A. P. Orlov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
A. P. Orlov has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- B. G. Repin
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
2 shared publications - A. A. Agapov
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
1 shared publication - Alexey Filippov
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
1 shared publication - D. S. Pokrovskiy
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
1 shared publication - I. M. Markevtsev
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
1 shared publication - M. D. Baryshnikov
Russian Federal Nuclear Center - All-Russian Research Institute of Experimental Physics (RFNC-VNIIEF) , 607188 Sarov
1 shared publication
Latest Publications
- 1 September 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (9)
Generation of aluminum K -line in devices based on explosive magnetic generator
For several years, RFNC-VNIIEF has been conducting research on the generation of powerful soft x-ray (SXR) pulses during the stagnation of multi-wire cylindrical array systems powered by microsecond current pulses from both explosive and stationary current sources. In recent experiments generating the aluminum K-line using a helical explosive magnetic generator (EMG) with a 200 mm helix diameter, equipped with an explosive opening switch, the SXR pulse energy in the full spectrum reaches 70.4 kJ, and in the quantum energy range above 1 keV, it reaches 25.7 kJ, which is approximately 36% of the total radiation energy. The current pulse amplitude in the load is ∼5 MA, and the implosion time is ∼0.75–1 μs. The realized efficiency of the radiation generation with quantum energy above 1 keV is comparable with the best results obtained in the world's pulsed power installations with aluminum multi-wire loads. This paper presents the main results of the experimental studies conducted, as well as scaling calculations using the radiation magneto-hydrodynamic FLUX-rz and FLUX-3D codes to optimize the aluminum K-line generation for various load configurations powered by the helical EMG.
- 1 September 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (9)
Generation of aluminum K -line in devices based on explosive magnetic generator
For several years, RFNC-VNIIEF has been conducting research on the generation of powerful soft x-ray (SXR) pulses during the stagnation of multi-wire cylindrical array systems powered by microsecond current pulses from both explosive and stationary current sources. In recent experiments generating the aluminum K-line using a helical explosive magnetic generator (EMG) with a 200 mm helix diameter, equipped with an explosive opening switch, the SXR pulse energy in the full spectrum reaches 70.4 kJ, and in the quantum energy range above 1 keV, it reaches 25.7 kJ, which is approximately 36% of the total radiation energy. The current pulse amplitude in the load is ∼5 MA, and the implosion time is ∼0.75–1 μs. The realized efficiency of the radiation generation with quantum energy above 1 keV is comparable with the best results obtained in the world's pulsed power installations with aluminum multi-wire loads. This paper presents the main results of the experimental studies conducted, as well as scaling calculations using the radiation magneto-hydrodynamic FLUX-rz and FLUX-3D codes to optimize the aluminum K-line generation for various load configurations powered by the helical EMG.
- 1 May 2022
- Published by AIP Publishing in Physics of Plasmas
- Vol. 29 (5)
Generalized computational ablation model of multi-wire cylindrical Z-pinches
The generalized computational ablation model of multi-wire Z-pinches is developed. Using derived equations, one can calculate at each moment of time both the mass ablation rate from single and nested cylindrical wire arrays as well as the matter ablation velocity. These two important variables provide the capability to numerically simulate high energy density Z-pinch experiments in a wide range of load parameters: the initial multi-wire array radius up to tens of centimeters, the inter-wire gap up to a few millimeters, the Z-pinch implosion time up to a few microseconds, and the current amplitude in a load up to tens of mega-amperes. The generalized ablation model makes it possible to reproduce the main characteristics of the Z-pinch implosion, such as the moment of starting and following movement trajectory of current-plasma sheath, timing of x-ray pulse generation, its duration, x-ray power, and total radiation energy, in radiative magneto-hydrodynamic calculations. The generalized computational ablation model of tungsten multi-wire Z-pinch was validated using results of experiments with explosive magneto-cumulative generators (Russia) and was applied further to various pulsed power generators such as Z-accelerator, PTS, MAGPIE, and Angara-5-1.
- 1 May 2022
- Published by AIP Publishing in Physics of Plasmas
- Vol. 29 (5)
Generalized computational ablation model of multi-wire cylindrical Z-pinches
The generalized computational ablation model of multi-wire Z-pinches is developed. Using derived equations, one can calculate at each moment of time both the mass ablation rate from single and nested cylindrical wire arrays as well as the matter ablation velocity. These two important variables provide the capability to numerically simulate high energy density Z-pinch experiments in a wide range of load parameters: the initial multi-wire array radius up to tens of centimeters, the inter-wire gap up to a few millimeters, the Z-pinch implosion time up to a few microseconds, and the current amplitude in a load up to tens of mega-amperes. The generalized ablation model makes it possible to reproduce the main characteristics of the Z-pinch implosion, such as the moment of starting and following movement trajectory of current-plasma sheath, timing of x-ray pulse generation, its duration, x-ray power, and total radiation energy, in radiative magneto-hydrodynamic calculations. The generalized computational ablation model of tungsten multi-wire Z-pinch was validated using results of experiments with explosive magneto-cumulative generators (Russia) and was applied further to various pulsed power generators such as Z-accelerator, PTS, MAGPIE, and Angara-5-1.