Yasunari Tanaka
Research Subjects
Yasunari Tanaka has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Hirotaka Nakamura
NTT Device Innovation Center, NTT Corporation, Atsugi, Japan
3 shared publications- Jun-Ichi Kani
NTT, Inc
3 shared publications - Kazutaka Hara
NTT Access Network Service Systems Laboratories, NTT Corporation, Yokosuka-shi, Kanagawa, Japan
3 shared publications - Tomoaki Yoshida
NTT Corporation
3 shared publications Kimikazu Sano
NTT Device Innovation Center, NTT Corporation, Atsugi, Japan
2 shared publications- Takahiko Shindo
NTT Device Innovation Center, Nippon Telegraph and Telephone Corporation, Atsugi, Kanagawa, Japan
2 shared publications
Latest Publications
- 11 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (19) , 9137-9147
Fiber Parameter-Independent Zero-Dispersion Wavelength Estimation Method and Its Feasibility With Reduced Quantization Bits and Sampling Rates
We propose a method for estimating the zero-dispersion wavelength (ZDW) of an optical fiber independently of fiber parameters and for tuning the emission wavelength for the ZDW to suppress waveform distortion in high-speed intensity modulation and direct detection (IM-DD) systems. By using two emission wavelengths and unique notch frequencies caused by chromatic dispersion (CD) calculated from the frequency spectra (FSs) of each received signal, the proposed method can estimate the ZDW independent of fiber parameters such as fiber length and dispersion slope. The ZDW can be estimated by using the emission wavelength on either the shorter-wavelength side or the longer-wavelength side of the ZDW. To evaluate the feasibility of the method, we estimate the ZDW of 60-km fiber using 50-Gbps pseudorandom binary sequence 211−1 PAM4 signals at 1300-nm and 1305-nm emission wavelengths. The obtained estimation accuracy of −0.78 nm is sufficiently good when using an 8-bit analogue-to-digital converter operating at a sampling rate of 200 GS/s. We also demonstrate that results similar to the estimated ZDW are obtained even when the number of quantization bits is reduced from 8 to 4 and the sampling rate is reduced from 200 to 50 GS/s. These results show that the functions of the proposed method can be implemented in optical transceivers. On the basis of this configuration, we also achieve penalty-free and equalizer-free transmission by using an emission wavelength tuned to the estimated ZDW. Furthermore, we discuss the challenges associated with implementing the method in practical applications. We show that the BtB FSs required for estimating the ZDW can be replaced with simulated data instead of experimental data, that the method can be applied even at the minimum receiver sensitivity, and that there is no CD penalty when the notch frequency does not appear below the baud rate. Finally, we modify the procedure of the method to be applicable when the notch frequency does not appear within the value of the baud rate. Since this method can suppress waveform distortion due to CD independently of baud rate, it is applicable to higher speed transmission systems with a larger capacity of 100 Gbps or more.
- 11 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (19) , 9137-9147
Fiber Parameter-Independent Zero-Dispersion Wavelength Estimation Method and Its Feasibility With Reduced Quantization Bits and Sampling Rates
We propose a method for estimating the zero-dispersion wavelength (ZDW) of an optical fiber independently of fiber parameters and for tuning the emission wavelength for the ZDW to suppress waveform distortion in high-speed intensity modulation and direct detection (IM-DD) systems. By using two emission wavelengths and unique notch frequencies caused by chromatic dispersion (CD) calculated from the frequency spectra (FSs) of each received signal, the proposed method can estimate the ZDW independent of fiber parameters such as fiber length and dispersion slope. The ZDW can be estimated by using the emission wavelength on either the shorter-wavelength side or the longer-wavelength side of the ZDW. To evaluate the feasibility of the method, we estimate the ZDW of 60-km fiber using 50-Gbps pseudorandom binary sequence 211−1 PAM4 signals at 1300-nm and 1305-nm emission wavelengths. The obtained estimation accuracy of −0.78 nm is sufficiently good when using an 8-bit analogue-to-digital converter operating at a sampling rate of 200 GS/s. We also demonstrate that results similar to the estimated ZDW are obtained even when the number of quantization bits is reduced from 8 to 4 and the sampling rate is reduced from 200 to 50 GS/s. These results show that the functions of the proposed method can be implemented in optical transceivers. On the basis of this configuration, we also achieve penalty-free and equalizer-free transmission by using an emission wavelength tuned to the estimated ZDW. Furthermore, we discuss the challenges associated with implementing the method in practical applications. We show that the BtB FSs required for estimating the ZDW can be replaced with simulated data instead of experimental data, that the method can be applied even at the minimum receiver sensitivity, and that there is no CD penalty when the notch frequency does not appear below the baud rate. Finally, we modify the procedure of the method to be applicable when the notch frequency does not appear within the value of the baud rate. Since this method can suppress waveform distortion due to CD independently of baud rate, it is applicable to higher speed transmission systems with a larger capacity of 100 Gbps or more.
