulloa
Institute for Systems Based on Optoelectronics and Microtechnology (ISOM), Universidad Politécnica de Madrid 3 , 28040 Madrid
2 shared publications - Julen Tamayo-Arriola
Univ. Politecnica de Madrid (Spain)
2 shared publications
Latest Publications
- 4 April 2026
- Published by Agence Bibliographique de l'Enseignement Supérieur
Toward a zinc oxide based quantum cascade laser
Vers un laser à cascade quantique à base d’oxyde de zinc: Le domaine Terahertz (THz), situé entre le domaine visible et micro-ondes, se révèle être très prometteur du point de vue des applications. Cependant, ce potentiel n'est pas totalement exploité à cause du manque de sources compactes capables de couvrir une part importante de cette gamme d'énergie. Les Lasers à Cascade Quantiques (LQC) sont considérés comme de bons candidats, car ils sont à la fois compacts et accordables. Mais dans le domaine THz, les LQCs existants souffrent d'une limite de leur température de fonctionnement ( 200K ), ce qui restreint fortement le champ des applications possibles. Cela vient d'une propriété intrinsèque des matériaux qui sont communément utilisés pour concevoir les LQCs : l'énergie de phonon-LO. Par conséquent, une forte compétition entre la transition assistée par LO-phonon et la transition radiative à la base du LQC survient à température ambiante, ce qui réduit l'efficacité du processus laser. Pour contrer ce problème, nous avons choisi d'utiliser le ZnO, car son énergie de phonon-LO est deux fois plus large que celle des matériaux cités précédemment, ce qui permet au laser de fonctionner jusqu'à température ambiante. Même si le ZnO et ses alliages ne sont pas nouveaux dans le domaine des semiconducteurs, ils sont complètement exotiques dans le domaine des LQCs. Les LQCs reposent sur des hétérostructures hautement périodiques, desquelles les propriétés clés du dispositif final découlent. Par conséquent, ces hétérostructures doivent être contrôlées à la monocouche atomique près et cette précision doit être reproductible sur une centaine de périodes, ce qui fait de la croissance des LQCs un véritable challenge. Cette thèse vise à relever ce défi en portant les hétérostructures ZnO/(Zn, Mg)O a un degré de contrôle ultime. Nous mettons en oeuvre la croissance d'hétérostructures ZnO/(Zn, Mg)O sur substrats ZnO à l'aide d'un nouveau bâti d'épitaxie par jets moléculaires et nous avons démontré qu'elles sont de qualité compatible avec celle requise par les LQCs. Ce premier pas nous a permis de démontrer l'observation des transitions intersousbandes dans le moyen infrarouge jusqu'à température ambiante, ainsi que leur couplage dans des structures à puits quantiques asymétriques. Des structures à cascade complètes ont aussi été crû et ont mené à la première démonstration d'un détecteur à cascade quantique à base de ZnO dans l'infrarouge à température ambiante. Des structures LQC ont aussi été réalisées et des expériences de microscopie électronique en transmission en mode balayage montrent un excellent contrôle des hétérostructures.
