Daniele Vella
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Daniele Vella has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Aleš Babnik
Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva ulica 6, 1000 Ljubljana, Slovenia
2 shared publications Aljaž Drnovšek
Jožef Stefan Institute, Department of Thin Films and Surfaces, Jamova 39, 1000 Ljubljana, Slovenia
2 shared publications- Goki Eda
Department of Physics, National University of Singapore, Singapore 117542, Singapore
2 shared publications - Ivan Verzhbitskiy
Department of Physics, National University of Singapore, Singapore, Singapore
2 shared publications - Kenji Watanabe
National Institute for Materials Science
2 shared publications Matija Jezeršek
Faculty of Mechanical Engineering, Laboratory for Laser Techniques, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
2 shared publications
Latest Publications
- Open Access
- 13 January 2026
- Published by Elsevier in Photoacoustics
- Vol. 47, 100796
Ultrafast subwavelength CVD-graphene nanoheater for the generation of broadband photoacoustic waves
- 13 January 2026
- Published by Elsevier in Photoacoustics
- Vol. 47, 100796
Open AccessUltrafast subwavelength CVD-graphene nanoheater for the generation of broadband photoacoustic waves
- Open Access
- 9 October 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (19) , 10860
High-Intensity Focused Pressure Wave Generation via Q-Switched Er:YAG Laser with a Water Layer Formed by the Coupled Lens for Optoacoustic Conversion
We demonstrate coating-free optoacoustic generation and focusing of ultrasound using a mechanically Q-switched (MQS) erbium-doped yttrium aluminum garnet (Er:YAG) source (~100 ns, ≤20 mJ) combined with a concave water interface that simultaneously serves as converter and acoustic lens. Axial, lateral, and focal-point measurements mapped the pressure field while varying beam diameter (2w = 5–15 mm) and pulse energy (E = 10–20 mJ). The maximum focal positive pressure (Pmax = 7 MPa) occurs at an intermediate diameter (~10 mm), whereas the tightest lateral/axial confinement and strongest spectral enhancement arise at larger diameters (14–15 mm) with fc = ~5 MHz and −6 dB bandwidth up to 7 MHz. Pressure increases nearly monotonically with energy. For equal fluence, larger diameters yield higher focal pressures due to greater focusing gain. Small beams (2w ≈ 5–7 mm) show shorter apparent time-of-flight (TOF) and waveform broadening, consistent with early shock-like emission from locally vaporizing region. These results provide practical rules for tuning amplitude, spectrum, and confinement, enabling sub-millimeter focusing for contamination-sensitive and therapeutic applications.
- 9 October 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (19) , 10860
Open AccessHigh-Intensity Focused Pressure Wave Generation via Q-Switched Er:YAG Laser with a Water Layer Formed by the Coupled Lens for Optoacoustic Conversion
We demonstrate coating-free optoacoustic generation and focusing of ultrasound using a mechanically Q-switched (MQS) erbium-doped yttrium aluminum garnet (Er:YAG) source (~100 ns, ≤20 mJ) combined with a concave water interface that simultaneously serves as converter and acoustic lens. Axial, lateral, and focal-point measurements mapped the pressure field while varying beam diameter (2w = 5–15 mm) and pulse energy (E = 10–20 mJ). The maximum focal positive pressure (Pmax = 7 MPa) occurs at an intermediate diameter (~10 mm), whereas the tightest lateral/axial confinement and strongest spectral enhancement arise at larger diameters (14–15 mm) with fc = ~5 MHz and −6 dB bandwidth up to 7 MHz. Pressure increases nearly monotonically with energy. For equal fluence, larger diameters yield higher focal pressures due to greater focusing gain. Small beams (2w ≈ 5–7 mm) show shorter apparent time-of-flight (TOF) and waveform broadening, consistent with early shock-like emission from locally vaporizing region. These results provide practical rules for tuning amplitude, spectrum, and confinement, enabling sub-millimeter focusing for contamination-sensitive and therapeutic applications.
