Xinyi Lin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xinyi Lin has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Na Yan
Fudan University
4 shared publications - Hao Min
State Key Laboratory of Integrated Chips and System, Fudan University
2 shared publications - Hao Xu
Fudan University
2 shared publications - Haoyuan Gao
State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China
2 shared publications - Peifang Wu
State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China
2 shared publications - Shujiang Ji
State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China
2 shared publications
Latest Publications
- 10 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 73 (4) , 2425-2437
A 6.8-GHz Fractional-N Pulse-Shaper-Based PLL Achieving −269.9-dB FoM Jitter-N-Area
This paper presents a 6.8-GHz compact digital fractional-N PLL based on a pulse-shaped loop filter, enabling a loop bandwidth of $0.26f_{ref}$ to suppress the ring oscillator’s phase noise. It leverages a constant-slope DTC with range extension technique to save 50% area of the capacitor array. The embedded nonlinearity cancellation and digital offset compensation further improve the spectrum purity. Fabricated in a 28-nm CMOS process, the pulse-shaper-based PLL occupies $\text {0.025mm}^{{2}}$ core area, achieves an integrated jitter of 804 fs and −53.2 dBc fractional spur at near-integer channels with a power consumption of 5.68mW, obtaining a $\text {FoM}_{\text {Jitter-N-Area}}$ of −269.9 dB.
- 10 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 73 (4) , 2425-2437
A 6.8-GHz Fractional-N Pulse-Shaper-Based PLL Achieving −269.9-dB FoM Jitter-N-Area
This paper presents a 6.8-GHz compact digital fractional-N PLL based on a pulse-shaped loop filter, enabling a loop bandwidth of $0.26f_{ref}$ to suppress the ring oscillator’s phase noise. It leverages a constant-slope DTC with range extension technique to save 50% area of the capacitor array. The embedded nonlinearity cancellation and digital offset compensation further improve the spectrum purity. Fabricated in a 28-nm CMOS process, the pulse-shaper-based PLL occupies $\text {0.025mm}^{{2}}$ core area, achieves an integrated jitter of 804 fs and −53.2 dBc fractional spur at near-integer channels with a power consumption of 5.68mW, obtaining a $\text {FoM}_{\text {Jitter-N-Area}}$ of −269.9 dB.
- 7 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 72 (4) , 529-533
An All-Digital Spread-Spectrum Clock Generator With Feedforward Gain Calibration for LPWAN Chirp Transmission System
In this brief, an all-digital spread-spectrum clock generator (AD-SSCG) is presented for low-power wide-area network (LPWAN) chirp spread spectrum application. Facing the periodic frequency hopping in chirp modulation, a gain calibration is employed in feedforward path to avoid two-point modulation (TPM) loop-gain mismatches and phase error, ensuring a precise frequency tracking. Employed with the combination of a constant slope digital-to-time converter (CS-DTC) and an multi-bit mid-rise TDC, the embedded digital loop can provide a linear sawtooth chirp modulation while keeping a good phase noise (PN) performance. Fabricated in a 40nm CMOS process, the AD-SSCG achieves a random jitter of 508fsrms, with measured PN of -111.6dBc/Hz@1MHz. The EMI reduction achieves 39.1dB (4MHz + 2000ppm depth). The prototype chip consumes 2.45mW under 1.1V supply voltage.
- 7 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 72 (4) , 529-533
An All-Digital Spread-Spectrum Clock Generator With Feedforward Gain Calibration for LPWAN Chirp Transmission System
In this brief, an all-digital spread-spectrum clock generator (AD-SSCG) is presented for low-power wide-area network (LPWAN) chirp spread spectrum application. Facing the periodic frequency hopping in chirp modulation, a gain calibration is employed in feedforward path to avoid two-point modulation (TPM) loop-gain mismatches and phase error, ensuring a precise frequency tracking. Employed with the combination of a constant slope digital-to-time converter (CS-DTC) and an multi-bit mid-rise TDC, the embedded digital loop can provide a linear sawtooth chirp modulation while keeping a good phase noise (PN) performance. Fabricated in a 40nm CMOS process, the AD-SSCG achieves a random jitter of 508fsrms, with measured PN of -111.6dBc/Hz@1MHz. The EMI reduction achieves 39.1dB (4MHz + 2000ppm depth). The prototype chip consumes 2.45mW under 1.1V supply voltage.