- 4 April 2026
- Published by Agence Bibliographique de l'Enseignement Supérieur
Toward a zinc oxide based quantum cascade laser
Vers un laser à cascade quantique à base d’oxyde de zinc: Le domaine Terahertz (THz), situé entre le domaine visible et micro-ondes, se révèle être très prometteur du point de vue des applications. Cependant, ce potentiel n'est pas totalement exploité à cause du manque de sources compactes capables de couvrir une part importante de cette gamme d'énergie. Les Lasers à Cascade Quantiques (LQC) sont considérés comme de bons candidats, car ils sont à la fois compacts et accordables. Mais dans le domaine THz, les LQCs existants souffrent d'une limite de leur température de fonctionnement ( 200K ), ce qui restreint fortement le champ des applications possibles. Cela vient d'une propriété intrinsèque des matériaux qui sont communément utilisés pour concevoir les LQCs : l'énergie de phonon-LO. Par conséquent, une forte compétition entre la transition assistée par LO-phonon et la transition radiative à la base du LQC survient à température ambiante, ce qui réduit l'efficacité du processus laser. Pour contrer ce problème, nous avons choisi d'utiliser le ZnO, car son énergie de phonon-LO est deux fois plus large que celle des matériaux cités précédemment, ce qui permet au laser de fonctionner jusqu'à température ambiante. Même si le ZnO et ses alliages ne sont pas nouveaux dans le domaine des semiconducteurs, ils sont complètement exotiques dans le domaine des LQCs. Les LQCs reposent sur des hétérostructures hautement périodiques, desquelles les propriétés clés du dispositif final découlent. Par conséquent, ces hétérostructures doivent être contrôlées à la monocouche atomique près et cette précision doit être reproductible sur une centaine de périodes, ce qui fait de la croissance des LQCs un véritable challenge. Cette thèse vise à relever ce défi en portant les hétérostructures ZnO/(Zn, Mg)O a un degré de contrôle ultime. Nous mettons en oeuvre la croissance d'hétérostructures ZnO/(Zn, Mg)O sur substrats ZnO à l'aide d'un nouveau bâti d'épitaxie par jets moléculaires et nous avons démontré qu'elles sont de qualité compatible avec celle requise par les LQCs. Ce premier pas nous a permis de démontrer l'observation des transitions intersousbandes dans le moyen infrarouge jusqu'à température ambiante, ainsi que leur couplage dans des structures à puits quantiques asymétriques. Des structures à cascade complètes ont aussi été crû et ont mené à la première démonstration d'un détecteur à cascade quantique à base de ZnO dans l'infrarouge à température ambiante. Des structures LQC ont aussi été réalisées et des expériences de microscopie électronique en transmission en mode balayage montrent un excellent contrôle des hétérostructures.
- Open Access
- 21 July 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (26)
A Type I Hyperbolic Metamaterial Driven by Phonons on ZnO
Negative refraction index can be achieved with uniaxial, type I hyperbolic metamaterials (HMMs) featuring ɛ ∥ >0 and ɛ ⊥ <0. A strategy to accomplish this has been to use surface plasmon polaritons (SPPs) in stacked doped/undoped semiconductor layers. Alternately, surface phonon polaritons (SPhPs) have emerged as a promising low‐loss alternative. In this work, a phonon‐driven type I HMM using ZnO/(Zn,Mg)O heterostructures is designed, demonstrating control over the hyperbolic behavior through the careful choice of Mg content and layer thicknesses. This study shows that increasing the Mg concentration in the ternary layers enhances type I behavior, while the optimal layer thickness varies depending on the Mg content. After analyzing the conditions for achieving type I hyperbolic dispersion, this concept is experimentally demonstrated with three samples. The structures are characterized by means of polarized reflectance spectroscopy and attenuated total reflectance spectroscopy is used to report the presence of a SPhP mode within the type I region. Employing the transfer matrix method, it is demonstrated that this mode exhibits negative frequency dispersion, a hallmark of type I hyperbolic modes, and isofrequency curve calculations further confirm this behavior. Controlling the design of a phononic type I HMM lays the groundwork for exploring low‐loss, sub‐diffraction‐limited optical modes using SPhP excitations.
- 21 July 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (26)
Open AccessA Type I Hyperbolic Metamaterial Driven by Phonons on ZnO
Negative refraction index can be achieved with uniaxial, type I hyperbolic metamaterials (HMMs) featuring ɛ ∥ >0 and ɛ ⊥ <0. A strategy to accomplish this has been to use surface plasmon polaritons (SPPs) in stacked doped/undoped semiconductor layers. Alternately, surface phonon polaritons (SPhPs) have emerged as a promising low‐loss alternative. In this work, a phonon‐driven type I HMM using ZnO/(Zn,Mg)O heterostructures is designed, demonstrating control over the hyperbolic behavior through the careful choice of Mg content and layer thicknesses. This study shows that increasing the Mg concentration in the ternary layers enhances type I behavior, while the optimal layer thickness varies depending on the Mg content. After analyzing the conditions for achieving type I hyperbolic dispersion, this concept is experimentally demonstrated with three samples. The structures are characterized by means of polarized reflectance spectroscopy and attenuated total reflectance spectroscopy is used to report the presence of a SPhP mode within the type I region. Employing the transfer matrix method, it is demonstrated that this mode exhibits negative frequency dispersion, a hallmark of type I hyperbolic modes, and isofrequency curve calculations further confirm this behavior. Controlling the design of a phononic type I HMM lays the groundwork for exploring low‐loss, sub‐diffraction‐limited optical modes using SPhP excitations.
