Guadalupe Vianey Landeros Gonzalez
Research Subjects
Research Interests
Guadalupe Vianey Landeros Gonzalez has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Gabriela Domínguez-Cortinas
Centre of Applied Research in Environment and Health, Faculty of Medicine,Autonomous University of San Luis Potosi,Mexico
2 shared publications - Ian David Williams
School of Engineering, Faculty of Engineering and Physical Sciences, University of Southampton, Highfield Campus, Southampton SO17 1BJ, United Kingdom
2 shared publications - Malcolm D. Hudson
Centre for Environmental Science, School of Geography & Environmental Science,University of Southampton,United Kingdom of Great Britain and Northern Ireland
2 shared publications - Peter. J. Shaw
School of Geography and Environmental Science, University of Southampton, Southampton, United Kingdom
2 shared publications
Latest Publications
- 24 January 2025
- Published by Eurowaste SRL in Detritus
- No. 30,p. 84-98
Where do they go? A review of the wastewater treatment process and its impact on the fate of microplastics
Wastewater treatment plants (WWTPs) are facilities designed to sanitise wastewater (WW) from different sources. A WW treatment process combines physical, chemical and biological reactions divided into 3 or 4 stages, according to the effluent standards of each site. WWTPs are intended to remove certain pollutants from the water stream, but not microplastics (MPs), plastic particles ranging from 5 mm to 1 µm. WWTPs work as source and destination for MPs. This review provides an insight into the stages included in WW treatment processes according to different technologies employed, alongside a critical evaluation of their influence on MPs. Relevant information and knowledge gaps have been identified. The removal of MPs depends on a variety of factors than just the type of incoming water or WWTP location. The most significant removal of MPs from WW occurs during the preliminary and primary stages. MPs removal efficiency fluctuates depending on the systems operating during the secondary and tertiary phases. As the comparison of information between studies is complicated due to the units and terms used to report and label the collected WW, we recommend that (1) kg/day units are applied if mass balance is of interest, and number of particles per L/day, considering the flow rate data from the sampling dates or annual average flow; (2) to further explain the selection criteria to classify MPs based on their size; and (3) to reach a consensus to name and identify the sampling points, such as the raw WW and effluent from the next stages.
- 24 January 2025
- Published by Eurowaste SRL in Detritus
- No. 30,p. 84-98
Where do they go? A review of the wastewater treatment process and its impact on the fate of microplastics
Wastewater treatment plants (WWTPs) are facilities designed to sanitise wastewater (WW) from different sources. A WW treatment process combines physical, chemical and biological reactions divided into 3 or 4 stages, according to the effluent standards of each site. WWTPs are intended to remove certain pollutants from the water stream, but not microplastics (MPs), plastic particles ranging from 5 mm to 1 µm. WWTPs work as source and destination for MPs. This review provides an insight into the stages included in WW treatment processes according to different technologies employed, alongside a critical evaluation of their influence on MPs. Relevant information and knowledge gaps have been identified. The removal of MPs depends on a variety of factors than just the type of incoming water or WWTP location. The most significant removal of MPs from WW occurs during the preliminary and primary stages. MPs removal efficiency fluctuates depending on the systems operating during the secondary and tertiary phases. As the comparison of information between studies is complicated due to the units and terms used to report and label the collected WW, we recommend that (1) kg/day units are applied if mass balance is of interest, and number of particles per L/day, considering the flow rate data from the sampling dates or annual average flow; (2) to further explain the selection criteria to classify MPs based on their size; and (3) to reach a consensus to name and identify the sampling points, such as the raw WW and effluent from the next stages.
- Open Access
- 30 September 2022
- Published by Eurowaste SRL in Detritus
- Vol. 20 (20) , 41-55
A Review of the Origins of Microplastics arriving at Wastewater Treatment Plants
Concerns regarding the impacts of microplastics in the global environment have brought into focus the need to understand better their origins, transport, and fate. Wastewaters (WW) are important in this regard: discharges from households, commercial and industrial premises, and surface run-off deliver microplastics to wastewater treatment plants (WWTPs) via sewerage systems, through which they are removed along with sewage sludge or destined for release into the environment in treated effluent. This review provides a contemporary and critical analysis of factors influencing the quantities and composition of microplastics (MPs) reaching wastewater treatment plants, including both primary and secondary sources. Three specific areas of concern were highlighted. First, current legislation, where present, needs to address regulation of microplastics in personal care and cosmetic products that cross international borders. Secondly, accurate estimation of microplastics arising from some sources and activities (e.g., mis-managed waste and hand washing of textiles) is challenging and estimated contributions of associated microplastics remain unsatisfactory as a basis for management decisions. Thirdly, information relating to microplastics in personal care and cosmetic products used by male consumers is lacking and contributions of such products to wastewater remain uncertain. We recommend that (1) voluntary practices and programmes should be replaced with formal regulation to achieve compliance, and (2) the role of consumers’ behaviour in generating microplastics that are destined for wastewater treatment plants remains largely unknown and that more research in this domain is needed.
- 30 September 2022
- Published by Eurowaste SRL in Detritus
- Vol. 20 (20) , 41-55
Open AccessA Review of the Origins of Microplastics arriving at Wastewater Treatment Plants
Concerns regarding the impacts of microplastics in the global environment have brought into focus the need to understand better their origins, transport, and fate. Wastewaters (WW) are important in this regard: discharges from households, commercial and industrial premises, and surface run-off deliver microplastics to wastewater treatment plants (WWTPs) via sewerage systems, through which they are removed along with sewage sludge or destined for release into the environment in treated effluent. This review provides a contemporary and critical analysis of factors influencing the quantities and composition of microplastics (MPs) reaching wastewater treatment plants, including both primary and secondary sources. Three specific areas of concern were highlighted. First, current legislation, where present, needs to address regulation of microplastics in personal care and cosmetic products that cross international borders. Secondly, accurate estimation of microplastics arising from some sources and activities (e.g., mis-managed waste and hand washing of textiles) is challenging and estimated contributions of associated microplastics remain unsatisfactory as a basis for management decisions. Thirdly, information relating to microplastics in personal care and cosmetic products used by male consumers is lacking and contributions of such products to wastewater remain uncertain. We recommend that (1) voluntary practices and programmes should be replaced with formal regulation to achieve compliance, and (2) the role of consumers’ behaviour in generating microplastics that are destined for wastewater treatment plants remains largely unknown and that more research in this domain is needed.