Banashree Samanta
Banashree Samanta has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Gargi Das
Department of Chemical Engineering, IIT Kharagpur 1 , Kharagpur, West Bengal 721302
4 shared publications Manish Kaushal
3 shared publicationsSubhabrata Ray
Indian Institute of Technology
3 shared publications- Subhabrata Ray
Process Consultant, P-408E, Santosh Mitra Sarani 3 , PO: Hijili Cooperative, Kharagpur, West Bengal 721302
3 shared publications Gargi Das
2 shared publications- Manish Kaushal
Department of Chemical Engineering, Indian Institute of Technology Kharagpur, Kharagpur, West Bengal 721302, India
2 shared publications
Latest Publications
- 27 March 2026
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 1032
Energy dissipation during laminar planar jump of a generalised time-independent non-Newtonian liquid – An analytical approach
This study presents an in-depth analysis of the energy dissipation and momentum balance during a laminar planar hydraulic jump in a viscous free surface flow, with shallow flow theory used to estimate the relevant jump parameters. The inclusion of momentum and kinetic energy correction factors incorporates the influence of the fluid nature. The fluid is described by the generalised Herschel–Bulkley model with Papanastasiou regularisation, which reduces to the Bingham plastic, power-law and Newtonian models under relevant limiting conditions. The analysis, extensively validated against experimental and simulated data, is explored to understand the physics of free surface flow during jump formation. Energy dissipation increases with an increase in the flow behaviour index n , flow consistency index k and yield stress τ o since each of them increases the apparent viscosity. Interestingly, it is higher in the supercritical (upstream) compared with the subcritical (downstream) zone. For constant discharge rate and film thickness, the specific energy depends on the velocity profile and is thus a function of n and τ o but not k, and the mechanism of influence of n and τ o are also different. For a generalised approach, energy dissipation and jump parameters are discussed as a function of relevant non-dimensional numbers obtained from SFT. Energy dissipation during a hydraulic jump in non-Newtonian liquids is a hitherto unexplored aspect. In fact, energy dissipation during a planar jump in a viscous Newtonian liquid is also rare, although hydraulic jumps are primarily used as energy dissipators in free surface flows.
- 27 March 2026
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 1032
Energy dissipation during laminar planar jump of a generalised time-independent non-Newtonian liquid – An analytical approach
This study presents an in-depth analysis of the energy dissipation and momentum balance during a laminar planar hydraulic jump in a viscous free surface flow, with shallow flow theory used to estimate the relevant jump parameters. The inclusion of momentum and kinetic energy correction factors incorporates the influence of the fluid nature. The fluid is described by the generalised Herschel–Bulkley model with Papanastasiou regularisation, which reduces to the Bingham plastic, power-law and Newtonian models under relevant limiting conditions. The analysis, extensively validated against experimental and simulated data, is explored to understand the physics of free surface flow during jump formation. Energy dissipation increases with an increase in the flow behaviour index n , flow consistency index k and yield stress τ o since each of them increases the apparent viscosity. Interestingly, it is higher in the supercritical (upstream) compared with the subcritical (downstream) zone. For constant discharge rate and film thickness, the specific energy depends on the velocity profile and is thus a function of n and τ o but not k, and the mechanism of influence of n and τ o are also different. For a generalised approach, energy dissipation and jump parameters are discussed as a function of relevant non-dimensional numbers obtained from SFT. Energy dissipation during a hydraulic jump in non-Newtonian liquids is a hitherto unexplored aspect. In fact, energy dissipation during a planar jump in a viscous Newtonian liquid is also rare, although hydraulic jumps are primarily used as energy dissipators in free surface flows.
- 19 September 2024
- Published by Elsevier in Journal of Non-Newtonian Fluid Mechanics
- Vol. 333
A numerical investigation of laminar planar hydraulic jump in Herschel-Bulkley fluid
- 19 September 2024
- Published by Elsevier in Journal of Non-Newtonian Fluid Mechanics
- Vol. 333
A numerical investigation of laminar planar hydraulic jump in Herschel-Bulkley fluid
- 10 November 2023
- Published by Elsevier in Chemical Engineering Science
- Vol. 284
Laminar planar hydraulic jump during free surface flow of Bingham plastic liquid
- 10 November 2023
- Published by Elsevier in Chemical Engineering Science
- Vol. 284
Laminar planar hydraulic jump during free surface flow of Bingham plastic liquid
- Open Access
- 1 November 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (11)
Analysis of natural planar jump in power-law liquids—A generalized “shallow flow” approach
The study presents a generalized “shallow flow” analysis of natural planar hydraulic jump in power-law liquids. It is based on self-similar velocity profile defined as function of flow behavior index, n, and shows significant improvement over the previous analysis which assumed a quadratic velocity profile and failed for n < 0.5. Thus, the study enables a deeper understanding of the influence of n for shear thinning vis-a-vis shear thickening liquids and emphasizes that the power-law description is adequate for highly shear thinning liquids if the flow parameters are valid over the range of interest.
