Na Duan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Na Duan has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Yong Li
School of Electrical Engineering, Southwest Jiaotong University, Chengdu, China
4 shared publications - Zhaowei Liu
School of Electrical Engineering, Southwest Jiaotong University, Chengdu, China
4 shared publications - Zhengyou He
School of Electrical Engineering, Southwest Jiaotong University, Chengdu, China
4 shared publications - Jiefeng Hu
Federation University
2 shared publications - Huanyu Yang
State Grid Hunan Electric Power Company Limited Changsha China
1 shared publication - Peng Li
China Southern Power Grid, Guangzhou, China
1 shared publication
Latest Publications
- 12 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (7) , 8834-8843
An Effective Power Improving Method of Magnetic Field Energy Harvesters Using a Series-Connected Capacitor for Wireless Sensors in Smart Grids
The low power density of a magnetic field energy harvester (MFEH) limits its applicability. Conventional methods for improving power harvesting, e.g., increasing the volume of the magnetic core, cannot effectively increase the output power density of the MFEH and it increases the burden on the transmission lines. An in-depth investigation reveals that by adding an optimal series-connected capacitor before the rectifier, the output power of the MFEH can be maximized. By reducing the net voltage applied to the magnetizing inductance, the flux accumulation is slower, lengthening the energy harvesting time, and the output power is increased. Furthermore, the output power can be maximized with an optimal series-connected capacitor. The design method of the optimal series-connected capacitor is theoretically analyzed in this article, which is only related to the load characteristics. In addition, the proposed method has a simple structure and can effectively improve the system power density of the MFEH. An experimental prototype is constructed to verify the effectiveness of the proposed method, and the results agree well with the theoretical analysis. Compared with the conventional MFEH without a series-connected capacitor, the method presented in this article can increase the harvested power by approximately 50%.
- 12 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (7) , 8834-8843
An Effective Power Improving Method of Magnetic Field Energy Harvesters Using a Series-Connected Capacitor for Wireless Sensors in Smart Grids
The low power density of a magnetic field energy harvester (MFEH) limits its applicability. Conventional methods for improving power harvesting, e.g., increasing the volume of the magnetic core, cannot effectively increase the output power density of the MFEH and it increases the burden on the transmission lines. An in-depth investigation reveals that by adding an optimal series-connected capacitor before the rectifier, the output power of the MFEH can be maximized. By reducing the net voltage applied to the magnetizing inductance, the flux accumulation is slower, lengthening the energy harvesting time, and the output power is increased. Furthermore, the output power can be maximized with an optimal series-connected capacitor. The design method of the optimal series-connected capacitor is theoretically analyzed in this article, which is only related to the load characteristics. In addition, the proposed method has a simple structure and can effectively improve the system power density of the MFEH. An experimental prototype is constructed to verify the effectiveness of the proposed method, and the results agree well with the theoretical analysis. Compared with the conventional MFEH without a series-connected capacitor, the method presented in this article can increase the harvested power by approximately 50%.
- 5 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 71 (5) , 5360-5369
An Energy Management Method for Magnetic Field Energy Harvesters Under Wide-Range Current in Railway Electrification Systems
The wide-range traction current brings great challenges to the stable operation of the magnetic field energy harvester (MFEH). Specifically, when the traction current is large, the core saturation increases, resulting in violent vibration of the magnetic core. When the traction current is low, the energy harvested by the MFEH is insufficient to power the load. To address these vital problems, an energy management method for MFEH is proposed to track the critical saturation point, i.e., the maximum power point in the unsaturated region. In this method, by regulating the equivalent load, the core voltage is controlled at the critical saturation voltage under different current levels. Moreover, the supercapacitor is employed to store excess energy at large currents, and the stored energy is released at low currents. Furthermore, a design procedure for the core and winding is proposed in this work, which can be used to adjust the critical saturation voltage of the MFEH. A laboratory prototype is built to verify the effectiveness of the proposal. The results show that the MFEH can operate at the critical saturation point and provide stable energy for the load under different current levels. This means that saturation suppression, maximum power point tracking, and energy management can be realized by applying the proposed method.
- 5 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 71 (5) , 5360-5369
An Energy Management Method for Magnetic Field Energy Harvesters Under Wide-Range Current in Railway Electrification Systems
The wide-range traction current brings great challenges to the stable operation of the magnetic field energy harvester (MFEH). Specifically, when the traction current is large, the core saturation increases, resulting in violent vibration of the magnetic core. When the traction current is low, the energy harvested by the MFEH is insufficient to power the load. To address these vital problems, an energy management method for MFEH is proposed to track the critical saturation point, i.e., the maximum power point in the unsaturated region. In this method, by regulating the equivalent load, the core voltage is controlled at the critical saturation voltage under different current levels. Moreover, the supercapacitor is employed to store excess energy at large currents, and the stored energy is released at low currents. Furthermore, a design procedure for the core and winding is proposed in this work, which can be used to adjust the critical saturation voltage of the MFEH. A laboratory prototype is built to verify the effectiveness of the proposal. The results show that the MFEH can operate at the critical saturation point and provide stable energy for the load under different current levels. This means that saturation suppression, maximum power point tracking, and energy management can be realized by applying the proposed method.
