Baozhu Du
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Baozhu Du has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Zhan Shu
Department of Electrical and Computer Engineering, University of Alberta, Edmonton, AB, Canada
5 shared publications - James Lam
Department of Mechanical Engineering, The University of Hong Kong, Hong Kong, China
4 shared publications James Lam
Department of Mechanical Engineering, The University of Hong Kong, Pokfulam Road, Hong Kong, P. R. China
2 shared publications- Junfeng Zhang
School of Information and Communication Engineering Hainan University Haikou China
2 shared publications Ying Chen
Southwest China Inst Elect Technol, Chengdu, Peoples R China
2 shared publications- Ying Chen
Southwest China Institute of Electronic Technology, Chengdu, China
2 shared publications
Latest Publications
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/CAA Journal of Automatica Sinica
- Vol. 13 (9) , 2146-2162
LSTM Networks-Based Data-Driven Secure Synchronization of Interconnected Systems with Malicious Subsystems
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/CAA Journal of Automatica Sinica
- Vol. 13 (9) , 2146-2162
LSTM Networks-Based Data-Driven Secure Synchronization of Interconnected Systems with Malicious Subsystems
- 20 April 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. PP (15) , 1
Enhanced Lyapunov-Based Model Predictive Control for Wheeled Mobile Robot with Improved Tunnel Performance Constraints
This study addresses the maneuvering control problem of a wheeled mobile robot (WMR) operating in dynamic and uncertain environments, where smooth error convergence and robustness against external disturbances are critical challenges. An enhanced Lyapunov-based model predictive control (ELMPC) method is developed, in which an improved tunnel performance function is incorporated into an auxiliary controller to impose stricter contraction constraints on the WMR system, enabling smoother and faster error convergence. In addition, an improved tunnel performance constraint (ITPC) scheme is introduced to eliminate the initial-condition dependence of conventional prescribed performance control. By employing a performance transition function, the ITPC ensures that performance bounds are satisfied under arbitrary initial errors while avoiding excessive transient responses. To compensate for unknown and time-varying disturbances, a neural network–based disturbance predictor is integrated into the control architecture. The predictor estimates disturbances online and transforms tracking errors into prediction errors, thereby accelerating convergence and enhancing robustness. The proposed control strategy is implemented within a Lyapunov-based model predictive control framework with explicit consideration of actuator constraints, where contraction constraints guarantee closed-loop stability and recursive feasibility. Experimental results demonstrate improved tracking performance, robustness, and constraint satisfaction under complex operating conditions.
- 20 April 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. PP (15) , 1
Enhanced Lyapunov-Based Model Predictive Control for Wheeled Mobile Robot with Improved Tunnel Performance Constraints
This study addresses the maneuvering control problem of a wheeled mobile robot (WMR) operating in dynamic and uncertain environments, where smooth error convergence and robustness against external disturbances are critical challenges. An enhanced Lyapunov-based model predictive control (ELMPC) method is developed, in which an improved tunnel performance function is incorporated into an auxiliary controller to impose stricter contraction constraints on the WMR system, enabling smoother and faster error convergence. In addition, an improved tunnel performance constraint (ITPC) scheme is introduced to eliminate the initial-condition dependence of conventional prescribed performance control. By employing a performance transition function, the ITPC ensures that performance bounds are satisfied under arbitrary initial errors while avoiding excessive transient responses. To compensate for unknown and time-varying disturbances, a neural network–based disturbance predictor is integrated into the control architecture. The predictor estimates disturbances online and transforms tracking errors into prediction errors, thereby accelerating convergence and enhancing robustness. The proposed control strategy is implemented within a Lyapunov-based model predictive control framework with explicit consideration of actuator constraints, where contraction constraints guarantee closed-loop stability and recursive feasibility. Experimental results demonstrate improved tracking performance, robustness, and constraint satisfaction under complex operating conditions.