- Open Access
Interferometric Fiber Optic Probe for Measurements of Cavitation Bubble Expansion Velocity and Bubble Oscillation Time
Cavitation bubbles are used in medicine as a mechanism to generate shock waves. The study of cavitation bubble dynamics plays a crucial role in understanding and utilizing such phenomena for practical applications and purposes. Since the lifetime of cavitation bubbles is in the range of hundreds of microseconds and the radii are in the millimeter range, the observation of bubble dynamics requires complicated and expensive equipment. High-speed cameras or other optical techniques require transparent containers or at least a transparent optical window to access the region. Fiber optic probe tips are commonly used to monitor water pressure, density, and temperature, but no study has used a fiber tip sensor in an interferometric setup to measure cavitation bubble dynamics. We present how a fiber tip sensor system, originally intended as a hydrophone, can be used to track the expansion and contraction of cavitation bubbles. The measurement is based on interference between light reflected from the fiber tip surface and light reflected from the cavitation bubble itself. We used a continuous-wave laser to generate cavitation bubbles and a high-speed camera to validate our measurements. The shock wave resulting from the collapse of a bubble can also be measured with a delay in the order of 1 µs since the probe tip can be placed less than 1 mm away from the origin of the cavitation bubble. By combining the information on the bubble expansion velocity and the time of bubble collapse, the lifetime of a bubble can be estimated. The bubble expansion velocity is measured with a spatial resolution of 488 nm, half the wavelength of the measuring laser. Our results demonstrate an alternative method for monitoring bubble dynamics without the need for expensive equipment. The method is flexible and can be adapted to different environmental conditions, opening up new perspectives in many application areas.
Open AccessInterferometric Fiber Optic Probe for Measurements of Cavitation Bubble Expansion Velocity and Bubble Oscillation Time
Cavitation bubbles are used in medicine as a mechanism to generate shock waves. The study of cavitation bubble dynamics plays a crucial role in understanding and utilizing such phenomena for practical applications and purposes. Since the lifetime of cavitation bubbles is in the range of hundreds of microseconds and the radii are in the millimeter range, the observation of bubble dynamics requires complicated and expensive equipment. High-speed cameras or other optical techniques require transparent containers or at least a transparent optical window to access the region. Fiber optic probe tips are commonly used to monitor water pressure, density, and temperature, but no study has used a fiber tip sensor in an interferometric setup to measure cavitation bubble dynamics. We present how a fiber tip sensor system, originally intended as a hydrophone, can be used to track the expansion and contraction of cavitation bubbles. The measurement is based on interference between light reflected from the fiber tip surface and light reflected from the cavitation bubble itself. We used a continuous-wave laser to generate cavitation bubbles and a high-speed camera to validate our measurements. The shock wave resulting from the collapse of a bubble can also be measured with a delay in the order of 1 µs since the probe tip can be placed less than 1 mm away from the origin of the cavitation bubble. By combining the information on the bubble expansion velocity and the time of bubble collapse, the lifetime of a bubble can be estimated. The bubble expansion velocity is measured with a spatial resolution of 488 nm, half the wavelength of the measuring laser. Our results demonstrate an alternative method for monitoring bubble dynamics without the need for expensive equipment. The method is flexible and can be adapted to different environmental conditions, opening up new perspectives in many application areas.
- Open Access
- 13 October 2022
- Published by Elsevier in Photoacoustics
- Vol. 28, 100413
Ultrasonic photoacoustic emitter of graphene-nanocomposites film on a flexible substrate
- 13 October 2022
- Published by Elsevier in Photoacoustics
- Vol. 28, 100413
Open AccessUltrasonic photoacoustic emitter of graphene-nanocomposites film on a flexible substrate
- 22 December 2021
- Published by Wiley in Advanced Optical Materials
- Vol. 10 (4) , 2102132
In‐Plane Field‐Driven Excitonic Electro‐Optic Modulation in Monolayer Semiconductor
2D semiconductors are attractive candidates for on‐chip electro‐optic modulators due to their ease of integration and rich exciton‐mediated phenomena. While electrostatic doping and out‐of‐plane field effect have been extensively studied, in‐plane field‐induced phenomena remain largely unexplored. Here electro‐optic response of monolayer WSe 2 subject to modulating in‐plane electric fields probed by electroabsorption and electroreflectance spectroscopy is reported. The devices are found to exhibit spatially varying response near exciton resonance, which cannot be explained by predicted effects such as Pockels and excitonic Stark effect. It is shown that the modulation signal is dominated by exciton linewidth broadening and narrowing associated with local accumulation and depletion of free holes. The field and frequency dependence of the devices is distinct from those of charge modulation devices. The observed behavior is ascribed to elastic scattering of excitons with field‐driven intrinsic free carriers.
