Shujiang Ji
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Shujiang Ji has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Hao Min
State Key Laboratory of Integrated Chips and System, Fudan University
4 shared publications - Na Yan
Fudan University
4 shared publications Yizhuo Wang
State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China
3 shared publications- Hao Xu
Fudan University
2 shared publications Sijia Lai
State Key Laboratory of ASIC and System, Fudan University, Shanghai, China
2 shared publications- Xinyi Lin
State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China
2 shared publications
Latest Publications
- 3 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (8) , 3597-3607
Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur
This paper presents an analog low-power sub-sampling phase locked loop (PLL) that tackles the reference spur caused by VCO load modulation from the sub-sampling operation. A complete analysis on the binary frequency shift keying (BFSK) effect including the impact of the VCO buffer is provided, followed by practical design guide that achieves the optimum spur/jitter trade-off. The proposed sub-sampling phase detector incorporates an active primary-secondary architecture for improved isolation to suppress the load modulation. The adaptive frequency locked loop (FLL) consumes zero power in the locked state and activates itself once unlocking is detected. The sub-sampling PLL is fabricated in a 40nm CMOS process. It achieves -121.5dBc/Hz phase noise at 1MHz offset frequency and an RMS jitter of 185fs integrated from 10k to 10MHz. The power dissipation is 1.14mW at 0.95V supply with a -254.1dB figure-of-merit. The proposed phase detector results in -73dBc reference spur that is among the lowest in state-of-art works.
- 3 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (8) , 3597-3607
Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur
This paper presents an analog low-power sub-sampling phase locked loop (PLL) that tackles the reference spur caused by VCO load modulation from the sub-sampling operation. A complete analysis on the binary frequency shift keying (BFSK) effect including the impact of the VCO buffer is provided, followed by practical design guide that achieves the optimum spur/jitter trade-off. The proposed sub-sampling phase detector incorporates an active primary-secondary architecture for improved isolation to suppress the load modulation. The adaptive frequency locked loop (FLL) consumes zero power in the locked state and activates itself once unlocking is detected. The sub-sampling PLL is fabricated in a 40nm CMOS process. It achieves -121.5dBc/Hz phase noise at 1MHz offset frequency and an RMS jitter of 185fs integrated from 10k to 10MHz. The power dissipation is 1.14mW at 0.95V supply with a -254.1dB figure-of-merit. The proposed phase detector results in -73dBc reference spur that is among the lowest in state-of-art works.
- 16 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (8) , 2252-2266
Analysis and Design of a Dual-Mode VCO With Inherent Mode Compensation Enabling a 7.9–14.3-GHz 85-fs-rms Jitter PLL
This article presents a wideband, low-jitter frequency synthesizer utilizing a dual-mode voltage-controlled oscillator (VCO). Mode imbalance in the dual-mode VCO is analyzed theoretically and compensated through the proposed symmetric figure-8 transformer and capacitor arrays. The compact mode-switching circuitry fundamentally eliminates mode ambiguity in multi-mode autonomous circuits. A computer-aided algorithm based on sequential least-squares programming (SLSQP) and hierarchical optimization method is developed to automatically optimize the capacitor array in the wideband VCO. The implemented dual-mode VCO suppresses the phase noise (PN) difference across the operating frequency range, which further enables a sub-sampling phase-locked loop (SSPLL) to achieve near-minimum jitter across a wide frequency range without loop gain adaptation. Fabricated in a 40-nm CMOS process, the wideband SSPLL covers the frequency range of 7.9–14.3 GHz with 14.1–17.2-mW power consumption and occupies only 0.18-mm $^2$ area. The SSPLL achieves better than $-$ 115-dBc/Hz in-band PN at a 10-GHz carrier. The rms jitter is less than 85 fs across the whole frequency range. The corresponding figure-of-merit tuning (FoM $_T$ ) is $-$ 247.1 to $-$ 248.1 dB.
- 16 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (8) , 2252-2266
Analysis and Design of a Dual-Mode VCO With Inherent Mode Compensation Enabling a 7.9–14.3-GHz 85-fs-rms Jitter PLL
This article presents a wideband, low-jitter frequency synthesizer utilizing a dual-mode voltage-controlled oscillator (VCO). Mode imbalance in the dual-mode VCO is analyzed theoretically and compensated through the proposed symmetric figure-8 transformer and capacitor arrays. The compact mode-switching circuitry fundamentally eliminates mode ambiguity in multi-mode autonomous circuits. A computer-aided algorithm based on sequential least-squares programming (SLSQP) and hierarchical optimization method is developed to automatically optimize the capacitor array in the wideband VCO. The implemented dual-mode VCO suppresses the phase noise (PN) difference across the operating frequency range, which further enables a sub-sampling phase-locked loop (SSPLL) to achieve near-minimum jitter across a wide frequency range without loop gain adaptation. Fabricated in a 40-nm CMOS process, the wideband SSPLL covers the frequency range of 7.9–14.3 GHz with 14.1–17.2-mW power consumption and occupies only 0.18-mm $^2$ area. The SSPLL achieves better than $-$ 115-dBc/Hz in-band PN at a 10-GHz carrier. The rms jitter is less than 85 fs across the whole frequency range. The corresponding figure-of-merit tuning (FoM $_T$ ) is $-$ 247.1 to $-$ 248.1 dB.
