Grit Häuschen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Grit Häuschen has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Dina Fattakhova-Rohlfing
Materials Synthesis and Processing IMD‐2 Institute of Energy Materials and Devices Forschungszentrum Jülich GmbH Jülich Germany
2 shared publications - Martin Finsterbusch
Forschungszentrum Jülich GmbH
2 shared publications - Alexandra C. Moy
Department of Materials Science and Engineering, University of Michigan, Ann Arbor, MI, 48109, USA
1 shared publication - Christian Schwab
Forschungszentrum Jülich GmbH
1 shared publication - Christoph Roitzheim
Forschungszentrum Jülich GmbH, Institute of Energy Materials and Devices: Materials Synthesis and Processing (IMD-2), Jülich, Germany
1 shared publication - Jeff Sakamoto
Department of Materials Science and Engineering, University of Michigan, Ann Arbor, MI 48109, USA
1 shared publication
Latest Publications
- Open Access
- 17 February 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 11 (11) , 5670-5680
Towards economic processing of high performance garnets – case study on zero Li excess Ga-substituted LLZO
In this processing study we systematically investigate the impact of lithium excess and dwell time on Ga-substituted LLZO (Li6.4Ga0.2La3Zr2O12). To draw a holistic picture of the underlying dependencies for maximum performance, we study the composition, phase formation, density and microstructure, especially with respect to the grain boundaries, in detail. For the first time, we show that Li-excess during synthesis and processing is not just unnecessary for LLZO:Ga, but that high amounts of Li excess can also prevent obtaining peak performance or increase energy and precursor consumption to a non-feasible level for industrial application. We show that the underlying mechanism is an intricate interplay between phase equilibria of different phases (tetragonal, cubic, Li–La–Ga), which have good conductivity and/or act as sintering aids (in low amounts) but are detrimental to electrochemical performance in large amounts. Based on this understanding, we developed a reproducible and robust processing route for LLZO:Ga, minimizing Li excess and dwell time while maintaining high conductivity in the final component. This can make the LLZO family more viable for application in high energy density all-solid-state batteries and provide a pathway for economic industrial processing.
- 17 February 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 11 (11) , 5670-5680
Open AccessTowards economic processing of high performance garnets – case study on zero Li excess Ga-substituted LLZO
In this processing study we systematically investigate the impact of lithium excess and dwell time on Ga-substituted LLZO (Li6.4Ga0.2La3Zr2O12). To draw a holistic picture of the underlying dependencies for maximum performance, we study the composition, phase formation, density and microstructure, especially with respect to the grain boundaries, in detail. For the first time, we show that Li-excess during synthesis and processing is not just unnecessary for LLZO:Ga, but that high amounts of Li excess can also prevent obtaining peak performance or increase energy and precursor consumption to a non-feasible level for industrial application. We show that the underlying mechanism is an intricate interplay between phase equilibria of different phases (tetragonal, cubic, Li–La–Ga), which have good conductivity and/or act as sintering aids (in low amounts) but are detrimental to electrochemical performance in large amounts. Based on this understanding, we developed a reproducible and robust processing route for LLZO:Ga, minimizing Li excess and dwell time while maintaining high conductivity in the final component. This can make the LLZO family more viable for application in high energy density all-solid-state batteries and provide a pathway for economic industrial processing.
- 28 September 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (41) , 21955-21972
The effects of aluminum concentration on the microstructural and electrochemical properties of lithium lanthanum zirconium oxide
Cubic lithium lanthanum zirconium oxide (Li7−xAlxLa3Zr2O12, LLZO) garnet has gained attention as a promising next-generation electrolyte for lithium batteries due to its high ionic conductivity and chemical stability with lithium metal. The high conductivity can be achieved through doping over a range of aluminum concentrations. In this study, we hot-pressed samples to achieve x = 0.25–0.55 mol to understand the effect of aluminum on microstructure and electrochemistry. It was observed that beyond the aluminum solubility limit (x = ∼0.40), resistive secondary phases formed at the grain boundaries. As a result, the percent grain boundary resistance increased from 17.6 to 41.2% for x = 0.25 and x = 0.55, respectively. Both the grain boundary and bulk activation energies remained relatively constant as the aluminum concentrations increased (∼0.44 eV and ∼0.39 eV, respectively). It was, therefore, surmised that the mobility term of the Nernst–Einstein equation was roughly independent of aluminum concentration and the major variable controlling bulk conductivity was the number of lithium charge carriers. As a result, as the aluminum concentration increased from x = 0.25 to x = 0.55 the bulk conductivity decreased from 0.56 to 0.15 mS cm−1. Following these trends of increasing grain boundary resistance and decreasing bulk conductivity with increasing aluminum concentration, x = 0.25 had the highest total conductivity (0.46 mS cm−1). We demonstrated that aluminum concentration has a significant effect on the microstructure and electrochemical properties of LLZO. We believe this work could help understand how to link processing, microstructure, and electrochemical properties to guide the manufacturing of LLZO for use in solid-state batteries.
- 28 September 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (41) , 21955-21972
The effects of aluminum concentration on the microstructural and electrochemical properties of lithium lanthanum zirconium oxide
Cubic lithium lanthanum zirconium oxide (Li7−xAlxLa3Zr2O12, LLZO) garnet has gained attention as a promising next-generation electrolyte for lithium batteries due to its high ionic conductivity and chemical stability with lithium metal. The high conductivity can be achieved through doping over a range of aluminum concentrations. In this study, we hot-pressed samples to achieve x = 0.25–0.55 mol to understand the effect of aluminum on microstructure and electrochemistry. It was observed that beyond the aluminum solubility limit (x = ∼0.40), resistive secondary phases formed at the grain boundaries. As a result, the percent grain boundary resistance increased from 17.6 to 41.2% for x = 0.25 and x = 0.55, respectively. Both the grain boundary and bulk activation energies remained relatively constant as the aluminum concentrations increased (∼0.44 eV and ∼0.39 eV, respectively). It was, therefore, surmised that the mobility term of the Nernst–Einstein equation was roughly independent of aluminum concentration and the major variable controlling bulk conductivity was the number of lithium charge carriers. As a result, as the aluminum concentration increased from x = 0.25 to x = 0.55 the bulk conductivity decreased from 0.56 to 0.15 mS cm−1. Following these trends of increasing grain boundary resistance and decreasing bulk conductivity with increasing aluminum concentration, x = 0.25 had the highest total conductivity (0.46 mS cm−1). We demonstrated that aluminum concentration has a significant effect on the microstructure and electrochemical properties of LLZO. We believe this work could help understand how to link processing, microstructure, and electrochemical properties to guide the manufacturing of LLZO for use in solid-state batteries.