Ágnes Nagyné Szokol
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ágnes Nagyné Szokol has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- András Szenes
Department for Quantum Optics, University of Szeged, 6720 Szeged, Hungary
2 shared publications - Attila Bonyár
Department of Electronics Technology Faculty of Electrical Engineering and Informatics Budapest University of Technology and Economics Egry József street 18 H-1111 Budapest Hungary
2 shared publications - Dávid Vass
Department for Quantum Optics, University of Szeged, 6720 Szeged, Hungary
2 shared publications - Emese Tóth
Department for Quantum Optics, University of Szeged, 6720 Szeged, Hungary
2 shared publications - Gyula Nagy
Institute of Applied Physics, TU Wien, 1040 Vienna, Austria
2 shared publications - Gábor Galbács
Department of Molecular and Analytical Chemistry, University of Szeged, Dóm sq. 7-8, Szeged, 6720, Hungary
2 shared publications
Latest Publications
- Open Access
Inscription of Quasi-Sinusoidal Surface Relief Optical Gratings in ZEONOR™ Cyclic Olefin Polymer by a 10.5 MeV N4+ Ion Microbeam at Low Implanted Fluences
Direct writing of microstructures in ZEONOR™ cyclic olefin polymer, using a high-energy medium-mass ion microbeam, was proposed and demonstrated. Microbeams of 10.5 MeV N4+ ions were used. The implanted fluences were between 2.5·1012 and 2.0·1013 ion/cm2. The microstructures were surface relief optical gratings of quasi-sinusoidal profile and grating constant of 4, 8 and 16 µm. Peak-to-peak amplitudes of the gratings ranged from 10 to 90 nm. Measured profiles of the gratings were Fourier-analyzed. Highest measured net first-order diffraction efficiencies were between 25 and 29% at wavelengths of 405 and 640 nm, very close to the theoretical maximum of 33%, calculated with the Raman-Nath equation. This method could be used for the production of micro- and nanostructures in cyclic olefin polymers and copolymers and other polymers as well, either for the direct production of label-free biosensors and other devices, or to produce masters for hot stamping of such structures.
Open AccessInscription of Quasi-Sinusoidal Surface Relief Optical Gratings in ZEONOR™ Cyclic Olefin Polymer by a 10.5 MeV N4+ Ion Microbeam at Low Implanted Fluences
Direct writing of microstructures in ZEONOR™ cyclic olefin polymer, using a high-energy medium-mass ion microbeam, was proposed and demonstrated. Microbeams of 10.5 MeV N4+ ions were used. The implanted fluences were between 2.5·1012 and 2.0·1013 ion/cm2. The microstructures were surface relief optical gratings of quasi-sinusoidal profile and grating constant of 4, 8 and 16 µm. Peak-to-peak amplitudes of the gratings ranged from 10 to 90 nm. Measured profiles of the gratings were Fourier-analyzed. Highest measured net first-order diffraction efficiencies were between 25 and 29% at wavelengths of 405 and 640 nm, very close to the theoretical maximum of 33%, calculated with the Raman-Nath equation. This method could be used for the production of micro- and nanostructures in cyclic olefin polymers and copolymers and other polymers as well, either for the direct production of label-free biosensors and other devices, or to produce masters for hot stamping of such structures.
- Open Access
- 3 April 2025
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 234 (10) , 3007-3013
Morphology studies on craters created by femtosecond laser irradiation in UDMA polymer targets embedded with plasmonic gold nanorods
The effect of embedded plasmonic gold nanoparticles on the crater morphology was studied in 160 µm-thick UDMA–TEGDMA copolymer films irradiated by femtosecond single pulses of a Ti:Sa laser. The plasmonic absorption of the embedded gold nanorods had a resonance at the wavelength of the laser. It was observed that by increasing the laser intensity the diameter of the craters decreased, while the depth of the craters increased. In addition, the crater depths were significantly higher in the presence of gold nanorods. A threshold intensity of 1.5·1017 W/cm2 has been determined, above which a doubled roughness and sevenfold increased crater volume was observed in the polymer containing gold nanorods. Graphical abstract
- 3 April 2025
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 234 (10) , 3007-3013
Open AccessMorphology studies on craters created by femtosecond laser irradiation in UDMA polymer targets embedded with plasmonic gold nanorods
The effect of embedded plasmonic gold nanoparticles on the crater morphology was studied in 160 µm-thick UDMA–TEGDMA copolymer films irradiated by femtosecond single pulses of a Ti:Sa laser. The plasmonic absorption of the embedded gold nanorods had a resonance at the wavelength of the laser. It was observed that by increasing the laser intensity the diameter of the craters decreased, while the depth of the craters increased. In addition, the crater depths were significantly higher in the presence of gold nanorods. A threshold intensity of 1.5·1017 W/cm2 has been determined, above which a doubled roughness and sevenfold increased crater volume was observed in the polymer containing gold nanorods. Graphical abstract
- Open Access
Direct Writing of Quasi-Sinusoidal and Blazed Surface Relief Optical Transmission Gratings in Bi12GeO20, Er: LiNbO3 and Er: Fe: LiNbO3 Crystals by Nitrogen Ion Microbeams of 5 MeV and 10.5 MeV Energy
High diffraction efficiency optical transmission gratings with quasi-sinusoidal and saw-tooth surface relief profiles were fabricated in Bi12GeO20, Er: LiNbO3 and Er: Fe: LiNbO3 crystals by ion beam implantation. The gratings were directly written by nitrogen ion microbeams at energies of 5 MeV and 10.5 MeV. The finest grating constant was 4 μm. Grating constants for the majority of the gratings were 16 μm. The highest amplitudes of the gratings reached 1600 nm. The highest first-order diffraction efficiency obtained in a sinusoidal grating was 25%, close to the theoretical maximum of 33%. The highest first-order diffraction efficiency of a blazed grating was also 25%, without Littrow optimization. Such gratings can be incorporated into integrated optical biosensors.