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 10, 2269-2274
Dynamic State-Feedback Synthesis for Positive Systems With Nonnegative Inputs
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 10, 2269-2274
Dynamic State-Feedback Synthesis for Positive Systems With Nonnegative Inputs
- Open Access
- 14 November 2025
- Published by Association for Computing Machinery (ACM)
- p. 143-148
An AI-Enhanced System with Microwave-Functionalized Water for Sustainable Cultivation of Dendrobium officinale
- 14 November 2025
- Published by Association for Computing Machinery (ACM)
- p. 143-148
Open AccessAn AI-Enhanced System with Microwave-Functionalized Water for Sustainable Cultivation of Dendrobium officinale
- 1 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (17) , 33519-33527
Noncontact Current Measurement Based on 3-D TMR Sensor Array
This paper proposed a non-contact current measurement system for in-wall concealed conductors using a three-dimensional (3-D) tunnel magnetoresistive (TMR) sensor array. The system employs a linear strip array of three coaxial, collinear TMR sensors (S1, S2, S3) with an optimal spacing of 15 mm, designed to detect magnetic fields in three spatial dimensions without physical contact or wall damage. To address positional deviations, including horizontal displacement (eccentricity up to 3 mm) and angular tilt (up to 30 degrees), a geometric correction algorithm is developed based on Biot-Savart law and sensor output ratios; this algorithm calculates the conductor’s intersection point and direction vector to correct for errors. For crosstalk from adjacent wires, a dual-conductor optimization model is introduced, leveraging the Levenberg-Marquardt method to solve nonlinear equations and minimize interference effects in scenarios with parallel conductors (e.g., spacing from 10–50 mm). Implemented with the AK09940A sensor (10 nT/LSB resolution, ±1200 μT range, and 40–70 nT RMS noise in low-noise mode), the system achieves a signal-to-noise ratio (SNR) of 50.7–66.9 dB through hardware calibration and averaging of 100 samples. Experimental validation under complex conditions—including horizontal displacement, tilt, and interfering conductors—demonstrates a relative error of less than 2% for currents of 15–40 A at burial depths of 20–40 mm, confirming high accuracy and robustness for building electrical safety applications.
- 1 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (17) , 33519-33527
Noncontact Current Measurement Based on 3-D TMR Sensor Array
This paper proposed a non-contact current measurement system for in-wall concealed conductors using a three-dimensional (3-D) tunnel magnetoresistive (TMR) sensor array. The system employs a linear strip array of three coaxial, collinear TMR sensors (S1, S2, S3) with an optimal spacing of 15 mm, designed to detect magnetic fields in three spatial dimensions without physical contact or wall damage. To address positional deviations, including horizontal displacement (eccentricity up to 3 mm) and angular tilt (up to 30 degrees), a geometric correction algorithm is developed based on Biot-Savart law and sensor output ratios; this algorithm calculates the conductor’s intersection point and direction vector to correct for errors. For crosstalk from adjacent wires, a dual-conductor optimization model is introduced, leveraging the Levenberg-Marquardt method to solve nonlinear equations and minimize interference effects in scenarios with parallel conductors (e.g., spacing from 10–50 mm). Implemented with the AK09940A sensor (10 nT/LSB resolution, ±1200 μT range, and 40–70 nT RMS noise in low-noise mode), the system achieves a signal-to-noise ratio (SNR) of 50.7–66.9 dB through hardware calibration and averaging of 100 samples. Experimental validation under complex conditions—including horizontal displacement, tilt, and interfering conductors—demonstrates a relative error of less than 2% for currents of 15–40 A at burial depths of 20–40 mm, confirming high accuracy and robustness for building electrical safety applications.