- 6 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 9 (17) , 15525-15537
A Highly Integrated Passive Wireless Sensing System With Synchronized Data Streaming of Multiple Tags
This paper introduces a highly integrated passive wireless sensing system based on extended EPC Gen2 protocol, using sensor tags and a reader to support concurrent data streams from multiple sensors. Multiple Subcarrier Multiple Access (MSMA) is used by assigning different subcarrier frequencies to the sensor tags for backscattering so that each tag has an independent channel for communication to achieve the simultaneous streaming of multi-sensor data. In order to improve the subcarrier frequency accuracy and further increase the number of communication channels, this paper proposes a novel method of subcarrier frequency calibration based on the Gen2 protocol. This method enables a high accuracy clock to be generated on-chip. At the same time, this paper also proposes a method based on Gen2 protocol to start a group of tags and receive real-time data in parallel. The tag chip is fabricated in a 0.18 μm CMOS process with a die size of 850 μm × 850 μm, and the reader prototype is built using software-defined radio equipment. The test results show that the sensing system proposed in this paper can collect and recognize concurrent data streams from multiple sensor tags synchronously. The measured sensitivity of the sensor tag is -14.9dBm with a 3-axis accelerating sensor, and the calibration accuracy of subcarrier frequency is better than ±0.385KHz in the range of 40KHz-640KHz. With this accuracy, the tags can be allocated up to 78 subcarrier communication channels theoretically.
- 6 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 9 (17) , 15525-15537
A Highly Integrated Passive Wireless Sensing System With Synchronized Data Streaming of Multiple Tags
This paper introduces a highly integrated passive wireless sensing system based on extended EPC Gen2 protocol, using sensor tags and a reader to support concurrent data streams from multiple sensors. Multiple Subcarrier Multiple Access (MSMA) is used by assigning different subcarrier frequencies to the sensor tags for backscattering so that each tag has an independent channel for communication to achieve the simultaneous streaming of multi-sensor data. In order to improve the subcarrier frequency accuracy and further increase the number of communication channels, this paper proposes a novel method of subcarrier frequency calibration based on the Gen2 protocol. This method enables a high accuracy clock to be generated on-chip. At the same time, this paper also proposes a method based on Gen2 protocol to start a group of tags and receive real-time data in parallel. The tag chip is fabricated in a 0.18 μm CMOS process with a die size of 850 μm × 850 μm, and the reader prototype is built using software-defined radio equipment. The test results show that the sensing system proposed in this paper can collect and recognize concurrent data streams from multiple sensor tags synchronously. The measured sensitivity of the sensor tag is -14.9dBm with a 3-axis accelerating sensor, and the calibration accuracy of subcarrier frequency is better than ±0.385KHz in the range of 40KHz-640KHz. With this accuracy, the tags can be allocated up to 78 subcarrier communication channels theoretically.
- 28 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (5) , 403-405
A 2.4-GHz Sub-Sampling PLL With an Adaptive and No Power Contribution FLL Achieving 103.58 fs rms Jitter and −257.8 dB FOM
A sub-sampling PLL (SSPLL) employing an adaptive frequency-locked loop (FLL) without static power consumption is proposed in this letter. A new unlock detection mechanism and a configurable PFD are realized in the adaptive FLL. With the new unlock detection mechanism, while the FLL that contains phase detector, divider, and charge pump dissipates no power during the locked steady state, it automatically starts when external interferences disturb the locked state. The optimized dead zone in the configurable PFD ensures a rapid relocking operation. Based on the proposed adaptive FLL, the 2.4 GHz SSPLL is fabricated in a 40-nm CMOS process. It achieves −128.5 dBc/Hz at 1 MHz offset frequency and the rms jitter is 103.58 fs integrated from 10 k to 10 MHz. It consumes 1.55 mW at 1 V supply and achieves −257.8 dB FOM.
- 28 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 32 (5) , 403-405
A 2.4-GHz Sub-Sampling PLL With an Adaptive and No Power Contribution FLL Achieving 103.58 fs rms Jitter and −257.8 dB FOM
A sub-sampling PLL (SSPLL) employing an adaptive frequency-locked loop (FLL) without static power consumption is proposed in this letter. A new unlock detection mechanism and a configurable PFD are realized in the adaptive FLL. With the new unlock detection mechanism, while the FLL that contains phase detector, divider, and charge pump dissipates no power during the locked steady state, it automatically starts when external interferences disturb the locked state. The optimized dead zone in the configurable PFD ensures a rapid relocking operation. Based on the proposed adaptive FLL, the 2.4 GHz SSPLL is fabricated in a 40-nm CMOS process. It achieves −128.5 dBc/Hz at 1 MHz offset frequency and the rms jitter is 103.58 fs integrated from 10 k to 10 MHz. It consumes 1.55 mW at 1 V supply and achieves −257.8 dB FOM.