Yangyang Fan
Yangyang Fan has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Zhenning Tao
Fujitsu Research & Development Center Company Ltd., Beijing, China
5 shared publications Hisao Nakashima
Fujitsu Ltd., Kawasaki, Japan
4 shared publications- Takeshi Hoshida
Fujitsu Ltd., Kawasaki, Japan
4 shared publications - Jingnan Li
Nagoya University, Nagoya, Japan
3 shared publications - Tong Ye
Fujitsu Research & Development Center Company Ltd., Beijing, China
3 shared publications - Ke Zhang
Fujitsu Research & Development Center Company Ltd., Beijing, China
2 shared publications
Latest Publications
- Open Access
- 26 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (20) , 9543-9550
Behavior Model and Nonlinear Distortion Characterization of PAM Optical DAC Transmitter
Optical digital-to-analog converter (DAC) transmitters exhibit great potential for saving power consumption and reducing footprint. However, the novel architecture of these optical transmitters introduces risks to signal performance due to inconsistencies in the responses among modulation segments. In this paper, a bit-dependent impulse model is proposed to characterize both the linear behavior and nonlinear distortions of N-bit pulse amplitude modulation (PAM) optical DAC transmitters. By applying minimum mean square error (MSE) criterion to the proposed model, the linear behavior, nonlinear noise spectrum, and nonlinear signal-to-noise ratio (SNR) are derived. Experiments on a Si-based PAM4 optical DAC transmitter, incorporating various impairments, demonstrate that the proposed model and distortion theory accurately characterize the linear response and nonlinear noise. Across all 48 investigated scenarios, the normalized mean square errors (NMSEs) between theoretical best linear approximations and measured values are below −17.5 dB. Nonlinear SNRs are also predicted with small errors of 0.65 dB across a 15 dB dynamic range. Furthermore, the proposed distortion theory provides a quantifiable criterion for bit-segment mapping, which can mitigate the nonlinearity of optical DAC transmitters.
- 26 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (20) , 9543-9550
Open AccessBehavior Model and Nonlinear Distortion Characterization of PAM Optical DAC Transmitter
Optical digital-to-analog converter (DAC) transmitters exhibit great potential for saving power consumption and reducing footprint. However, the novel architecture of these optical transmitters introduces risks to signal performance due to inconsistencies in the responses among modulation segments. In this paper, a bit-dependent impulse model is proposed to characterize both the linear behavior and nonlinear distortions of N-bit pulse amplitude modulation (PAM) optical DAC transmitters. By applying minimum mean square error (MSE) criterion to the proposed model, the linear behavior, nonlinear noise spectrum, and nonlinear signal-to-noise ratio (SNR) are derived. Experiments on a Si-based PAM4 optical DAC transmitter, incorporating various impairments, demonstrate that the proposed model and distortion theory accurately characterize the linear response and nonlinear noise. Across all 48 investigated scenarios, the normalized mean square errors (NMSEs) between theoretical best linear approximations and measured values are below −17.5 dB. Nonlinear SNRs are also predicted with small errors of 0.65 dB across a 15 dB dynamic range. Furthermore, the proposed distortion theory provides a quantifiable criterion for bit-segment mapping, which can mitigate the nonlinearity of optical DAC transmitters.
- Open Access
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (10) , 4722-4730
Deep-Depth Probability-Maintained Notch Enabling Nonlinear Distortion Measurement for Various Modulation Formats
Nonlinear distortion is critical for optical communication systems with a high baud rate and a high-order modulation format. Thus, a simple and accurate method to measure the nonlinear distortion is highly desired. Although simple notch, which directly removes the certain frequency components of nonlinear system input and then measures the regrowth components of nonlinear system output, is straightforward to measure nonlinear distortion, it is only applicable to the Gaussian signal. However, pulse amplitude modulation (PAM) and quadrature amplitude modulation (QAM), which are widely used in communication systems, are not Gaussian signals. In this study, we propose a deep-depth probability-maintained notch generation method for the PAM to accurately characterize the nonlinear distortion based on the signal spectrum measurement. Employing the proposed time order perturbation, the notch depth for PAM2/4/8 achieves 20/24/28 dB, which allows for a large dynamic range nonlinear distortion measurement for various modulation formats. The experiment demonstrates that the nonlinear noise power ratios are measured within a root mean square error of 0.6 dB for the uniform PAM2/4/8 as well as the probabilistic shaped PAM4/8. The proposed method is also applicable to square QAM formats because a square QAM is composed of two independent PAMs.
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (10) , 4722-4730
Open AccessDeep-Depth Probability-Maintained Notch Enabling Nonlinear Distortion Measurement for Various Modulation Formats
Nonlinear distortion is critical for optical communication systems with a high baud rate and a high-order modulation format. Thus, a simple and accurate method to measure the nonlinear distortion is highly desired. Although simple notch, which directly removes the certain frequency components of nonlinear system input and then measures the regrowth components of nonlinear system output, is straightforward to measure nonlinear distortion, it is only applicable to the Gaussian signal. However, pulse amplitude modulation (PAM) and quadrature amplitude modulation (QAM), which are widely used in communication systems, are not Gaussian signals. In this study, we propose a deep-depth probability-maintained notch generation method for the PAM to accurately characterize the nonlinear distortion based on the signal spectrum measurement. Employing the proposed time order perturbation, the notch depth for PAM2/4/8 achieves 20/24/28 dB, which allows for a large dynamic range nonlinear distortion measurement for various modulation formats. The experiment demonstrates that the nonlinear noise power ratios are measured within a root mean square error of 0.6 dB for the uniform PAM2/4/8 as well as the probabilistic shaped PAM4/8. The proposed method is also applicable to square QAM formats because a square QAM is composed of two independent PAMs.