- 26 May 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (19) , 195143
Exciton ionization induced by intersubband absorption in nonpolar ZnO-ZnMgO quantum wells at room temperature
We present a systematic investigation of intersubband transitions in nonintentionally doped ZnO/ZnMgO quantum wells (QWs). The investigation is performed using photoinduced absorption spectroscopy at room temperature under optical pumping by a UV laser to generate electron-hole pairs. All samples exhibit TM-polarized intersubbandlike absorption resonances. However, the peak transition energy is largely blueshifted (>100 meV) with expectations from electronic quantum confinement simulations. Based on calculations of the exciton binding energies, we attribute the photoinduced absorption at room temperature to the dissociation of excitons towards free carriers in the state and not to to excitonic transitions induced by the intersubband absorption as previously stated by Olszakier et al. [ Phys. Rev. Lett. 62, 2997 (1989)]. This effect is a consequence of the huge binding energy of excitons in the ZnO material system, which is further enhanced in QWs due to the quantum confinement. This may pave the way for a better understanding of semiconductors’ excitonic processes as well as for developing intersubband devices with a blueshifted operating range.- 26 May 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (19) , 195143
Exciton ionization induced by intersubband absorption in nonpolar ZnO-ZnMgO quantum wells at room temperature
We present a systematic investigation of intersubband transitions in nonintentionally doped ZnO/ZnMgO quantum wells (QWs). The investigation is performed using photoinduced absorption spectroscopy at room temperature under optical pumping by a UV laser to generate electron-hole pairs. All samples exhibit TM-polarized intersubbandlike absorption resonances. However, the peak transition energy is largely blueshifted (>100 meV) with expectations from electronic quantum confinement simulations. Based on calculations of the exciton binding energies, we attribute the photoinduced absorption at room temperature to the dissociation of excitons towards free carriers in the state and not to to excitonic transitions induced by the intersubband absorption as previously stated by Olszakier et al. [ Phys. Rev. Lett. 62, 2997 (1989)]. This effect is a consequence of the huge binding energy of excitons in the ZnO material system, which is further enhanced in QWs due to the quantum confinement. This may pave the way for a better understanding of semiconductors’ excitonic processes as well as for developing intersubband devices with a blueshifted operating range.- Open Access
- 10 September 2019
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 123 (11) , 117401
Optical Phase Transition in Semiconductor Quantum Metamaterials
Unexpected light propagation effects, such as negative refraction, have been reported in artificial media. Leveraging on the intersubband resonances in heterostructured semiconductors, we show that all possible optical regimes, ranging from classical dieletric and metal to hyperbolic metamaterial types 1 and 2, can be achieved. As a demonstration, we prove that the negative refraction effect can occur at a designed frequency by controlling the electronic quantum confinement.
- 10 September 2019
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 123 (11) , 117401
Open AccessOptical Phase Transition in Semiconductor Quantum Metamaterials
Unexpected light propagation effects, such as negative refraction, have been reported in artificial media. Leveraging on the intersubband resonances in heterostructured semiconductors, we show that all possible optical regimes, ranging from classical dieletric and metal to hyperbolic metamaterial types 1 and 2, can be achieved. As a demonstration, we prove that the negative refraction effect can occur at a designed frequency by controlling the electronic quantum confinement.
- Open Access
- 26 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 766, 436-441
Ga-doping of nonpolar m-plane ZnMgO with high Mg contents
- 26 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 766, 436-441
Open AccessGa-doping of nonpolar m-plane ZnMgO with high Mg contents