- 1 November 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (11)
Open AccessAnalysis of natural planar jump in power-law liquids—A generalized “shallow flow” approach
The study presents a generalized “shallow flow” analysis of natural planar hydraulic jump in power-law liquids. It is based on self-similar velocity profile defined as function of flow behavior index, n, and shows significant improvement over the previous analysis which assumed a quadratic velocity profile and failed for n < 0.5. Thus, the study enables a deeper understanding of the influence of n for shear thinning vis-a-vis shear thickening liquids and emphasizes that the power-law description is adequate for highly shear thinning liquids if the flow parameters are valid over the range of interest.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Draining of shear-thinning liquids from closed-top millichannels
Draining from a closed-top tube occurs by downward displacement of liquid by air. The air volume grows inside the tube as an axisymmetric bullet-shaped finger similar to the Taylor bubble observed in gas–liquid slug flows, and the liquid drains as an annular film between the finger and the tube wall. The present study investigates the draining of shear-thinning vis-à-vis Newtonian liquids from closed-top circular millichannels. Numerical simulations using the phase-field method suggest that both the power law and Carreau models give close predictions of draining behavior in the investigated domain, i.e., for shear rate >0.1 s−1. The results are validated against experimental measurements based on high-speed photography and particle image velocimetry during the draining of aqueous solutions of carboxymethyl cellulose, xanthan gum, and glycerol. Further validations are performed for shear-thinning (using the power law, Carreau, and Carreau–Yasuda models) and Newtonian liquids with literature data on Taylor bubble rise in stationary liquid columns. The simulations using the power law model are used to explore additional insights into the flow physics. An increase in the apparent viscosity of shear-thinning liquids (by increasing the flow behavior index and/or flow consistency index) slows down the rate of Taylor finger growth. Increased liquid viscosity also results in a slender Taylor finger and leaves a higher amount of undrained liquid at the end of film-wise draining. The draining rate is a more significant function of flow behavior index n of the power law model for highly shear-thinning liquids (n < 0.6).
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Draining of shear-thinning liquids from closed-top millichannels
Draining from a closed-top tube occurs by downward displacement of liquid by air. The air volume grows inside the tube as an axisymmetric bullet-shaped finger similar to the Taylor bubble observed in gas–liquid slug flows, and the liquid drains as an annular film between the finger and the tube wall. The present study investigates the draining of shear-thinning vis-à-vis Newtonian liquids from closed-top circular millichannels. Numerical simulations using the phase-field method suggest that both the power law and Carreau models give close predictions of draining behavior in the investigated domain, i.e., for shear rate >0.1 s−1. The results are validated against experimental measurements based on high-speed photography and particle image velocimetry during the draining of aqueous solutions of carboxymethyl cellulose, xanthan gum, and glycerol. Further validations are performed for shear-thinning (using the power law, Carreau, and Carreau–Yasuda models) and Newtonian liquids with literature data on Taylor bubble rise in stationary liquid columns. The simulations using the power law model are used to explore additional insights into the flow physics. An increase in the apparent viscosity of shear-thinning liquids (by increasing the flow behavior index and/or flow consistency index) slows down the rate of Taylor finger growth. Increased liquid viscosity also results in a slender Taylor finger and leaves a higher amount of undrained liquid at the end of film-wise draining. The draining rate is a more significant function of flow behavior index n of the power law model for highly shear-thinning liquids (n < 0.6).
- 1 October 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (10) , 103110
Laminar planar hydraulic jump in thin film flow of power-law liquids—Experimental, analytical and numerical study
This study explores the physics of laminar planar hydraulic jump of power-law liquids in a horizontal channel through shallow water analysis. The theory is supplemented and validated by numerical simulation performed by the phase-field method in COMSOL Multiphysics. The analysis is applicable for shear thinning as well as thickening liquids and reduces to Newtonian equations when the flow behavior index (n) is unity. The analytical and numerical results are further validated with experimental data of the present study. The steady state free surface profile in conjunction with a modified Bélanger type equation predicts jump location and strength (the ratio of film height just after and before the jump). The analysis provides a modified scaled relationship between the jump location and the liquid flow rate compared to that proposed for inviscid and viscous Newtonian liquids. An order of magnitude analysis expresses the scaled jump location and strength as a function of inlet Reynolds number (Rein), inlet Froude number (Frin), scaled channel length, and n. We find that an increase in the flow consistency index and/or favors jump formation and the jump shifts toward the channel exit with increasing n for the same channel geometry, Rein and Frin. The influence of scaled channel length is more pronounced for n < 1 as compared to n > 1 while shear thickening liquids are more significantly influenced by Frin at fixed Rein and scaled channel length. The coupled effect of flow parameters on jump characteristics is depicted in the Rein–Frin plane, which denote the range of the existence of different jump types as the function of n.- 1 October 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (10) , 103110
Laminar planar hydraulic jump in thin film flow of power-law liquids—Experimental, analytical and numerical study
This study explores the physics of laminar planar hydraulic jump of power-law liquids in a horizontal channel through shallow water analysis. The theory is supplemented and validated by numerical simulation performed by the phase-field method in COMSOL Multiphysics. The analysis is applicable for shear thinning as well as thickening liquids and reduces to Newtonian equations when the flow behavior index (n) is unity. The analytical and numerical results are further validated with experimental data of the present study. The steady state free surface profile in conjunction with a modified Bélanger type equation predicts jump location and strength (the ratio of film height just after and before the jump). The analysis provides a modified scaled relationship between the jump location and the liquid flow rate compared to that proposed for inviscid and viscous Newtonian liquids. An order of magnitude analysis expresses the scaled jump location and strength as a function of inlet Reynolds number (Rein), inlet Froude number (Frin), scaled channel length, and n. We find that an increase in the flow consistency index and/or favors jump formation and the jump shifts toward the channel exit with increasing n for the same channel geometry, Rein and Frin. The influence of scaled channel length is more pronounced for n < 1 as compared to n > 1 while shear thickening liquids are more significantly influenced by Frin at fixed Rein and scaled channel length. The coupled effect of flow parameters on jump characteristics is depicted in the Rein–Frin plane, which denote the range of the existence of different jump types as the function of n.