- 22 December 2021
- Published by Wiley in Advanced Optical Materials
- Vol. 10 (4) , 2102132
In‐Plane Field‐Driven Excitonic Electro‐Optic Modulation in Monolayer Semiconductor
2D semiconductors are attractive candidates for on‐chip electro‐optic modulators due to their ease of integration and rich exciton‐mediated phenomena. While electrostatic doping and out‐of‐plane field effect have been extensively studied, in‐plane field‐induced phenomena remain largely unexplored. Here electro‐optic response of monolayer WSe 2 subject to modulating in‐plane electric fields probed by electroabsorption and electroreflectance spectroscopy is reported. The devices are found to exhibit spatially varying response near exciton resonance, which cannot be explained by predicted effects such as Pockels and excitonic Stark effect. It is shown that the modulation signal is dominated by exciton linewidth broadening and narrowing associated with local accumulation and depletion of free holes. The field and frequency dependence of the devices is distinct from those of charge modulation devices. The observed behavior is ascribed to elastic scattering of excitons with field‐driven intrinsic free carriers.
- 1 January 2021
- Published by Optica Publishing Group
- p. EM1A.32
Microstructured Optoacoustic Lens of Black-TiOx for Focused Ultrasound and Confined Cavitation Bubbles
We present a laser induced ultrasound and the localization of cavitation bubbles using an optoacoustic spherical Ti/black-TiOx lens. Results demonstrate the possibility to localize cavities and secondary ablative effects into the subsurface tissue.
- 1 January 2021
- Published by Optica Publishing Group
- p. EM1A.32
Microstructured Optoacoustic Lens of Black-TiOx for Focused Ultrasound and Confined Cavitation Bubbles
We present a laser induced ultrasound and the localization of cavitation bubbles using an optoacoustic spherical Ti/black-TiOx lens. Results demonstrate the possibility to localize cavities and secondary ablative effects into the subsurface tissue.
- Open Access
- 15 February 2019
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 13 (3) , 3218-3224
Suppressed Out-of-Plane Polarizability of Free Excitons in Monolayer WSe2
Monolayer semiconductors are atomically thin quantum wells with strong confinement of electrons in two-dimensional (2D) plane. Here, we experimentally study the out-of-plane polarizability of excitons in hBN-encapsulated monolayer WSe2 in strong electric fields of up to 1.6 V/nm (16 MV/cm). We monitor free exciton photoluminescence peaks with increasing electric fields at a constant carrier density, carefully compensating for unintentional photodoping in our double-gated device at 4 K. We show that the Stark shift is smaller than 0.4 meV despite the large electric fields applied, yielding an upper limit of polarizability αz to be ~ 10-11 Dm/V. Such a small polarizability, which is nearly two orders of magnitude smaller than the previously reported value for MoS2, indicates strong atomic confinement of electrons in this 2D system and highlights the unusual robustness of free excitons against surface potential fluctuations.
- 15 February 2019
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 13 (3) , 3218-3224
Open AccessSuppressed Out-of-Plane Polarizability of Free Excitons in Monolayer WSe2
Monolayer semiconductors are atomically thin quantum wells with strong confinement of electrons in two-dimensional (2D) plane. Here, we experimentally study the out-of-plane polarizability of excitons in hBN-encapsulated monolayer WSe2 in strong electric fields of up to 1.6 V/nm (16 MV/cm). We monitor free exciton photoluminescence peaks with increasing electric fields at a constant carrier density, carefully compensating for unintentional photodoping in our double-gated device at 4 K. We show that the Stark shift is smaller than 0.4 meV despite the large electric fields applied, yielding an upper limit of polarizability αz to be ~ 10-11 Dm/V. Such a small polarizability, which is nearly two orders of magnitude smaller than the previously reported value for MoS2, indicates strong atomic confinement of electrons in this 2D system and highlights the unusual robustness of free excitons against surface potential fluctuations.