- 8 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 70 (10) , 10730-10739
Impedance-Matching-Based Maximum Power Tracking for Magnetic Field Energy Harvesters Using Active Rectifiers
Increasing the power harvested from magnetic field energy harvesters (MFEHs) without expanding their volumes is crucial. Conventional methods for improving power harvest, e.g., flux-shaping capacitor and transfer window alignment techniques, are not applicable under varying primary current and load conditions. To address this vital problem, in this article, we present a control strategy of MFEHs based on impedance-matching theory, which considers the nonlinear characteristic of magnetic energy sources and can track the maximum power under varying current and load conditions based on an active rectifier. A calculation formula is derived to determine the optimal initial operating point of the active rectifier circuit, which aims to adjust the equivalent impedance to achieve maximum power tracking. An experimental prototype is constructed to verify the effectiveness of the proposed method. It is found that the proposed method enhances the harvested power under different current and load conditions, particularly in deep saturation conditions. The experimental results show that the proposed MFEH can harvest an average power of 2.51 W on an 800 Ω load from a 50 Hz 80 A RMS power line, which is increased by 136.8% compared with the conventional MFEH with a passive rectifier.
- 8 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 70 (10) , 10730-10739
Impedance-Matching-Based Maximum Power Tracking for Magnetic Field Energy Harvesters Using Active Rectifiers
Increasing the power harvested from magnetic field energy harvesters (MFEHs) without expanding their volumes is crucial. Conventional methods for improving power harvest, e.g., flux-shaping capacitor and transfer window alignment techniques, are not applicable under varying primary current and load conditions. To address this vital problem, in this article, we present a control strategy of MFEHs based on impedance-matching theory, which considers the nonlinear characteristic of magnetic energy sources and can track the maximum power under varying current and load conditions based on an active rectifier. A calculation formula is derived to determine the optimal initial operating point of the active rectifier circuit, which aims to adjust the equivalent impedance to achieve maximum power tracking. An experimental prototype is constructed to verify the effectiveness of the proposed method. It is found that the proposed method enhances the harvested power under different current and load conditions, particularly in deep saturation conditions. The experimental results show that the proposed MFEH can harvest an average power of 2.51 W on an 800 Ω load from a 50 Hz 80 A RMS power line, which is increased by 136.8% compared with the conventional MFEH with a passive rectifier.
- 9 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 70 (1) , 276-285
An Accurate Model of Magnetic Energy Harvester in the Saturated Region for Harvesting Maximum Power: Analysis, Design, and Experimental Verification
To reduce the size and weight of the magnetic energy harvester (MEH), the magnetic core should be designed to work in the maximum power region, i.e., in the saturated region. However, the conventional analysis model of the MEH, which ignores the phase difference between the primary and secondary currents, is only suitable for the unsaturated region. When the core is in the saturated region, the results of the numerical calculation severely deviate from the experimental observations due to the non-negligible phase difference. To address this vital problem, this article establishes an excitation current model (ECM) to calculate the phase difference caused by the magnetizing inductance. An accurate model of the MEH is presented based on the ECM in this article, which can calculate the harvesting power of the MEH in the saturated region. Besides, a strategy for finding the maximum power point is proposed, which can be used for the designing of the MEH. Finally, an experimental prototype is constructed to verify the effectiveness of the proposed analysis model and the design method of the MEH. The experimental results show that the proposed analysis model can maintain high accuracy when the magnetic core enters the saturated region, and the MEH designed by the proposed model can reach the expected power with a compact size. Compared with the theoretical value, the output voltage deviation of the MEH is only 0.4%, and the output power deviation is only 0.8%.
- 9 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 70 (1) , 276-285
An Accurate Model of Magnetic Energy Harvester in the Saturated Region for Harvesting Maximum Power: Analysis, Design, and Experimental Verification
To reduce the size and weight of the magnetic energy harvester (MEH), the magnetic core should be designed to work in the maximum power region, i.e., in the saturated region. However, the conventional analysis model of the MEH, which ignores the phase difference between the primary and secondary currents, is only suitable for the unsaturated region. When the core is in the saturated region, the results of the numerical calculation severely deviate from the experimental observations due to the non-negligible phase difference. To address this vital problem, this article establishes an excitation current model (ECM) to calculate the phase difference caused by the magnetizing inductance. An accurate model of the MEH is presented based on the ECM in this article, which can calculate the harvesting power of the MEH in the saturated region. Besides, a strategy for finding the maximum power point is proposed, which can be used for the designing of the MEH. Finally, an experimental prototype is constructed to verify the effectiveness of the proposed analysis model and the design method of the MEH. The experimental results show that the proposed analysis model can maintain high accuracy when the magnetic core enters the saturated region, and the MEH designed by the proposed model can reach the expected power with a compact size. Compared with the theoretical value, the output voltage deviation of the MEH is only 0.4%, and the output power deviation is only 0.8%.