- 3 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (8) , 3597-3607
Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur
This paper presents an analog low-power sub-sampling phase locked loop (PLL) that tackles the reference spur caused by VCO load modulation from the sub-sampling operation. A complete analysis on the binary frequency shift keying (BFSK) effect including the impact of the VCO buffer is provided, followed by practical design guide that achieves the optimum spur/jitter trade-off. The proposed sub-sampling phase detector incorporates an active primary-secondary architecture for improved isolation to suppress the load modulation. The adaptive frequency locked loop (FLL) consumes zero power in the locked state and activates itself once unlocking is detected. The sub-sampling PLL is fabricated in a 40nm CMOS process. It achieves -121.5dBc/Hz phase noise at 1MHz offset frequency and an RMS jitter of 185fs integrated from 10k to 10MHz. The power dissipation is 1.14mW at 0.95V supply with a -254.1dB figure-of-merit. The proposed phase detector results in -73dBc reference spur that is among the lowest in state-of-art works.
- 3 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (8) , 3597-3607
Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur
This paper presents an analog low-power sub-sampling phase locked loop (PLL) that tackles the reference spur caused by VCO load modulation from the sub-sampling operation. A complete analysis on the binary frequency shift keying (BFSK) effect including the impact of the VCO buffer is provided, followed by practical design guide that achieves the optimum spur/jitter trade-off. The proposed sub-sampling phase detector incorporates an active primary-secondary architecture for improved isolation to suppress the load modulation. The adaptive frequency locked loop (FLL) consumes zero power in the locked state and activates itself once unlocking is detected. The sub-sampling PLL is fabricated in a 40nm CMOS process. It achieves -121.5dBc/Hz phase noise at 1MHz offset frequency and an RMS jitter of 185fs integrated from 10k to 10MHz. The power dissipation is 1.14mW at 0.95V supply with a -254.1dB figure-of-merit. The proposed phase detector results in -73dBc reference spur that is among the lowest in state-of-art works.
- 28 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (5) , 403-405
A 2.4-GHz Sub-Sampling PLL With an Adaptive and No Power Contribution FLL Achieving 103.58 fs rms Jitter and −257.8 dB FOM
A sub-sampling PLL (SSPLL) employing an adaptive frequency-locked loop (FLL) without static power consumption is proposed in this letter. A new unlock detection mechanism and a configurable PFD are realized in the adaptive FLL. With the new unlock detection mechanism, while the FLL that contains phase detector, divider, and charge pump dissipates no power during the locked steady state, it automatically starts when external interferences disturb the locked state. The optimized dead zone in the configurable PFD ensures a rapid relocking operation. Based on the proposed adaptive FLL, the 2.4 GHz SSPLL is fabricated in a 40-nm CMOS process. It achieves −128.5 dBc/Hz at 1 MHz offset frequency and the rms jitter is 103.58 fs integrated from 10 k to 10 MHz. It consumes 1.55 mW at 1 V supply and achieves −257.8 dB FOM.
- 28 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (5) , 403-405
A 2.4-GHz Sub-Sampling PLL With an Adaptive and No Power Contribution FLL Achieving 103.58 fs rms Jitter and −257.8 dB FOM
A sub-sampling PLL (SSPLL) employing an adaptive frequency-locked loop (FLL) without static power consumption is proposed in this letter. A new unlock detection mechanism and a configurable PFD are realized in the adaptive FLL. With the new unlock detection mechanism, while the FLL that contains phase detector, divider, and charge pump dissipates no power during the locked steady state, it automatically starts when external interferences disturb the locked state. The optimized dead zone in the configurable PFD ensures a rapid relocking operation. Based on the proposed adaptive FLL, the 2.4 GHz SSPLL is fabricated in a 40-nm CMOS process. It achieves −128.5 dBc/Hz at 1 MHz offset frequency and the rms jitter is 103.58 fs integrated from 10 k to 10 MHz. It consumes 1.55 mW at 1 V supply and achieves −257.8 dB FOM.