TITakayuki Iwama

Takayuki Iwama

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Takayuki Iwama has a total of 72 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Foaming Behavior of FeO-Containing Slag during Pulverized Coal Injection under Continuous Ar Blowing

    by Huafang Yu, Fuga Sato, Takayuki Iwama, Wen-Feng Gu, Elizaveta Cheremisina, Ryo Inoue, Shigeru Ueda

    To clarify the foaming behavior of FeO-containing slags during pulverized coal injection, calcined anthracite powder was introduced under continuous Ar gas blowing, and the temporal change in foam height was measured. CaO–SiO2–FeO–Al2O3 and CaO–SiO2–FeO–MgO slags were used. Relatively large bubbles were formed when only Ar gas was blown, whereas after pulverized coal injection, a film-like structure formed on the slag surface and the foam height increased markedly. For the Al2O3-containing slag, injection of 0.1 g of pulverized coal resulted in maximum foam heights of approximately 30 mm in the first injection and 65 mm in the second injection. SEM observation and EDS analysis revealed phases corresponding to wüstite, gehlenite, and fine metallic Fe in the upper region of the Al2O3-containing slag, and phases corresponding to wüstite and metallic Fe in the film-like sample from the MgO-containing slag. In foaming caused only by Ar gas blowing, the foam height increased on the higher-viscosity side, whereas during pulverized coal injection, the maximum foam height increased with increasing temperature. The MgO-containing slag showed a lower foam height than the Al2O3-containing slag under Ar gas blowing alone, but exhibited rapid and pronounced foaming during pulverized coal injection. These results suggest that foaming during pulverized coal injection is likely a multiphase reaction phenomenon governed by the combined effects of liquid-phase viscosity, gas generation through the carbonaceous material–FeO reaction, dispersion of solid phases or metallic Fe particles, and gas retention within the foam films.

  • Open Access

    Mineral phase evolution of steelmaking slag under industrial treatment processes and its implications for potential volume stability

    by Wenfeng Gu, Jiang Diao, Wei Xia, Takayuki Iwama, Hongyi Li, Bing Xie, Shigeru Ueda

  • Open Access

    Effect of Deoxidation Agents on Secondary Inclusion in Fe-36mass%Ni Alloy

    by Hiroshi Fukaya, Makoto Kubo, Shintaro Yano, Shigeru Suzuki, Keijiro Saito, Takayuki Iwama, Jonah Gamutan, Takahiro Miki

    This study investigates the effects of deoxidation agents (Si and Al) and cooling rate on secondary inclusions in Fe-36mass%Ni alloy. Laboratory solidification experiments were performed at cooling rates ranging from 0.2 to 5.5 K/min. The spatial distribution of inclusions relative to microsegregation was quantitatively evaluated using a "combination analysis" that integrates SEM-EDS automated inclusion analysis with EPMA elemental mapping. Results showed that Al addition significantly reduced oxygen content and inclusion size compared to samples without Al. The combination analysis revealed that high-Al2O3 inclusions were primarily detected in early-solidified regions, while low-Al2O3 inclusions appeared in later-solidified regions. This transition in inclusion types and their detected positions is attributed to competitive deoxidation and stoichiometric limitations of Al during solidification. In Low-Si/Low-Al samples, the inclusion distribution shifted toward later-solidified regions as the cooling rate increased. Theoretical calculations using the Clyne-Kurz equation indicated that the degree of solute enrichment in the residual liquid phase alone cannot explain this cooling-rate-dependent shift in inclusion detected positions. These findings suggest that the spatial distribution of secondary inclusions is influenced not only by local chemical equilibrium but also by physical factors such as fluid flow within the mushy zone and inclusion formation kinetics.

