SCSiwen Chen

Siwen Chen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Siwen Chen has a total of 18 co-authors. Here are the top co-authors by number of shared publications:

  • Da Xu

    Changchun Univ Sci & Technol, Sch Optoelect Engn, Changchun 130022, Jilin, Peoples R China

    2 shared publications
  • Gaofei Sun

    Key Laboratory of Opto-electronic Measurement and Optical Information Transmission Technology, Ministry of Education, Department of Instrumentation Science and Technology, Changchun University of Science and Technology, Changchun, China

    2 shared publications
  • Gaofei Sun

    Jilin Province Engineering Research Center

    2 shared publications
  • Jiali Chen

    Key Laboratory of Opto-electronic Measurement and Optical Information Transmission Technology, Ministry of Education, Department of Instrumentation Science and Technology, Changchun University of Science and Technology, Changchun, China

    2 shared publications
  • Jianhua Yang

    2 shared publications
  • Jierui Zhang

    2 shared publications

Latest Publications

  • Research on methods for improving irradiance uniformity based on the analysis of the energy transmission characteristics of solar simulator

    by Jianhua Yang, Shi Liu, Jierui Zhang, Siwen Chen, Yutian Peng, Yao Meng, Da Xu, Ran Zhang, Gaofei Sun

    Aiming at the issue that the irradiance uniformity of the existing solar simulator is difficult to enhance further, based on the theories of geometrical and matrix optics, the characteristics of energy transmission in the optical system of the solar simulator were analyzed. The influence of the optical axis offsets of each subsystem on the irradiance non-uniformity was studied by using LightTools. Based on the analysis and research of the energy transmission characteristics, a method for optical axis calibration was proposed. The total optical axis offset was fitted by the least squares method to obtain the curve of irradiance non-uniformity change. Finally, a calibration experiment of the optical axis was established to verify and test the irradiance distribution and calculate the irradiance non-uniformity. The results show that compared with the traditional self-collimation-based solar simulator optical axis calibration method, the irradiance non-uniformity within 100 mm × 100 mm of the square facula is 0.86%, and the irradiance uniformity of the solar simulator has been further improved.

  • Research on multi-optical axis online compensation alignment method for space environment simulation system

    by Jierui Zhang, Shi Liu, Yutian Peng, Siwen Chen, Jianhua Yang, Xinhui Zhao, Yao Meng, Da Xu, Gaofei Sun, Ran Zhang

    Aiming at the problem that the error of multi-optical axis alignment is difficult to control in the simulation calibration test, a multi-optical axis dynamic compensation alignment method for the space environment simulation system is proposed. The effect of optical axis disturbance on the signal detection link was analyzed to obtain the alignment accuracy requirements, the optical axis alignment error compensation mechanism was established, the target simulation system with long pupil distance was designed, the alignment error transfer model based on topology structure was constructed, and the test prototype was built. The test results show that the static attitude alignment resolution is better than 3" and the position alignment resolution is better than 11µm. After online compensation, the position error is better than 11.04µm, and the energy error is better than 3.2%, which realizes the online monitoring and compensation of the optical axis alignment error of the ground space environment simulation system.

  • Open Access

    Design of Integrating Sphere Uniform Light System for Solar Simulator

    by Jiali Chen, Gaofei Sun, Shi Liu, Guoyu Zhang, Siwen Chen, Jierui Zhang, Qiang Liu

    In the process of designing and adjusting the solar simulator, the side lobe effect and aberration of the optical integrator affect the irradiation uniformity, an integrating sphere is proposed to replace the optical integrator for uniform light and the compound parabolic reflector for beam shaping. First, based on the equal illuminance theorem and the radiation transfer theory, the calculation formula of the energy transmission efficiency of the porous integrating sphere is derived; Then, the light hole illuminance interference factor is introduced, and the effects of the aperture size of the integrating sphere, the radius of the integrating sphere, and the size and position of the baffle on the energy transmission efficiency and irradiation uniformity are analyzed. Finally, an integrating sphere uniform light system with high energy transmission efficiency and uniformity is designed and simulated with LightTools software. The simulation results show that: the average difference of irradiation uniformity and the range difference of irradiation uniformity are closest to 1 in the area where the ratio of the opening size and radius of the integrating sphere is 36% - 40%, and the light is evenly distributed; When the baffle position is 0.8 times of integrating sphere radius away from the light entrance hole, irradiation non-uniformity at the outlet hole is 1.99%, which is the best position of the baffle; In the effective irradiation surface of Φ1032mm, the irradiation non-uniformity is 1.98%, and the maximum irradiance is 0.62 solar constants, the spot simulation with high irradiation uniformity on large irradiation surface is realized.


  • Identification of Cogging Force in Ironed Linear Motor Based on RBF Neural Networks using Hybrid Self-Adaptive TLBO

    by Siwen Chen, Yang Liu, Fazhi Song

    The cogging force is an intrinsic characteristic of linear motor, which is caused by the structure of linear motor. As a crucial disturbance, the cogging force seriously impairs the positioning accuracy of linear motor. The existing compensation approaches are hardly implemented or have a low accuracy in practice, due to the inaccurate model of the cogging force. In this paper, the identification problem of the cogging force of the linear motor is investigated. To compensate the unknown nonlinearity, the RBF neural network is utilized for fitting. Moreover, to overcome the local optimal solutions involved with the traditional TLBO method, a hybrid self-adaptive TLBO algorithm is adopted to train the neural network. Finally, experimental results confirm the effectiveness and advantage of the proposed method.

  • Open Access

    Optical Design of a Solar Simulator With Large Irradiation Surface and High Irradiation Uniformity

    by Shi Liu, Gaofei Sun, Guoyu Zhang, Siwen Chen, Jiali Chen, Jierui Zhang

    Aiming at the problem of low irradiation uniformity in existing solar simulators with large irradiation surface, a new optical design method of off-axis TMA (three-mirror anastigmat) solar simulators with large irradiation surface high uniformity was proposed. Three groups of short arc xenon lamps and non-coaxial ellipsoid mirror are used as composite light sources, the causes of stray light in optical integrator are clarified, and the optimization design method of integrator based on anti-crosstalk diaphragm is proposed. The light propagation matrix model of the optical system of the solar simulator is established to effectively suppress stray light in the integrator, and the influence of the aberration of the collimating system on the irradiation uniformity was analyzed. A optical system of object side telecentric off-axis TMA was designed to achieve high uniform illumination with large irradiation area. The results show that in the Φ500mm irradiation surface, the irradiance of the system is better than 1S0 (1367 w/m2), up to 1656 w/m2, irradiation uniformity is 98.29%, this research can provide accurate and reliable solar radiation for space environment experiment of satellite load and make up for the limitation of low irradiation uniformity of traditional solar simulators with large irradiation surface.