Maxime Hugues
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Maxime Hugues has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Yvon Cordier
Université Côte d'Azur, CNRS, CRHEA 4 , rue Bernard Grégory, 06560 Valbonne
5 shared publications - Adrian Hierro
ISOM Universidad Politécnica de Madrid Madrid Spain
3 shared publications - Frédéric Georgi
Mines Paris
3 shared publications - Jean Michel Chauveau
Université Côte d’Azur, CNRS, CRHEA, 06560 Valbonne, France
3 shared publications - Miguel Montes Bajo
ISOM Universidad Politécnica de Madrid Madrid Spain
3 shared publications - Nolwenn Le Biavan
Université Cote d’Azur, CNRS, CRHEA, rue Bernard Gregory, Sophia Antipolis, 06560 Valbonne, France
3 shared publications
Latest Publications
- 11 May 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (19)
Ammonia source molecular beam epitaxy of ScAlN/GaN HEMTs with AlN exclusion layers
In this work, ScAlN/GaN high electron mobility transistor heterostructures were grown by molecular beam epitaxy with an ammonia source. The impact of inserting an AlN exclusion layer between the ScAlN barrier and the GaN channel is studied. On the one hand, increasing the AlN exclusion layer thickness from 0.15 to 3.5 nm results in an enhancement of the electron mobility from 391 to 921 cm2/V s. On the other hand, the heterostructure containing a 1.5 nm thick AlN layer grown at 800 °C exhibits a mobility of 666 cm2/V s, while that with a 1.6 nm AlN layer grown at a lower temperature reveals a mobility of 1025 cm2/V s, the maximum recorded in this study, which underlines the important role of this parameter.
- 11 May 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (19)
Ammonia source molecular beam epitaxy of ScAlN/GaN HEMTs with AlN exclusion layers
In this work, ScAlN/GaN high electron mobility transistor heterostructures were grown by molecular beam epitaxy with an ammonia source. The impact of inserting an AlN exclusion layer between the ScAlN barrier and the GaN channel is studied. On the one hand, increasing the AlN exclusion layer thickness from 0.15 to 3.5 nm results in an enhancement of the electron mobility from 391 to 921 cm2/V s. On the other hand, the heterostructure containing a 1.5 nm thick AlN layer grown at 800 °C exhibits a mobility of 666 cm2/V s, while that with a 1.6 nm AlN layer grown at a lower temperature reveals a mobility of 1025 cm2/V s, the maximum recorded in this study, which underlines the important role of this parameter.
- Open Access
- 23 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (24)
Surface oxidation and oxygen incorporation in ScAlN films grown by molecular beam epitaxy
Recently, there has been much interest in the ScAlN alloy, thanks to its various potential applications in high-frequency high-power, acoustoelectric, and ferroelectric devices. Nonetheless, these applications could be impaired by the presence of oxygen in the alloy and the formation of a surface oxide layer due to the high affinity of scandium with such impurity. A current trend is to increase the Sc content and most of the time it is accompanied by a lowering of the growth temperature. As it probably strongly influences the incorporation of impurities, we have carefully studied the effects of growth temperature and Sc content in the surface oxide and oxygen content of ScAlN films grown by ammonia source molecular beam epitaxy. The oxygen concentration and bonding configuration have been determined by combining normal-incidence, angle resolved, and ion-etching x-ray photoelectron spectroscopy.
- 23 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (24)
Open AccessSurface oxidation and oxygen incorporation in ScAlN films grown by molecular beam epitaxy
Recently, there has been much interest in the ScAlN alloy, thanks to its various potential applications in high-frequency high-power, acoustoelectric, and ferroelectric devices. Nonetheless, these applications could be impaired by the presence of oxygen in the alloy and the formation of a surface oxide layer due to the high affinity of scandium with such impurity. A current trend is to increase the Sc content and most of the time it is accompanied by a lowering of the growth temperature. As it probably strongly influences the incorporation of impurities, we have carefully studied the effects of growth temperature and Sc content in the surface oxide and oxygen content of ScAlN films grown by ammonia source molecular beam epitaxy. The oxygen concentration and bonding configuration have been determined by combining normal-incidence, angle resolved, and ion-etching x-ray photoelectron spectroscopy.