  • Phase Stability and MgO Regulation in Steelmaking Slag for Improved Volume Stability

    by Wen-Feng Gu, Jiang Diao, Zhi-Qiu Lai, Jun-Yi Deng, Jing Lei, Hua-Fang Yu, Takayuki Iwama, Hong-Yi Li, Bing Xie, Shigeru Ueda

  • Open Access

    Leaching behavior of steelmaking slag fertilizer under repeated wetting and drying conditions simulating upland soil

    by Takayuki Iwama, Shohei Koizumi, Megumi Obara, Shigeru Ueda

    To determine how steelmaking slag dissolves and modulates soil acidity and exchangeable cations under upland-like repeated wetting–drying conditions, we conducted a soil-column experiment. Specifically, we aimed to identify the Ca-supplying phases responsible for pH correction, evaluate their persistence during extended leaching, and define the layer-scale reach of the effect to inform application planning (rate, placement, and maintenance). Soil columns incorporating discrete slag-amended layers were prepared together with unamended controls. A repeated wetting–drying leaching test was run up to 24 weeks; after termination, each column was sampled by layer, and soil pH and exchangeable CaO were measured. Additionally, surfaces and cross-sections of slag particles embedded in the columns were observed to identify dissolving phases and secondary precipitates. In the control columns, soil pH remained in the acidic range (4.8–5.5), whereas slag-amended layers maintained pH 6.0–6.5 for 24 weeks in the test columns. Adjacent unamended layers in the test columns showed no detectable change, indicating that the effect was confined to the amended layers. Exchangeable CaO increased in soils mixed with slag. Microstructural observations revealed alteration and dissolution of free lime (f-CaO) and dicalcium silicate (2 CaO ⋅ SiO2), with calcium carbonate (CaCO3) precipitates on particle surfaces. These Ca-supplying phases persisted after 24 weeks of leaching. Sustained Ca release from f-CaO and 2 CaO ⋅ SiO2, together with CaCO3 precipitation, produced localized, durable pH correction in slag-amended layers while leaving adjacent layers unchanged. The defined reach and persistence provide a mechanistic basis for application planning in acidic upland soils – informing rate, placement within the profile, and maintenance intervals.

  • Open Access

    Reply on AC1

    by Takayuki Iwama, Shohei Koizumi, Megumi Obara, Shigeru Ueda

    To determine how steelmaking slag dissolves and modulates soil acidity and exchangeable cations under upland-like repeated wetting–drying conditions, we conducted a soil-column experiment. Specifically, we aimed to identify the Ca-supplying phases responsible for pH correction, evaluate their persistence during extended leaching, and define the layer-scale reach of the effect to inform application planning (rate, placement, and maintenance). Soil columns incorporating discrete slag-amended layers were prepared together with unamended controls. A repeated wetting–drying leaching test was run up to 24 weeks; after termination, each column was sampled by layer, and soil pH and exchangeable CaO were measured. Additionally, surfaces and cross-sections of slag particles embedded in the columns were observed to identify dissolving phases and secondary precipitates. In the control columns, soil pH remained in the acidic range (4.8–5.5), whereas slag-amended layers maintained pH 6.0–6.5 for 24 weeks in the test columns. Adjacent unamended layers in the test columns showed no detectable change, indicating that the effect was confined to the amended layers. Exchangeable CaO increased in soils mixed with slag. Microstructural observations revealed alteration and dissolution of free lime (f-CaO) and dicalcium silicate (2CaO·SiO2), with CaCO3 precipitates on particle surfaces. These Ca-supplying phases persisted after 24 weeks of leaching. Sustained Ca release from f-CaO and 2CaO·SiO2, together with CaCO3 precipitation, produced localized, durable pH correction in slag-amended layers while leaving adjacent layers unchanged. The defined reach and persistence provide a mechanistic basis for application planning in acidic upland soils – informing rate, placement within the profile, and maintenance intervals.

