Fernanda Bortolini
Research Subjects
Research Interests
Fernanda Bortolini has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Andréa Mittelmann
Embrapa Dairy Cattle Juiz de Fora Minas Gerais Brazil
1 shared publication - Carlos Eduardo da Silva Pedroso
Universidade Federal de Pelotas
1 shared publication - Luis Guilherme Ramos Tavares1 shared publication
- Lílian Moreira Barros
Faculdade de Agronomia Eliseu Maciel, Departamento de Fitotecnia, Universidade Federal de Pelotas, Campus Capão do Leão, Pelotas, RS, 96010-610, Brazil
1 shared publication - Rodrigo Porto Veronez1 shared publication
Latest Publications
- Open Access
- 25 March 2022
- Published by Universidad Nacional de Colombia in Acta Agronomica
- Vol. 70 (3)
Sowing rate and its effects on forage yield of tetraploid ryegrass
There is a shortage of information about the ryegrass crop (Lolium multiflorum Lam.), especially regarding the suitable sowing rate. Thus, the present work aimed to determine the most adequate sowing rate for tetraploid ryegrass cultivars. A tetraploid ryegrass population was sown at different densities: 150, 300, 600, 900, 1200, 1500, 1800 seeds/m². The number of plants per m², percentage of soil cover, leaf yield and green and dry forage yield were evaluated. The experimental design was randomized blocks with three replications. To observe the behavior of the pasture at different densities for each cut, regression analysis was performed, through which it was possible to verify that the sowing rate has greater influence on the initial cut of the crop. In all the variables analyzed by regression, only the second cut presented a linear trend favorable to the increase in density. In the other cuts, an increase was observed, both in the height of plants and in the yield variables, up to the density of 1500 seeds/m², with a subsequent fall to the highest density, indicating that higher densities may be detrimental to pasture yield. Therefore the density of 1500 seeds/m² is the most suitable for tetraploid ryegrass cultivars.
- 25 March 2022
- Published by Universidad Nacional de Colombia in Acta Agronomica
- Vol. 70 (3)
Open AccessSowing rate and its effects on forage yield of tetraploid ryegrass
There is a shortage of information about the ryegrass crop (Lolium multiflorum Lam.), especially regarding the suitable sowing rate. Thus, the present work aimed to determine the most adequate sowing rate for tetraploid ryegrass cultivars. A tetraploid ryegrass population was sown at different densities: 150, 300, 600, 900, 1200, 1500, 1800 seeds/m². The number of plants per m², percentage of soil cover, leaf yield and green and dry forage yield were evaluated. The experimental design was randomized blocks with three replications. To observe the behavior of the pasture at different densities for each cut, regression analysis was performed, through which it was possible to verify that the sowing rate has greater influence on the initial cut of the crop. In all the variables analyzed by regression, only the second cut presented a linear trend favorable to the increase in density. In the other cuts, an increase was observed, both in the height of plants and in the yield variables, up to the density of 1500 seeds/m², with a subsequent fall to the highest density, indicating that higher densities may be detrimental to pasture yield. Therefore the density of 1500 seeds/m² is the most suitable for tetraploid ryegrass cultivars.