Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Zihao Zhu has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    FEM-Based Analysis of the Loading Capacity of Defective Cable Tunnel Structures

    by He Liu, Junbo Liu, Peng Zhang, Yahong Zhao, Zhigang Wang, Lixin Jiao, Jingyao Luan, Zihao Zhu

    With the popularized application of underground cable tunnels in China, various structural defects such as cracking, deforming and material deteriorating also emerge. In cable tunnels that have been poorly maintained for a long time, there is always a coexistence of several kinds of defects, and with the current methods of monitoring, it is difficult to identify the major defect affecting the load-carrying capacity and resolve it. However, the finite element method (FEM) can better solve this problem by analyzing the effect of a single defect parameter separately. In this paper, four different types of cable tunnels, namely the circular, rectangular, arched and trenched sectional tunnels, are modelled and analyzed with FEM. Defect parameters, including crack dimensions and concrete deterioration, are considered as variables, which are controlled and studied respectively. The results of the simulation indicate that the impact of crack propagation on the residual-bearing capacity of cable tunnels is much larger than that of concrete deterioration, especially the deepening of cracks. Works in this paper have the potential to be further referenced for cable-tunnel structure estimation and defect prevention.

  • Open Access

    Experimental Investigation on the Diffusion Law of Polymer Slurry Grouted in Sand

    by Zhenhua Li, Zihao Zhu, Yahong Zhao, Cong Zeng, Peng Zhang

    Polymer slurry is widely used in underground engineering treatment, but due to the concealed nature of underground projects, the diffusion pattern of slurry in the sand has been little studied. In this study, the basic physical properties of water-based polyurethane, oil-based polyurethane, and acrylate and epoxy resin were compared, and the performance of chemical grouted sands with different polymer slurry/sand mass ratios (PS/S) was tested. The higher the PS/S, the better the mechanical and impermeability properties of the chemical grouted sands. In this paper, water-based polyurethane was selected to carry out orthogonal tests on the diffusivity of slurry in sands. This experiment investigated the degree of influence of sand quality, grouting pressure and sand compactness on the diffusion of slurry in sands. The test results show that, in terms of factors affecting the final pressure of grouting, the sand density has the greatest influence, followed by the sand quality, and the grouting pressure is the smallest. In terms of slurry diffusibility, grouting pressure has the greatest influence, followed by sand compactness, and the sand quality is the smallest. The diffusion mechanism of slurry in the sand was deduced from the morphology of chemical grouted sands. Water-based polyurethane showed splitting-compression-penetration diffusion in sands of different grades, and the diffusion pattern of the slurry was not the same in low-pressure (1–1.5 MPa) grouting and high-pressure (2 MPa) grouting, and lateral splitting occurred in the case of high-pressure grouting diffusion.


  • Open Access

    An Experimental Study of the Mechanical Properties of Partially Rehabilitated Cable Tunnels

    by Zihao Zhu, Baosong Ma, Zheng Zeng, Chenkun Gong, Zhe Mei, Jinqiu Hu, Peng Zhang

    For buried municipal tunnels—such as cable tunnels and utility tunnels with structural defects—due to the sheltering of the internal pipelines, shelves, and other auxiliary facilities, traditional trenchless rehabilitating methods are not applicable since an intact ring is needed for spraying and lining. In these tunnels, only the exposed area at the crown of the ring can be partly rehabilitated. In this paper, three-edge bearing tests (TEBTs) for partially rehabilitated reinforced concrete (RC) pipe sections are carried out to simulate the case of a municipal tunnel and the effects of different repair materials (cement mortar and epoxy resin) and different dimensional parameters of the liner (lining thickness, lining range) on the partial rehabilitation effect of defective RC pipes are studied. The deforming compatibility of the liner–pipe interface is discussed, and the flexural rigidity of the partially rehabilitated section is calculated. The results show that the load-carrying capacities of partial rehabilitated RC pipes are effectively improved.