  • Open Access

    Reply on RC1

    by Takayuki Iwama, Shohei Koizumi, Megumi Obara, Shigeru Ueda

    To determine how steelmaking slag dissolves and modulates soil acidity and exchangeable cations under upland-like repeated wetting–drying conditions, we conducted a soil-column experiment. Specifically, we aimed to identify the Ca-supplying phases responsible for pH correction, evaluate their persistence during extended leaching, and define the layer-scale reach of the effect to inform application planning (rate, placement, and maintenance). Soil columns incorporating discrete slag-amended layers were prepared together with unamended controls. A repeated wetting–drying leaching test was run up to 24 weeks; after termination, each column was sampled by layer, and soil pH and exchangeable CaO were measured. Additionally, surfaces and cross-sections of slag particles embedded in the columns were observed to identify dissolving phases and secondary precipitates. In the control columns, soil pH remained in the acidic range (4.8–5.5), whereas slag-amended layers maintained pH 6.0–6.5 for 24 weeks in the test columns. Adjacent unamended layers in the test columns showed no detectable change, indicating that the effect was confined to the amended layers. Exchangeable CaO increased in soils mixed with slag. Microstructural observations revealed alteration and dissolution of free lime (f-CaO) and dicalcium silicate (2CaO·SiO2), with CaCO3 precipitates on particle surfaces. These Ca-supplying phases persisted after 24 weeks of leaching. Sustained Ca release from f-CaO and 2CaO·SiO2, together with CaCO3 precipitation, produced localized, durable pH correction in slag-amended layers while leaving adjacent layers unchanged. The defined reach and persistence provide a mechanistic basis for application planning in acidic upland soils – informing rate, placement within the profile, and maintenance intervals.

  • Open Access

    Reply on RC2

    by Takayuki Iwama, Shohei Koizumi, Megumi Obara, Shigeru Ueda

    To determine how steelmaking slag dissolves and modulates soil acidity and exchangeable cations under upland-like repeated wetting–drying conditions, we conducted a soil-column experiment. Specifically, we aimed to identify the Ca-supplying phases responsible for pH correction, evaluate their persistence during extended leaching, and define the layer-scale reach of the effect to inform application planning (rate, placement, and maintenance). Soil columns incorporating discrete slag-amended layers were prepared together with unamended controls. A repeated wetting–drying leaching test was run up to 24 weeks; after termination, each column was sampled by layer, and soil pH and exchangeable CaO were measured. Additionally, surfaces and cross-sections of slag particles embedded in the columns were observed to identify dissolving phases and secondary precipitates. In the control columns, soil pH remained in the acidic range (4.8–5.5), whereas slag-amended layers maintained pH 6.0–6.5 for 24 weeks in the test columns. Adjacent unamended layers in the test columns showed no detectable change, indicating that the effect was confined to the amended layers. Exchangeable CaO increased in soils mixed with slag. Microstructural observations revealed alteration and dissolution of free lime (f-CaO) and dicalcium silicate (2CaO·SiO2), with CaCO3 precipitates on particle surfaces. These Ca-supplying phases persisted after 24 weeks of leaching. Sustained Ca release from f-CaO and 2CaO·SiO2, together with CaCO3 precipitation, produced localized, durable pH correction in slag-amended layers while leaving adjacent layers unchanged. The defined reach and persistence provide a mechanistic basis for application planning in acidic upland soils – informing rate, placement within the profile, and maintenance intervals.

  • Open Access

    Comment on egusphere-2025-6356

    by Takayuki Iwama, Shohei Koizumi, Megumi Obara, Shigeru Ueda

    To determine how steelmaking slag dissolves and modulates soil acidity and exchangeable cations under upland-like repeated wetting–drying conditions, we conducted a soil-column experiment. Specifically, we aimed to identify the Ca-supplying phases responsible for pH correction, evaluate their persistence during extended leaching, and define the layer-scale reach of the effect to inform application planning (rate, placement, and maintenance). Soil columns incorporating discrete slag-amended layers were prepared together with unamended controls. A repeated wetting–drying leaching test was run up to 24 weeks; after termination, each column was sampled by layer, and soil pH and exchangeable CaO were measured. Additionally, surfaces and cross-sections of slag particles embedded in the columns were observed to identify dissolving phases and secondary precipitates. In the control columns, soil pH remained in the acidic range (4.8–5.5), whereas slag-amended layers maintained pH 6.0–6.5 for 24 weeks in the test columns. Adjacent unamended layers in the test columns showed no detectable change, indicating that the effect was confined to the amended layers. Exchangeable CaO increased in soils mixed with slag. Microstructural observations revealed alteration and dissolution of free lime (f-CaO) and dicalcium silicate (2CaO·SiO2), with CaCO3 precipitates on particle surfaces. These Ca-supplying phases persisted after 24 weeks of leaching. Sustained Ca release from f-CaO and 2CaO·SiO2, together with CaCO3 precipitation, produced localized, durable pH correction in slag-amended layers while leaving adjacent layers unchanged. The defined reach and persistence provide a mechanistic basis for application planning in acidic upland soils – informing rate, placement within the profile, and maintenance intervals.