- Open Access
- 21 July 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (26)
A Type I Hyperbolic Metamaterial Driven by Phonons on ZnO
Negative refraction index can be achieved with uniaxial, type I hyperbolic metamaterials (HMMs) featuring ɛ ∥ >0 and ɛ ⊥ <0. A strategy to accomplish this has been to use surface plasmon polaritons (SPPs) in stacked doped/undoped semiconductor layers. Alternately, surface phonon polaritons (SPhPs) have emerged as a promising low‐loss alternative. In this work, a phonon‐driven type I HMM using ZnO/(Zn,Mg)O heterostructures is designed, demonstrating control over the hyperbolic behavior through the careful choice of Mg content and layer thicknesses. This study shows that increasing the Mg concentration in the ternary layers enhances type I behavior, while the optimal layer thickness varies depending on the Mg content. After analyzing the conditions for achieving type I hyperbolic dispersion, this concept is experimentally demonstrated with three samples. The structures are characterized by means of polarized reflectance spectroscopy and attenuated total reflectance spectroscopy is used to report the presence of a SPhP mode within the type I region. Employing the transfer matrix method, it is demonstrated that this mode exhibits negative frequency dispersion, a hallmark of type I hyperbolic modes, and isofrequency curve calculations further confirm this behavior. Controlling the design of a phononic type I HMM lays the groundwork for exploring low‐loss, sub‐diffraction‐limited optical modes using SPhP excitations.
- 21 July 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (26)
Open AccessA Type I Hyperbolic Metamaterial Driven by Phonons on ZnO
Negative refraction index can be achieved with uniaxial, type I hyperbolic metamaterials (HMMs) featuring ɛ ∥ >0 and ɛ ⊥ <0. A strategy to accomplish this has been to use surface plasmon polaritons (SPPs) in stacked doped/undoped semiconductor layers. Alternately, surface phonon polaritons (SPhPs) have emerged as a promising low‐loss alternative. In this work, a phonon‐driven type I HMM using ZnO/(Zn,Mg)O heterostructures is designed, demonstrating control over the hyperbolic behavior through the careful choice of Mg content and layer thicknesses. This study shows that increasing the Mg concentration in the ternary layers enhances type I behavior, while the optimal layer thickness varies depending on the Mg content. After analyzing the conditions for achieving type I hyperbolic dispersion, this concept is experimentally demonstrated with three samples. The structures are characterized by means of polarized reflectance spectroscopy and attenuated total reflectance spectroscopy is used to report the presence of a SPhP mode within the type I region. Employing the transfer matrix method, it is demonstrated that this mode exhibits negative frequency dispersion, a hallmark of type I hyperbolic modes, and isofrequency curve calculations further confirm this behavior. Controlling the design of a phononic type I HMM lays the groundwork for exploring low‐loss, sub‐diffraction‐limited optical modes using SPhP excitations.
- 1 March 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (3)
Erratum: “Influence of the temperature on growth by ammonia source molecular beam epitaxy of wurtzite phase ScAlN alloy on GaN” [APL Mater. 11, 031105 (2023)]
An error has been identified in the primary axis label of Fig. 4(a) of the original paper:1 the unit of capacitance should be mF/m2 rather than F/cm2. The corre
- 1 March 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (3)
Erratum: “Influence of the temperature on growth by ammonia source molecular beam epitaxy of wurtzite phase ScAlN alloy on GaN” [APL Mater. 11, 031105 (2023)]
An error has been identified in the primary axis label of Fig. 4(a) of the original paper:1 the unit of capacitance should be mF/m2 rather than F/cm2. The corre
- Open Access
- 16 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (16)
Alloy distribution and compositional metrology of epitaxial ScAlN by atom probe tomography
The properties of ScAlN layers grown by molecular beam epitaxy have been carefully studied using atom probe tomography (APT) and complementary techniques. The measured III-site fraction within the ScxAl1−xN layer is x = 0.16 ± 0.02, in good agreement with the values determined by x-ray photoelectron spectroscopy (XPS, x = 0.14) and secondary ion mass spectrometry (SIMS, x = 0.14). The frequency distribution analysis indicates that the compound behaves as a random alloy. A significant amount of oxygen, around 0.2% in site fraction, is found within the ScAlN layer as a randomly distributed impurity. The alloy composition measurement in terms of Sc fraction is rather independent of the surface electric field, which excludes compositional inaccuracies for the experimental parameters used in the APT analysis.
