SHSeyed Mohsen Hosseini-Golgoo

Seyed Mohsen Hosseini-Golgoo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Seyed Mohsen Hosseini-Golgoo has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Gas Sensing Measurements of a Novel NO₂ Sensor Using K₂CO₃/Al₂O₃ Composite Pellets From Resistive Aspect

    by Seyed Mohsen Hosseini-Golgoo, Majid Davtalab-Ghazimahalleh

    K 2 CO 3 /Al 2 O 3 composite pellets connected to gold contacts were employed as resistive NO 2 sensor. Gas sensing experiments showed that this structure has an acceptable response to NO 2 at room temperature and its response increases drastically as the operating temperature decreases. It was found that highest gas-solid interactions occurred at T =10°C with sensor response of 44 in the presence of 900 ppb NO 2 . Evaluations of the response and recovery times of the sensor suggested that these parameters also significantly improved when sensor operates at room temperature. Typically, the response and recovery times to 900 ppb NO 2 at room temperature (25°C) were 65 s and 473 s, respectively. NO 2 detection limit is estimated to be 4 ppb at room temperature and 2 ppb at 10oC. The linearity of the calibration curve in the NO 2 concentration range between 40-1500 ppb combined with good selectivity, especially among alcoholic gases, makes this structure a good sub-ppm selective NO 2 sensor at room temperature and cold body state.


  • Black tea quality determination using a generic resistive gas sensor

    by S M Hosseini-Golgoo, M Saeedi-Mirakmahaleh, H Saberi

    In this study, we present an analysis on the dynamic fermentation profile of a generic resistive gas sensor to optimize the process of turning green leaves into black tea and determine the quality of manufactured black tea, which are two crucial issues in the tea industry. The leaves were plucked from Lahijan and Rudsar, two important cultivation areas in Iran, in spring, summer and autumn. The results showed that the tea leaves optimum fermentation time (OFT) coincides with the second highest peak in the sensor’s dynamic fermentation profile. For example, various experiments showed that the second peak in the sensor’s dynamic response for the Lahijan summer tea samples, which had experienced optimal manufacturing stages, occurs in 117 ± 2 min. Also, tea tasters announced the OFT of 120 min for these samples by carefully examining five traits of the manufactured black tea. It was observed that the occurrence of this second peak is prolonged and even disappears as the quality of black tea decreases. To find the final black tea quality, we introduce a coordinate plane whose axes are determined based on the amplitude of the first peak and the occurrence of the second peak in the sensor’s dynamic fermentation profile. In this method, the characteristics of an optimal sample should be considered as a reference point. In the introduced classification space, the Euclidean distance of each point from the origin of the coordinates could also predict the tea taster’s score with a difference of ±0.5 marks. Finally, we show that the dynamic responses of a temperature-modulated gas sensor have sufficient discriminative features to segregate manufactured black tea samples based on their quality.


  • K2CO3/Al2O3 Composite Pellet as Room-Temperature NO2 Sensor

    by Seyed Mohsen Hosseini-Golgoo, Majid Davtalab-Ghazimahalleh

    K 2 CO 3 , an alkaline carbonate, is commonly used as lean NOx trap device at elevated temperatures. In this device, K 2 CO 3 along with some appropriate additives are coated on two interdigitated Au contacts, which previously patterned on an insulator support, such as Al 2 O 3 . Failure to spontaneous recovery in the sensor's operating conditions causes to a problem in the application of this structure as an NO 2 sensor. In this letter, we show that if K 2 CO 3 is combined with Al 2 O 3 in the form of a pellet and Au contacts are transferred to the top of the structure, a new device is obtained that can detect NO 2 at room temperature in both resistometric and potentiometric modes. In resistometric mode, this sensor exhibits response and recovery time of 65 and 473 s upon exposure to 900 ppb NO 2 at room temperature. Under the same conditions, these times reduce to 16 and 62 s, respectively, when the sensor is operating in potentiometric mode. Using both measurement modes, the relative accuracy of the sensor for prediction of NO 2 concentration level from 15 ppb to 900 ppb is less than 25%. Brick-wall modeling of the grains for resistometric mode and Nernstian electrochemical cell for potentiometric mode could successfully interpret the experimental behavior of the K 2 CO 3 /Al 2 O 3 composite pellet in the exposure of NO 2 .


  • Design of Broadband CNFET LNA Based on Extracted I-V Closed-Form Equation

    by Alireza Saberkari, Omid Khorgami, Javad Bagheri, Morgan Madec, Seyed Mohsen Hosseini-Golgoo, Eduard Alarcon

    A procedure of extracting a closed-form user-friendly I-V equation for short channel carbon nanotube field-effect transistors (CNFET) in the saturation region is presented by employing a relation between CNFET parameters meeting the experimental results. The methodology is based on the Stanford model and ballistic relation of one channel CNFET. In this regard, the ballistic relation is simplified to a closed-form I-V equation, and then, the parameters are estimated through the fitting algorithm by means of ICCAP and least square method, respectively, and the obtained equation is verified by the experimental results given in the literature. Additionally, an extended quantitative noise analysis is performed at the circuit level and the noise sources implemented in Verilog-A are added to the Stanford CNFET HSPICE model. Subsequently, with the accordance to the extracted I-V equation, a CNFET-based inductor-less broadband common-gate low noise amplifier (LNA) is designed theoretically and its results are confirmed in HSPICE based on the Stanford CNFET model, indicating a proper matching between analysis and simulation. The proposed CNFET-based LNA provides very-high-frequency bandwidth and also lower noise figure in comparison with its contemporary CMOS-based LNA, without any passive spiral inductor.


  • Open Access

    Comparison of information content of temporal response of chemoresistive gas sensor under three different temperature modulation regimes for gas detection of different feature reduction methods

    by S M Hosseini-Golgoo, F Salimi, A Saberkari, S Rahbarpour

    In the present work the feature extraction of transient response of a resistive gas sensor under temperature cycling, temperature transient, and temperature combination methods were compared. So, the heater were stimulated by three pulse (cycling), ramp (transient) and staircase (combination) waveforms. The period or duration of all waves was equal to 40 s. Methanol, ethanol, 1-propanol, 1-butanol, toluene and acetone each at 11 different concentration levels in the range of 100 to 2000 ppm were used as the target gases. The utilized sensor was TGS-813 that made by Figaro Company. Recorded results were studied and heuristic features such as peak, rise time, slope and curvature of recorded responses were extracted for each heater waveform. Results showed that although application of this feature extraction method to all waveforms led to gas diagnoses, best results were achieved in the case of staircase waveform. The combination waveform had enough information to separate all examined target gases.


  • Open Access

    Comparison of different feature reduction methods in the improvement of gas diagnosis of a temperature modulated resistive gas sensor

    by S M Hosseini-Golgoo, N Ebrahimpour

    The present study aims to analyze dynamic responses of a temperature modulated resistive gas sensor with the emphasis on the comparison of different feature reduction methods. For this purpose, four selected feature reduction methods consist of Linear Discriminant Analysis (LDA), Principal Component Analysis (PCA), Generalized-LDA (GDA) and Kernel-PCA (KPCA) are applied and compared. The sensor selected for the experiment is a tin oxide based sensor, FIS commercial type. A staircase voltage with the step length of 40 s and voltage range of 1-5 V constitutes the input of the sensor. Sensor system was modeled by ARMAX linear model. The effects of induced gases were recorded as parameter vectors in the data obtained by the model. After applying the methods of feature reductions, the performance of gas separation was compared. It was found out that LDA and GDA yielded the best data classification.