- 8 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/CAA Journal of Automatica Sinica
- Vol. 11 (11) , 2298-2315
A Double Sensitive Fault Detection Filter for Positive Markovian Jump Systems with A Hybrid Event-Triggered Mechanism
This paper is concerned with the double sensitive fault detection filter for positive Markovian jump systems. A new hybrid adaptive event-triggered mechanism is proposed by introducing a non-monotonic adaptive law. A linear adaptive event-triggered threshold is established by virtue of 1-norm inequality. Under such a triggering strategy, the original system can be transformed into an interval uncertain system. By using a stochastic copositive Lyapunov function, an asynchronous fault detection filter is designed for positive Markovian jump systems (PMJSs) in terms of linear programming. The presented filter satisfies both $L_{-}$ -gain ( $\ell_{-}$ -gain) fault sensitivity and $L_{1}\ (\ell_{1})$ internal differential privacy sensitivity. The proposed approach is also extended to the discrete-time case. Finally, two examples are provided to illustrate the effectiveness of the proposed design.- 8 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/CAA Journal of Automatica Sinica
- Vol. 11 (11) , 2298-2315
A Double Sensitive Fault Detection Filter for Positive Markovian Jump Systems with A Hybrid Event-Triggered Mechanism
This paper is concerned with the double sensitive fault detection filter for positive Markovian jump systems. A new hybrid adaptive event-triggered mechanism is proposed by introducing a non-monotonic adaptive law. A linear adaptive event-triggered threshold is established by virtue of 1-norm inequality. Under such a triggering strategy, the original system can be transformed into an interval uncertain system. By using a stochastic copositive Lyapunov function, an asynchronous fault detection filter is designed for positive Markovian jump systems (PMJSs) in terms of linear programming. The presented filter satisfies both $L_{-}$ -gain ( $\ell_{-}$ -gain) fault sensitivity and $L_{1}\ (\ell_{1})$ internal differential privacy sensitivity. The proposed approach is also extended to the discrete-time case. Finally, two examples are provided to illustrate the effectiveness of the proposed design.- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 69 (12) , 8812-8819
KYP Lemma for Cone-Preserving Systems and Its Applications to Controller Design
This paper presents a new version of the Kalman Yakubovich-Popov (KYP) Lemma for linear systems with their states constrained in proper cones. Based on this lemma, two important applications are introduced. One is the stabilization controller design to satisfy the spectral radius performance while preserving cone invariance. The other is to obtain an H∞ state-feedback controller such that both H∞ performance and cone invariance are guaranteed. Moreover, to address these two problems, a practical algorithm based on the linear matrix inequality is provided. Finally, two numerical examples on a linear system defined in the second-order cone are used to illustrate the results.
- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 69 (12) , 8812-8819
KYP Lemma for Cone-Preserving Systems and Its Applications to Controller Design
This paper presents a new version of the Kalman Yakubovich-Popov (KYP) Lemma for linear systems with their states constrained in proper cones. Based on this lemma, two important applications are introduced. One is the stabilization controller design to satisfy the spectral radius performance while preserving cone invariance. The other is to obtain an H∞ state-feedback controller such that both H∞ performance and cone invariance are guaranteed. Moreover, to address these two problems, a practical algorithm based on the linear matrix inequality is provided. Finally, two numerical examples on a linear system defined in the second-order cone are used to illustrate the results.
- 18 October 2023
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 360 (18) , 14443-14453
Reachable set estimation for positive linear discrete-time systems under the constrained disturbance
- 18 October 2023
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 360 (18) , 14443-14453
Reachable set estimation for positive linear discrete-time systems under the constrained disturbance
- 6 September 2022
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
- Vol. 237 (1) , 35-42
Non-overshoot tracking control for positive continuous-time linear systems
This article focuses on state and output tracking control for positive continuous-time linear systems without overshoot. Linear state feedback controllers are designed respectively to ensure both the system state, and output can unilateral track the reference state and output. In addition, using Lyapunov direct method, the exponential convergence rate of tracking system is calculated. A numerical example is given to demonstrate the effectiveness of the proposed method.
- 6 September 2022
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
- Vol. 237 (1) , 35-42
Non-overshoot tracking control for positive continuous-time linear systems
This article focuses on state and output tracking control for positive continuous-time linear systems without overshoot. Linear state feedback controllers are designed respectively to ensure both the system state, and output can unilateral track the reference state and output. In addition, using Lyapunov direct method, the exponential convergence rate of tracking system is calculated. A numerical example is given to demonstrate the effectiveness of the proposed method.
- 1 November 2020
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 357 (17) , 12571-12587
On positively invariant polyhedrons for continuous-time positive linear systems
- 1 November 2020
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 357 (17) , 12571-12587
On positively invariant polyhedrons for continuous-time positive linear systems