- 16 October 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (16)
Open AccessAlloy distribution and compositional metrology of epitaxial ScAlN by atom probe tomography
The properties of ScAlN layers grown by molecular beam epitaxy have been carefully studied using atom probe tomography (APT) and complementary techniques. The measured III-site fraction within the ScxAl1−xN layer is x = 0.16 ± 0.02, in good agreement with the values determined by x-ray photoelectron spectroscopy (XPS, x = 0.14) and secondary ion mass spectrometry (SIMS, x = 0.14). The frequency distribution analysis indicates that the compound behaves as a random alloy. A significant amount of oxygen, around 0.2% in site fraction, is found within the ScAlN layer as a randomly distributed impurity. The alloy composition measurement in terms of Sc fraction is rather independent of the surface electric field, which excludes compositional inaccuracies for the experimental parameters used in the APT analysis.
- Open Access
- 10 September 2019
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 123 (11) , 117401
Optical Phase Transition in Semiconductor Quantum Metamaterials
Unexpected light propagation effects, such as negative refraction, have been reported in artificial media. Leveraging on the intersubband resonances in heterostructured semiconductors, we show that all possible optical regimes, ranging from classical dieletric and metal to hyperbolic metamaterial types 1 and 2, can be achieved. As a demonstration, we prove that the negative refraction effect can occur at a designed frequency by controlling the electronic quantum confinement.
- 10 September 2019
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 123 (11) , 117401
Open AccessOptical Phase Transition in Semiconductor Quantum Metamaterials
Unexpected light propagation effects, such as negative refraction, have been reported in artificial media. Leveraging on the intersubband resonances in heterostructured semiconductors, we show that all possible optical regimes, ranging from classical dieletric and metal to hyperbolic metamaterial types 1 and 2, can be achieved. As a demonstration, we prove that the negative refraction effect can occur at a designed frequency by controlling the electronic quantum confinement.
- Open Access
- 26 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 766, 436-441
Ga-doping of nonpolar m-plane ZnMgO with high Mg contents
- 26 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 766, 436-441
Open AccessGa-doping of nonpolar m-plane ZnMgO with high Mg contents
- 23 January 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 100 (4) , 041118
Ultra-broad spontaneous emission and modal gain spectrum from a hybrid quantum well/quantum dot laser structure
We propose and demonstrate a hybrid quantum well/quantum dot structure to enhance the gain and spontaneous emission bandwidth of a quantum dot active region. A single quantum well is introduced into a multi-layer stack of quantum dots, spectrally positioned to cancel the losses due to the second excited state of the dots. As a result, the modal gain at room temperature is extended to 300 nm, covering the wavelength range of 1100-1400 nm, and spontaneous emission has a 250 nm, 3 dB linewidth from 1080-1335 nm, of interest to short-haul telecom and optical coherence tomography applications.
- 23 January 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 100 (4) , 041118
Ultra-broad spontaneous emission and modal gain spectrum from a hybrid quantum well/quantum dot laser structure
We propose and demonstrate a hybrid quantum well/quantum dot structure to enhance the gain and spontaneous emission bandwidth of a quantum dot active region. A single quantum well is introduced into a multi-layer stack of quantum dots, spectrally positioned to cancel the losses due to the second excited state of the dots. As a result, the modal gain at room temperature is extended to 300 nm, covering the wavelength range of 1100-1400 nm, and spontaneous emission has a 250 nm, 3 dB linewidth from 1080-1335 nm, of interest to short-haul telecom and optical coherence tomography applications.
- 1 May 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 278 (1-4) , 383-386
Structural and electrical properties of AlGaN/GaN HEMTs grown by MBE on SiC, Si(111) and GaN templates
- 1 May 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 278 (1-4) , 383-386
Structural and electrical properties of AlGaN/GaN HEMTs grown by MBE on SiC, Si(111) and GaN templates