- 30 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (6) , 1844-1852
Zero-Dispersion Wavelength Estimation and Optimization Method for Penalty-Free and Equalizer-Free 53-Gbps/λ IM-DD Transmission Over 100 Km
We propose the method to estimate the zero-dispersion wavelength (ZDW) and to optimize the emission wavelength for high-speed intensity modulation and direct detection (IM-DD) transmission. The feature of this method can estimate the ZDW by using the unique notch frequency caused by chromatic dispersion from the frequency spectrum of the received signal, and reduce chromatic dispersion by tuning the emission wavelength to the estimation value of the ZDW in a configuration that using only general transmitters/receivers without additional dedicated equipment. With the proposed method, the limitation of transmission distance can be relaxed in high-speed IM-DD transmission without using a dispersion compensation device or an equalizer. We experimentally demonstrated that the notch frequency was observed at a condition of the pseudorandom binary sequence (PRBS) 2 15 -1 and 2 31 -1 non-return-to-zero (NRZ) signals at 53.125 Gbps for a total 80 and 100 km, and the ZDW was estimated with fast Fourier transformation sizes of 256, 512, and 1024. The results indicated that the proposed method can be estimated with an accuracy of about ±1 nm from the true value of the ZDW. In addition, to confirm the feasibility of the proposed method, we experimentally demonstrated that PRBS 2 15 -1 and 2 31 -1 NRZ signals at 53.125 Gbps were transmitted over 100 km by tuning the emission wavelength to the estimated ZDW value. For the ZDW with a true value of 1312.20 nm, the chromatic dispersion penalty was up to 1.5 dB under the conditions of a 53.125 Gbps NRZ signal with an emission wavelength of 1303.73 nm and a transmission distance of 100 km. Penalty-free and equalizer-free transmission was demonstrated by applying this method.
- 30 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (6) , 1844-1852
Zero-Dispersion Wavelength Estimation and Optimization Method for Penalty-Free and Equalizer-Free 53-Gbps/λ IM-DD Transmission Over 100 Km
We propose the method to estimate the zero-dispersion wavelength (ZDW) and to optimize the emission wavelength for high-speed intensity modulation and direct detection (IM-DD) transmission. The feature of this method can estimate the ZDW by using the unique notch frequency caused by chromatic dispersion from the frequency spectrum of the received signal, and reduce chromatic dispersion by tuning the emission wavelength to the estimation value of the ZDW in a configuration that using only general transmitters/receivers without additional dedicated equipment. With the proposed method, the limitation of transmission distance can be relaxed in high-speed IM-DD transmission without using a dispersion compensation device or an equalizer. We experimentally demonstrated that the notch frequency was observed at a condition of the pseudorandom binary sequence (PRBS) 2 15 -1 and 2 31 -1 non-return-to-zero (NRZ) signals at 53.125 Gbps for a total 80 and 100 km, and the ZDW was estimated with fast Fourier transformation sizes of 256, 512, and 1024. The results indicated that the proposed method can be estimated with an accuracy of about ±1 nm from the true value of the ZDW. In addition, to confirm the feasibility of the proposed method, we experimentally demonstrated that PRBS 2 15 -1 and 2 31 -1 NRZ signals at 53.125 Gbps were transmitted over 100 km by tuning the emission wavelength to the estimated ZDW value. For the ZDW with a true value of 1312.20 nm, the chromatic dispersion penalty was up to 1.5 dB under the conditions of a 53.125 Gbps NRZ signal with an emission wavelength of 1303.73 nm and a transmission distance of 100 km. Penalty-free and equalizer-free transmission was demonstrated by applying this method.
