Kateryna Smirnova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kateryna Smirnova has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ahmet Çağrı Ulusoy
Karlsruhe Institute of Technology
3 shared publications - Mark van der Heijden
NXP Semiconductors, Eindhoven, The Netherlands
2 shared publications - Christian Bohn
Institute of Radio Frequency Engineering and Electronics, Karlsruhe Institute of Technology (KIT), Karlsruhe, Germany
1 shared publication Domine Leenaerts
Business Line Radio Frequency Power, NXP Semiconductors, Eindhoven, Eindhoven, The Netherlands
1 shared publication- Domine M. W. Leenaerts
NXP Semiconductors, Eindhoven, The Netherlands
1 shared publication Konstantinos Giannakidis
NXP Semiconductors, Eindhoven, The Netherlands
1 shared publication
Latest Publications
- 9 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 7, 175-178
Bidirectional 6-Bit Active Phase Shifter in W-Band
In this letter, a novel W-band switchless bidirectional active phase shifter with 6-bit resolution is proposed. The circuit is implemented in the SiGe:C BiCMOS technology using a Gilbert-cell core configured in a way to combine the reciprocity of passive phase shifters with the compactness of active topologies. The circuit exhibits a maximum average gain of –7.4 and –8.2 dB in two directions while maintaining the RMS amplitude and phase error lower than 0.84 dB and 3.4° within 85– 100 GHz, respectively. The phase shifter uses 0.04 mm2 of the IC area and the DC power of 38 mW in each direction from a 2.4-V supply voltage, excluding the phase control circuitry.
- 9 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 7, 175-178
Bidirectional 6-Bit Active Phase Shifter in W-Band
In this letter, a novel W-band switchless bidirectional active phase shifter with 6-bit resolution is proposed. The circuit is implemented in the SiGe:C BiCMOS technology using a Gilbert-cell core configured in a way to combine the reciprocity of passive phase shifters with the compactness of active topologies. The circuit exhibits a maximum average gain of –7.4 and –8.2 dB in two directions while maintaining the RMS amplitude and phase error lower than 0.84 dB and 3.4° within 85– 100 GHz, respectively. The phase shifter uses 0.04 mm2 of the IC area and the DC power of 38 mW in each direction from a 2.4-V supply voltage, excluding the phase control circuitry.
- 6 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (8) , 1171-1174
Ultralow-Power W-Band Low-Noise Amplifier Design in 130-nm SiGe BiCMOS
This letter presents a power consumption reduction aspect for a 100-GHz low-noise amplifier (LNA). Two designs implemented in 0.13- $\mu$ m SiGe bipolar complementary metal oxide semiconductor (BiCMOS) technology demonstrate state-of-the-art performance, whereas $P_{\mathrm{DC}}$ is reduced from 23.5 mW for the standard version to 3.8 mW for the low-power version. Two circuits exhibit a measured gain of 22 and 16 dB and a noise figure (NF) of 4 and 6.3 dB at 100 GHz. An input 1-dB compression point for the standard and the low-power version is $-$ 24.5 and $-$ 26.5 dBm, respectively. The occupied integrated circuit (IC) area in both cases is 0.018 and 0.014 mm $^2$ excluding the pads, which proves to be the most compact design among previously reported in the frequency range of interest.
- 6 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (8) , 1171-1174
Ultralow-Power W-Band Low-Noise Amplifier Design in 130-nm SiGe BiCMOS
This letter presents a power consumption reduction aspect for a 100-GHz low-noise amplifier (LNA). Two designs implemented in 0.13- $\mu$ m SiGe bipolar complementary metal oxide semiconductor (BiCMOS) technology demonstrate state-of-the-art performance, whereas $P_{\mathrm{DC}}$ is reduced from 23.5 mW for the standard version to 3.8 mW for the low-power version. Two circuits exhibit a measured gain of 22 and 16 dB and a noise figure (NF) of 4 and 6.3 dB at 100 GHz. An input 1-dB compression point for the standard and the low-power version is $-$ 24.5 and $-$ 26.5 dBm, respectively. The occupied integrated circuit (IC) area in both cases is 0.018 and 0.014 mm $^2$ excluding the pads, which proves to be the most compact design among previously reported in the frequency range of interest.
- 13 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (7) , 1035-1038
W-Band 6-Bit Active Phase Shifter Using Differential Lange Coupler in SiGe BiCMOS
This letter presents a $W$ -band vector-modulator-based phase shifter with a 6-bit resolution, implemented in a SiGe:C BiCMOS technology. The phase shifter maintains the RMS amplitude and phase errors lower than 1 dB and 6.6 $^{\circ}$ , respectively, for the frequency range of 86–106 GHz without digital calibration. The maximum average gain is 2.3 dB with the 3-dB bandwidth achieving 31 GHz. The circuit consumes 49 mW of power including the phase control circuitry from a 2.4-V supply voltage, 34 mW of which is used by the Gilbert cell. A novel compact differential Lange coupler is used as an IQ splitter. The core part occupies only 0.027 mm $^2$ of the chip area.
- 13 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (7) , 1035-1038
W-Band 6-Bit Active Phase Shifter Using Differential Lange Coupler in SiGe BiCMOS
This letter presents a $W$ -band vector-modulator-based phase shifter with a 6-bit resolution, implemented in a SiGe:C BiCMOS technology. The phase shifter maintains the RMS amplitude and phase errors lower than 1 dB and 6.6 $^{\circ}$ , respectively, for the frequency range of 86–106 GHz without digital calibration. The maximum average gain is 2.3 dB with the 3-dB bandwidth achieving 31 GHz. The circuit consumes 49 mW of power including the phase control circuitry from a 2.4-V supply voltage, 34 mW of which is used by the Gilbert cell. A novel compact differential Lange coupler is used as an IQ splitter. The core part occupies only 0.027 mm $^2$ of the chip area.