ZYZhenyu Yang

Zhenyu Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhenyu Yang has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design and Properties of SQUID Sensors With Octagonal Double Transformer for Cryogenic Current Comparator

    by Da Xu, Qing Chen, Zhenyu Yang, Jinjin Li, Wenhui Cao, Wei Li, Kunli Zhou, Yunfeng Lu, Jianting Zhao, Qing Zhong

    Superconducting quantum interference devices (SQUIDs) with large input inductance and octagonal double transformer were designed and fabricated using Nb/Al-AlOx/Nb Josephson junctions for cryogenic current comparator. A 30-turn input coil of 1.5 μH is coupled to a large octagonal transformer of 3.6 nH, the counterpart of transformer is a 1.5-turn coil of 3.0 nH coupled to a second-order gradiometric SQUID of 97 pH. The octagonal double transformer makes low-inductance SQUID easily match to the large-inductance input coil. A current sensitivity of 1.1 μA/Φ0, a flux noise of 3.8 μΦ0/√Hz at 4 kHz and 9.7 μΦ0/√Hz at 1 Hz were achieved at 4.2 K. Another SQUID sensor with 10-turn input coil of 0.5 μH coupled to a large octagonal transformer of 6.0 nH, which is coupled to a first-order gradiometric SQUID of 580 pH, achieves a lower current sensitivity of 0.5 μA/Φ0 and a flux noise of 17 μΦ0/√Hz at 4 kHz.


  • Measurement of the Resistor Load Effect Using the Combined Quantum Hall Resistance

    by Zhenyu Yang, Yunfeng Lu, Jianting Zhao, Hongxing Yang, Qing He

    The accurate measurement of the resistor load effect is necessary for precision resistance transfer, especially in international comparisons. In this paper, a method to evaluate the resistor load effect using the combined quantum hall resistance (QHR) is proposed. The cryogenic current comparator (CCC) is selected to achieve optimal comparison performance. With the combined QHR device composed of 4 GaAs QHR in series and parallel as the reference, the compare load limitation is enlarged, while the resistance with the single QHR is maintained. This contributes to a reliable method for high-precision resistance transfer under different loads. Afterward, the QHR combining contact resistor model is established and analyzed. Finally, a series of experiments between the combined QHR and the measured 100 Ω resistor are performed with different currents. The resistor load coefficient is deduced as - 1.69×10 -9 /mW with fitted uncertainty of 8.28×10 -11 /mW; and its effectiveness is validated by calculating fitted resistance deviation.


  • An ADRC Strategy With Sequential Output Stacking Extended State Observers to Evaluate Hydraulic Torque for a Continuous-Wave Pulse Generator

    by Zhidan Yan, Shiyan Deng, Zhenyu Yang, Yanping Wang, Yunfeng Lu, Xiucai Shi

    The quality of pressure signals is intricately linked to the speed variation characteristics of the permanent magnet synchronous motor (PMSM) employed to drive the rotor of the continuous wave pulse generator. However, achieving precise control of PMSM is significantly challenged by complex and time-varying drilling operating conditions. A serial n ADRC (S n ADRC) is presented to increase the control motor's immunity and dynamic performance, where “ n ” indicates the number of sequential output stacking extended state observers (SOS-ESOs) equal to the highest order of the disturbance. Based on the deduced continuous wave pulse generator rotor model, first-order SOS-ESO is intended to detect the first-order disturbance, with the higher order SOS-ESO designed to anticipate the residual disturbances in order to accomplish real-time and precise hydraulic torque prediction. Moreover, the estimation performance of SOS-ESO is analyzed, and the intrinsic stability of S n ADRC with the speed loop control system is rigorously demonstrated using the Lyapunov theory. Additionally, SOS-ESO is employed in simulation to resist polynomial disturbances, and it is discovered that the n thorder SOS-ESO may successfully suppress complex disturbances up to ( n -1) order. Finally, the control performance of S n ADRC is compared to that of classical control methods in both the simulation and experiment, and the results show that S n ADRC has excellent rapidity and stability in motor control, which opens up a wide range of possibilities for practical applications in control and engineering fields.


  • Double DOF Strategy for Continuous-Wave Pulse Generator based on Extended Kalman Filter and Adaptive Linear Active Disturbance Rejection Control

    by Zhenyu Yang, Zhidan Yan, Yunfeng Lu, Weiliang Wang, Liandong Yu, Yanfeng Geng

    Permanent magnet synchronous motor (PMSM) has been widely employed in the continuous-wave pulse generator and exhibits advanced performance. However, its applications are constrained to some extent, because of the alternating load shocks and measurement resolution, etc. To cope with these issues, a double degree-of-freedom (DOF) control strategy that combines the extended Kalman filter (EKF) and adaptive linear active disturbance rejection control (LADRC) is proposed to realize fast dynamic response and strong anti-interference capability. The EKF is established according to the PMSM motion model to filter measurement noise and generate external disturbance estimations in a timely manner and reduce the observed burden of adaptive LADRC. The LADRC characteristics are analyzed to highlight conflicts between dynamic response and noise suppression under different observer and system bandwidths. Then, adaptive bandwidth laws are constructed. Finally, the simulation and experimental results are achieved to verify the effectiveness of the proposed strategy for the PMSM control system. It is believed that the striking advantages of such a method render it very suitable and powerful for the speed control of a continuous-wave pulse generator.