- 30 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (17) , 5783-5792
Extraction of AMCC Signal Superposed by SOA-Integrated EA-DFB Laser for In-Service Monitoring in All-Photonics Network
We propose an in-line monitoring method that enables fully passive extraction of the control signal for end-to-end optical direct connection on the All-Photonics Network (APN), which is one of the elements of the Innovative Optical and Wireless Network (IOWN). In our approach, the auxiliary management and control channel (AMCC) signal superposed on the client signal as the control signal is extracted by a fully passive configuration without any optical to electrical conversion. By installing the proposed configuration in the Photonic Gateway (Ph-GW), which is an edge optical node of the APN located at the boundary between the access network and the local full-mesh network, the AMCC signal can be extracted in the middle of a route even when the users are communicating via direct optical connection. The proposed configuration enables in-service user terminal monitoring for end-to-end optical direct connection, which is the core concept of the APN. We conducted transmission experiments on the area management of cyber physical system (CPS) in which we assumed that an intensity modulation-direct detection (IM-DD) system with low power consumption and economy is used. We then determined the target transmission distance and bandwidth and conducted 60-km optical transmission in the local full-mesh network. The results demonstrated that a loss budget of 36 dB for the client signal was achieved. We also investigated extending the transmission distance of the client signal by adjusting the branch ratio of the passive extractor so that the optical power of the AMCC signal reached the minimum receiver sensitivity. As a result, we were able to extend the transmission distance to 80 km.
- 30 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (17) , 5783-5792
Extraction of AMCC Signal Superposed by SOA-Integrated EA-DFB Laser for In-Service Monitoring in All-Photonics Network
We propose an in-line monitoring method that enables fully passive extraction of the control signal for end-to-end optical direct connection on the All-Photonics Network (APN), which is one of the elements of the Innovative Optical and Wireless Network (IOWN). In our approach, the auxiliary management and control channel (AMCC) signal superposed on the client signal as the control signal is extracted by a fully passive configuration without any optical to electrical conversion. By installing the proposed configuration in the Photonic Gateway (Ph-GW), which is an edge optical node of the APN located at the boundary between the access network and the local full-mesh network, the AMCC signal can be extracted in the middle of a route even when the users are communicating via direct optical connection. The proposed configuration enables in-service user terminal monitoring for end-to-end optical direct connection, which is the core concept of the APN. We conducted transmission experiments on the area management of cyber physical system (CPS) in which we assumed that an intensity modulation-direct detection (IM-DD) system with low power consumption and economy is used. We then determined the target transmission distance and bandwidth and conducted 60-km optical transmission in the local full-mesh network. The results demonstrated that a loss budget of 36 dB for the client signal was achieved. We also investigated extending the transmission distance of the client signal by adjusting the branch ratio of the passive extractor so that the optical power of the AMCC signal reached the minimum receiver sensitivity. As a result, we were able to extend the transmission distance to 80 km.
- 1 January 2021
- Published by Optica Publishing Group
- p. M4A.7
High-power-budget End-to-end Optical Connection with AMCC Superposition of SOA-integrated EA-DFB Transmitter in All-Photonics Network
We experimentally evaluate the transmission characteristics of AMCC superposition with an SOA-integrated EA-DFB transmitter for the All-Photonics Network. The results demonstrate that direct optical connections with the power budget of 34.6 dB are achievable.
- 1 January 2021
- Published by Optica Publishing Group
- p. M4A.7
High-power-budget End-to-end Optical Connection with AMCC Superposition of SOA-integrated EA-DFB Transmitter in All-Photonics Network
We experimentally evaluate the transmission characteristics of AMCC superposition with an SOA-integrated EA-DFB transmitter for the All-Photonics Network. The results demonstrate that direct optical connections with the power budget of 34.6 dB are achievable.