Mariaconcetta Pierro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mariaconcetta Pierro has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Eugenio Meloni
Department of Industrial Engineering, University of Salerno, via Giovanni Paolo II 132, 84084 Fisciano, SA, Italy
2 shared publications - Marco Martino
Hydrogen and New Vectors Laboratory (TERIN-DEC-H2V), Energy Technology and Renewable Sources Department, ENEA Portici Research Center, Piazzale Enrico Fermi, 1, Località Granatello, 80055 Portici, Italy
2 shared publications - Vincenzo Palma
Department of Industrial Engineering, University of Salerno, Via Giovanni Paolo II 132, 84084 Fisciano, Italy
2 shared publications - Federico Brandani
Air Liquide, Paris Innovation Campus. 1, chemin de la Porte des Loges, 78350 Les Loges en Josas, France
1 shared publication - Liberato Cafiero
Department of Industrial Engineering, University of Salerno, via Giovanni Paolo II 132, 84084 Fisciano, SA, Italy
1 shared publication - Pluton Pullumbi
Air Liquide, Paris Innovation Campus. 1, chemin de la Porte des Loges, 78350 Les Loges en Josas, France
1 shared publication
Latest Publications
- Open Access
Ru- and Rh-Based Catalysts for CO2 Methanation Assisted by Non-Thermal Plasma
The need to reduce the concentration of CO2 in the atmosphere is becoming increasingly necessary since it is considered the main factor responsible for climate change. Carbon Capture and Utilization (CCU) technology offers the opportunity to obtain a wide range of chemicals using this molecule as a raw material. In this work, the catalytic Non-Thermal Plasma (NTP)-assisted hydrogenation of CO2 to CH4 (methanation reaction) in a Dielectric Barrier Discharge (DBD) reactor was investigated. Four different Ru- and Rh-based catalysts were prepared starting from γ-Al2O3 spheres, characterized and tested in both thermal and NTP-assisted methanation under different operating conditions. The experimental tests evidenced the very positive effect of the NTP application on the catalytic performance, highlighting that for all the catalysts the same CO2 conversion was reached at a temperature 150 °C lower with respect to the conventional thermal reaction. Among the prepared catalysts, the bimetallic ones showed the best performance, reaching a CO2 conversion of 97% at about 180 °C with a lower energy consumption with respect to similar catalysts present in the literature.
Open AccessRu- and Rh-Based Catalysts for CO2 Methanation Assisted by Non-Thermal Plasma
The need to reduce the concentration of CO2 in the atmosphere is becoming increasingly necessary since it is considered the main factor responsible for climate change. Carbon Capture and Utilization (CCU) technology offers the opportunity to obtain a wide range of chemicals using this molecule as a raw material. In this work, the catalytic Non-Thermal Plasma (NTP)-assisted hydrogenation of CO2 to CH4 (methanation reaction) in a Dielectric Barrier Discharge (DBD) reactor was investigated. Four different Ru- and Rh-based catalysts were prepared starting from γ-Al2O3 spheres, characterized and tested in both thermal and NTP-assisted methanation under different operating conditions. The experimental tests evidenced the very positive effect of the NTP application on the catalytic performance, highlighting that for all the catalysts the same CO2 conversion was reached at a temperature 150 °C lower with respect to the conventional thermal reaction. Among the prepared catalysts, the bimetallic ones showed the best performance, reaching a CO2 conversion of 97% at about 180 °C with a lower energy consumption with respect to similar catalysts present in the literature.
- Open Access
MW-Assisted Regeneration of 13X Zeolites after N2O Adsorption from Concentrated Streams: A Process Intensification
N2O has a global warming potential about 300 times higher than CO2, and even if its contribution to the greenhouse effect is underrated, its abatement in industrial production’s tail gas has become imperative. In this work, we investigate the feasibility of the microwave (MW)-assisted regeneration of a 13X zeolite bed for N2O capture from tail gases. Several consecutive adsorption–desorption cycles were performed to verify the microwave heating effect on the zeolite’s adsorption properties. The results of the experimental tests, performed at N2O concentrations of 10, 20 and 40% vol, highlighted that (i) the steps are perfectly repeatable in terms of both adsorbed and desorbed amount of N2O, meaning that the MWs did not damage the zeolite’s structure, (ii) the presence of both H2O and O2 in the feed stream irreversibly reduces the adsorbent capacity due to nitrites and nitrates formation, and (iii) the presence of H2O alone with N2O still reduces the adsorbent capacity of the zeolites, which can be recovered through MW-assisted regeneration at 350 °C. Moreover, the MW-assisted TSA assured an energy and purge gas saving up to 63% and 82.5%, respectively, compared to a traditional regeneration process, resulting in effective process intensification.
Open AccessMW-Assisted Regeneration of 13X Zeolites after N2O Adsorption from Concentrated Streams: A Process Intensification
N2O has a global warming potential about 300 times higher than CO2, and even if its contribution to the greenhouse effect is underrated, its abatement in industrial production’s tail gas has become imperative. In this work, we investigate the feasibility of the microwave (MW)-assisted regeneration of a 13X zeolite bed for N2O capture from tail gases. Several consecutive adsorption–desorption cycles were performed to verify the microwave heating effect on the zeolite’s adsorption properties. The results of the experimental tests, performed at N2O concentrations of 10, 20 and 40% vol, highlighted that (i) the steps are perfectly repeatable in terms of both adsorbed and desorbed amount of N2O, meaning that the MWs did not damage the zeolite’s structure, (ii) the presence of both H2O and O2 in the feed stream irreversibly reduces the adsorbent capacity due to nitrites and nitrates formation, and (iii) the presence of H2O alone with N2O still reduces the adsorbent capacity of the zeolites, which can be recovered through MW-assisted regeneration at 350 °C. Moreover, the MW-assisted TSA assured an energy and purge gas saving up to 63% and 82.5%, respectively, compared to a traditional regeneration process, resulting in effective process intensification.