- Open Access
- 1 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (10) , 3163-3172
Characterization, Measurement and Specification of Device Imperfections in Optical Coherent Transceivers
Transceiver imperfections become the primary source of impairment as baud rate and modulation order grow in advanced optical coherent communications. Thus, transceiver imperfections, both linear and nonlinear, need to be appropriately characterized, measured, and specified. Treatments for linear imperfections are relatively mature. This study reviews the transceivers linear imperfection modeling, characterization, and measurement technologies. In practical applications, in-field measurement using the transceiver and a few low speed additional devices is preferred. In the case of nonlinear imperfections, the situation is complex. One important task is to estimate the nonlinear system performance from the nonlinear characteristics of the devices. In this study, we attempt to establish a connection between them by examining different technologies. Although the orthogonal component has a good correlation with nonlinear system performance, its measurement is prohibitively complex. In the nonlinear noise to power ratio measurement, a certain frequency component of the input signal is notched, and the re-growth component at the notch frequency is measured at the nonlinear device output. The ratio between the re-growth component power and the output signal power is the noise to power ratio. While this method is easy to carry out, it does not correctly estimate nonlinear impairment in general. The reason for this is that the signal incurs different nonlinear responses in two conditions, i.e., with or without a notch. This method accurately estimates the nonlinear impairment in some special but useful cases, such as Gaussian input signals and nonlinear systems whose dominant nonlinear term is the even order term.
- 1 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (10) , 3163-3172
Open AccessCharacterization, Measurement and Specification of Device Imperfections in Optical Coherent Transceivers
Transceiver imperfections become the primary source of impairment as baud rate and modulation order grow in advanced optical coherent communications. Thus, transceiver imperfections, both linear and nonlinear, need to be appropriately characterized, measured, and specified. Treatments for linear imperfections are relatively mature. This study reviews the transceivers linear imperfection modeling, characterization, and measurement technologies. In practical applications, in-field measurement using the transceiver and a few low speed additional devices is preferred. In the case of nonlinear imperfections, the situation is complex. One important task is to estimate the nonlinear system performance from the nonlinear characteristics of the devices. In this study, we attempt to establish a connection between them by examining different technologies. Although the orthogonal component has a good correlation with nonlinear system performance, its measurement is prohibitively complex. In the nonlinear noise to power ratio measurement, a certain frequency component of the input signal is notched, and the re-growth component at the notch frequency is measured at the nonlinear device output. The ratio between the re-growth component power and the output signal power is the noise to power ratio. While this method is easy to carry out, it does not correctly estimate nonlinear impairment in general. The reason for this is that the signal incurs different nonlinear responses in two conditions, i.e., with or without a notch. This method accurately estimates the nonlinear impairment in some special but useful cases, such as Gaussian input signals and nonlinear systems whose dominant nonlinear term is the even order term.
- 1 January 2021
- Published by Optica Publishing Group
- p. Th5D.4
In-field Calibration of Phase Response of Optical Transmitter Using Built-in Monitor Photodiode
The in-field calibration of the phase response of high-capacity optical transmitters is proposed with the assistance of the narrow-band photodiode built in Mach-Zehnder modulator. The ±1° measurement error within signal bandwidth is experimentally demonstrated.
- 1 January 2021
- Published by Optica Publishing Group
- p. Th5D.4
In-field Calibration of Phase Response of Optical Transmitter Using Built-in Monitor Photodiode
The in-field calibration of the phase response of high-capacity optical transmitters is proposed with the assistance of the narrow-band photodiode built in Mach-Zehnder modulator. The ±1° measurement error within signal bandwidth is experimentally demonstrated.
- 1 January 2014
- Published by Optica Publishing Group
- Vol. 29, Th2A.8
A High Performance Nonlinear Compensation Algorithm with Reduced Complexity Based on XPM Model
A high performance nonlinear compensator is proposed based on XPM model. It achieves 1.7 dB Q improvement with 80% complexity reduction. It tolerates asynchronous process among multi-channels and the information interconnection speed far below baudrate.
- 1 January 2014
- Published by Optica Publishing Group
- Vol. 29, Th2A.8
A High Performance Nonlinear Compensation Algorithm with Reduced Complexity Based on XPM Model
A high performance nonlinear compensator is proposed based on XPM model. It achieves 1.7 dB Q improvement with 80% complexity reduction. It tolerates asynchronous process among multi-channels and the information interconnection speed far below baudrate.
- 7 March 2013
- Published by Elsevier in Materials Research Bulletin
- Vol. 48 (6) , 2370-2374
Luminescence properties of Li-codoped Lu2SiO5:Ce thin-film phosphors prepared by sol–gel processing
- 7 March 2013
- Published by Elsevier in Materials Research Bulletin
- Vol. 48 (6) , 2370-2374
Luminescence properties of Li-codoped Lu2SiO5:Ce thin-film phosphors prepared by sol–gel processing