Neha S. Baghele
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Neha S. Baghele has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Anjali K. Khambete
Department of Civil Engineering, S. V. National Institute of Technology, Surat, Gujarat, India
1 shared publication- Anjali K. Khambete
Faculty of Civil Engineering Department, S. V. National Institute of Technology, Surat, India
1 shared publication Robin A. Christian
Department of Civil Engineering, S. V. National Institute of Technology, Surat, Gujarat, India
1 shared publication- Robin A. Christian
Sardar Vallabhbhai National Institute of Technology
1 shared publication
Latest Publications
- 6 October 2022
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 44 (4) , 9310-9324
Significance of hydrodynamic cavitation to enhance reuse of secondary sedimentation tank effluent: a geometrical assessment
Adequate wastewater management is an environmental concern because of the lack of freshwater resources, which brings about the quick augmentation of technologies for complete quantitative and qualitative wastewater recovery. In the cluster of the advanced oxidation process, hydrodynamic cavitation developed as a promising technology to treat wastewater, in the last couple of decades, due to its low-cost energy efficiency without aided and residual chemicals. In the present study, two pilot-scale experimental setups (I and II) of hydrodynamic cavitation reactor have been used to treat the secondary sedimentation tank (SST) effluent of natural six sewage treatment plant (STP) of Surat city for irrigational reuse, using an orifice as a cavitating device. At inception, the inlet pressure has been optimized, which follows the first-order kinetic rate constant. The pump power with respect to the diameter of the main pipeline has differentiated by keeping the constant dimension of the cavitating device to compare the geometrical effect and was analyzed using the number of rotations concerning recirculation time to degrade the chemical oxygen demand (COD). It is found that the maximum COD, total suspended solids (TSS), and most probable number (MPN) were degraded to 79.8%, 63.8%, and 99.5%, respectively, by setup II; also, descent within the permissible limit proclaimed by CPHEEO India to irrigate the non-edible crops.
- 6 October 2022
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 44 (4) , 9310-9324
Significance of hydrodynamic cavitation to enhance reuse of secondary sedimentation tank effluent: a geometrical assessment
Adequate wastewater management is an environmental concern because of the lack of freshwater resources, which brings about the quick augmentation of technologies for complete quantitative and qualitative wastewater recovery. In the cluster of the advanced oxidation process, hydrodynamic cavitation developed as a promising technology to treat wastewater, in the last couple of decades, due to its low-cost energy efficiency without aided and residual chemicals. In the present study, two pilot-scale experimental setups (I and II) of hydrodynamic cavitation reactor have been used to treat the secondary sedimentation tank (SST) effluent of natural six sewage treatment plant (STP) of Surat city for irrigational reuse, using an orifice as a cavitating device. At inception, the inlet pressure has been optimized, which follows the first-order kinetic rate constant. The pump power with respect to the diameter of the main pipeline has differentiated by keeping the constant dimension of the cavitating device to compare the geometrical effect and was analyzed using the number of rotations concerning recirculation time to degrade the chemical oxygen demand (COD). It is found that the maximum COD, total suspended solids (TSS), and most probable number (MPN) were degraded to 79.8%, 63.8%, and 99.5%, respectively, by setup II; also, descent within the permissible limit proclaimed by CPHEEO India to irrigate the non-edible crops.
- 16 June 2022
- Published by Taylor & Francis in Environmental Technology
- Vol. 44 (27) , 4238-4247
Application of effective orifice jet length for treating SST effluent of STP by hydrodynamic cavitation
Advanced oxidation process in general and hydrodynamic cavitation, in particular, has emerged as a promising technology for the treatment of wastewater in the last few years as the process is energy-efficient and cost-effective. In this process, cavities are generated due to local pressure drops caused by constrictions. This work aimed to investigate the potential of hydrodynamic cavitation as a tertiary treatment to the secondary sedimentation tank effluent of a sewage treatment plant, with two laboratory-scale experimental setups having an orifice plate of a 1 mm diameter hole. The process dependency was estimated by optimizing inlet pressure (0.8 bar for setup I and 5 bar for setup II). Moreover, effective orifice jet length was varied to investigate the impact of fluid buoyancy force on expansion and collapse of a cavity on the chemical oxygen demand removal and disinfection. At L2 length (two-thirds of the original length), both setups can degrade the organic and inorganic pollutants to the maximum extent. With the optimum condition in setup II, maximum COD, TSS, and fecal coliform degradation were 80.47%, 62.83%, and 52.27%, respectively, compared to setup I. GRAPHICAL ABSTRACT
- 16 June 2022
- Published by Taylor & Francis in Environmental Technology
- Vol. 44 (27) , 4238-4247
Application of effective orifice jet length for treating SST effluent of STP by hydrodynamic cavitation
Advanced oxidation process in general and hydrodynamic cavitation, in particular, has emerged as a promising technology for the treatment of wastewater in the last few years as the process is energy-efficient and cost-effective. In this process, cavities are generated due to local pressure drops caused by constrictions. This work aimed to investigate the potential of hydrodynamic cavitation as a tertiary treatment to the secondary sedimentation tank effluent of a sewage treatment plant, with two laboratory-scale experimental setups having an orifice plate of a 1 mm diameter hole. The process dependency was estimated by optimizing inlet pressure (0.8 bar for setup I and 5 bar for setup II). Moreover, effective orifice jet length was varied to investigate the impact of fluid buoyancy force on expansion and collapse of a cavity on the chemical oxygen demand removal and disinfection. At L2 length (two-thirds of the original length), both setups can degrade the organic and inorganic pollutants to the maximum extent. With the optimum condition in setup II, maximum COD, TSS, and fecal coliform degradation were 80.47%, 62.83%, and 52.27%, respectively, compared to setup I. GRAPHICAL ABSTRACT