Mark van der Heijden
Mark van der Heijden has a total of 60 co-authors. Here are the top co-authors by number of shared publications:
- Ahmet Çağrı Ulusoy
Karlsruhe Institute of Technology
2 shared publications - Kateryna Smirnova
Institute of Radio Frequency Engineering and Electronics (IHE), Karlsruhe Institute of Technology, Karlsruhe, Germany
2 shared publications A. Briseno Ojeda
Karlsruhe Institute of Technology, 6131 Karlsruhe, Germany
1 shared publicationA. Filippi
NXP Semiconductors, High Tech Campus 60, 5656 AG Eindhoven, The Netherlands
1 shared publicationA.B. Smolders
Eindhoven University of Technology, Den Dolech 2, 5612 AZ Eindhoven, The Netherlands
1 shared publicationB. Cimbili
Fraunhofer Institute for Applied Solid State Physics, IAF, Tullastrasse 72, 79108 Freiburg, Germany
1 shared publication
Latest Publications
- 14 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (4) , 3666-3676
D-Band Reciprocal Passive Design and Analysis Based on Consecutive Single-Ended Two-Port Measurements
This work proposes and analyzes a methodology to characterize the scattering parameters of multiport passives up to 170 GHz by consecutive single-ended two-port measurements. The generalized methodology is based on duplicating the device under test with linear combinations of load and open terminations to create a system of equations that can be solved for full characterization. The methodology is applied to a D-band differential four-port quadrature hybrid (QH) coupler designed in 22-nm FDSOI technology. Measurement results are presented for even- and odd-mode and differential-mode over five samples. Moreover, a quantitative and qualitative study is presented to highlight the method’s sensitivity to variability in measurement, device under test, and terminations.
- 14 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (4) , 3666-3676
D-Band Reciprocal Passive Design and Analysis Based on Consecutive Single-Ended Two-Port Measurements
This work proposes and analyzes a methodology to characterize the scattering parameters of multiport passives up to 170 GHz by consecutive single-ended two-port measurements. The generalized methodology is based on duplicating the device under test with linear combinations of load and open terminations to create a system of equations that can be solved for full characterization. The methodology is applied to a D-band differential four-port quadrature hybrid (QH) coupler designed in 22-nm FDSOI technology. Measurement results are presented for even- and odd-mode and differential-mode over five samples. Moreover, a quantitative and qualitative study is presented to highlight the method’s sensitivity to variability in measurement, device under test, and terminations.
- 9 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 7, 175-178
Bidirectional 6-Bit Active Phase Shifter in W-Band
In this letter, a novel W-band switchless bidirectional active phase shifter with 6-bit resolution is proposed. The circuit is implemented in the SiGe:C BiCMOS technology using a Gilbert-cell core configured in a way to combine the reciprocity of passive phase shifters with the compactness of active topologies. The circuit exhibits a maximum average gain of –7.4 and –8.2 dB in two directions while maintaining the RMS amplitude and phase error lower than 0.84 dB and 3.4° within 85– 100 GHz, respectively. The phase shifter uses 0.04 mm2 of the IC area and the DC power of 38 mW in each direction from a 2.4-V supply voltage, excluding the phase control circuitry.
- 9 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 7, 175-178
Bidirectional 6-Bit Active Phase Shifter in W-Band
In this letter, a novel W-band switchless bidirectional active phase shifter with 6-bit resolution is proposed. The circuit is implemented in the SiGe:C BiCMOS technology using a Gilbert-cell core configured in a way to combine the reciprocity of passive phase shifters with the compactness of active topologies. The circuit exhibits a maximum average gain of –7.4 and –8.2 dB in two directions while maintaining the RMS amplitude and phase error lower than 0.84 dB and 3.4° within 85– 100 GHz, respectively. The phase shifter uses 0.04 mm2 of the IC area and the DC power of 38 mW in each direction from a 2.4-V supply voltage, excluding the phase control circuitry.
- 13 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (7) , 1035-1038
W-Band 6-Bit Active Phase Shifter Using Differential Lange Coupler in SiGe BiCMOS
This letter presents a $W$ -band vector-modulator-based phase shifter with a 6-bit resolution, implemented in a SiGe:C BiCMOS technology. The phase shifter maintains the RMS amplitude and phase errors lower than 1 dB and 6.6 $^{\circ}$ , respectively, for the frequency range of 86–106 GHz without digital calibration. The maximum average gain is 2.3 dB with the 3-dB bandwidth achieving 31 GHz. The circuit consumes 49 mW of power including the phase control circuitry from a 2.4-V supply voltage, 34 mW of which is used by the Gilbert cell. A novel compact differential Lange coupler is used as an IQ splitter. The core part occupies only 0.027 mm $^2$ of the chip area.
- 13 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (7) , 1035-1038
W-Band 6-Bit Active Phase Shifter Using Differential Lange Coupler in SiGe BiCMOS
This letter presents a $W$ -band vector-modulator-based phase shifter with a 6-bit resolution, implemented in a SiGe:C BiCMOS technology. The phase shifter maintains the RMS amplitude and phase errors lower than 1 dB and 6.6 $^{\circ}$ , respectively, for the frequency range of 86–106 GHz without digital calibration. The maximum average gain is 2.3 dB with the 3-dB bandwidth achieving 31 GHz. The circuit consumes 49 mW of power including the phase control circuitry from a 2.4-V supply voltage, 34 mW of which is used by the Gilbert cell. A novel compact differential Lange coupler is used as an IQ splitter. The core part occupies only 0.027 mm $^2$ of the chip area.
- Open Access
- 2 September 2022
- Published by CERN in Open Research Europe
- Vol. 2, 106
The state of the art in beyond 5G distributed massive multiple-input multiple-output communication system solutions
Beyond fifth generation (5G) communication systems aim towards data rates in the tera bits per second range, with improved and flexible coverage options, introducing many new technological challenges in the fields of network architecture, signal pro- cessing, and radio frequency front-ends. One option is to move towards cell-free, or distributed massive Multiple-Input Multiple-Output (MIMO) network architectures and highly integrated front-end solutions. This paper presents an outlook on be- yond 5G distributed massive MIMO communication systems, the signal processing, characterisation and simulation challenges, and an overview of the state of the art in millimetre wave antennas and electronics.
- 2 September 2022
- Published by CERN in Open Research Europe
- Vol. 2, 106
Open AccessThe state of the art in beyond 5G distributed massive multiple-input multiple-output communication system solutions
Beyond fifth generation (5G) communication systems aim towards data rates in the tera bits per second range, with improved and flexible coverage options, introducing many new technological challenges in the fields of network architecture, signal pro- cessing, and radio frequency front-ends. One option is to move towards cell-free, or distributed massive Multiple-Input Multiple-Output (MIMO) network architectures and highly integrated front-end solutions. This paper presents an outlook on be- yond 5G distributed massive MIMO communication systems, the signal processing, characterisation and simulation challenges, and an overview of the state of the art in millimetre wave antennas and electronics.