Open AccessDirect Writing of Quasi-Sinusoidal and Blazed Surface Relief Optical Transmission Gratings in Bi12GeO20, Er: LiNbO3 and Er: Fe: LiNbO3 Crystals by Nitrogen Ion Microbeams of 5 MeV and 10.5 MeV Energy
High diffraction efficiency optical transmission gratings with quasi-sinusoidal and saw-tooth surface relief profiles were fabricated in Bi12GeO20, Er: LiNbO3 and Er: Fe: LiNbO3 crystals by ion beam implantation. The gratings were directly written by nitrogen ion microbeams at energies of 5 MeV and 10.5 MeV. The finest grating constant was 4 μm. Grating constants for the majority of the gratings were 16 μm. The highest amplitudes of the gratings reached 1600 nm. The highest first-order diffraction efficiency obtained in a sinusoidal grating was 25%, close to the theoretical maximum of 33%. The highest first-order diffraction efficiency of a blazed grating was also 25%, without Littrow optimization. Such gratings can be incorporated into integrated optical biosensors.
- Open Access
With Nanoplasmonics towards Fusion
A status report is presented about the Nanoplasmonic Laser Induced Fusion Experiment (NAPLIFE). The goal is to investigate and verify plasmonically enhanced phenomena on the surfaces of nanoantennas embedded in a polymer target at laser intensities up to a few times W/cm and pulse durations of 40–120 fs. The first results on enhanced crater formation for Au-doped polymer targets are shown, and SERS signals typical for and bound vibrations are cited. Trials to detect ratio by means of LIBS measurments are reported. Plasmonics has the potential to work at these intensities, enhancing the energy and deuterium production, due to thus far unknown mechanisms.Open AccessWith Nanoplasmonics towards Fusion
A status report is presented about the Nanoplasmonic Laser Induced Fusion Experiment (NAPLIFE). The goal is to investigate and verify plasmonically enhanced phenomena on the surfaces of nanoantennas embedded in a polymer target at laser intensities up to a few times W/cm and pulse durations of 40–120 fs. The first results on enhanced crater formation for Au-doped polymer targets are shown, and SERS signals typical for and bound vibrations are cited. Trials to detect ratio by means of LIBS measurments are reported. Plasmonics has the potential to work at these intensities, enhancing the energy and deuterium production, due to thus far unknown mechanisms. - Open Access
- 5 November 2022
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 23 (21) , 13575
The Effect of Femtosecond Laser Irradiation and Plasmon Field on the Degree of Conversion of a UDMA-TEGDMA Copolymer Nanocomposite Doped with Gold Nanorods
In this work, the effects of femtosecond laser irradiation and doping with plasmonic gold nanorods on the degree of conversion (DC) of a urethane dimethacrylate (UDMA)–triethylene glycol dimethacrylate (TEGDMA) nanocomposite were investigated. The UDMA-TEGDMA photopolymer was prepared in a 3:1 weight ratio and doped with dodecanethiol- (DDT) capped gold nanorods of 25 × 75 or 25 × 85 nm nominal diameter and length. It was found that the presence of the gold nanorods alone (without direct plasmonic excitation) can increase the DC of the photopolymer by 6–15%. This increase was found to be similar to what could be achieved with a control heat treatment of 30 min at 180 °C. It was also shown that femtosecond laser impulses (795 nm, 5 mJ pulse energy, 50 fs pulse length, 2.83 Jcm−2 fluence), applied after the photopolymerization under a standard dental curing lamp, can cause a 2–7% increase in the DC of undoped samples, even after thermal pre-treatment. The best DC values (12–15% increase) were obtained with combined nanorod doping and subsequent laser irradiation close to the plasmon resonance peak of the nanorods (760–800 nm), which proves that the excited plasmon field can directly facilitate double bond breakage (without thermoplasmonic effects due to the short pulse length) and increase the crosslink density independently from the initial photopolymerization process.
- 5 November 2022
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 23 (21) , 13575
Open AccessThe Effect of Femtosecond Laser Irradiation and Plasmon Field on the Degree of Conversion of a UDMA-TEGDMA Copolymer Nanocomposite Doped with Gold Nanorods
In this work, the effects of femtosecond laser irradiation and doping with plasmonic gold nanorods on the degree of conversion (DC) of a urethane dimethacrylate (UDMA)–triethylene glycol dimethacrylate (TEGDMA) nanocomposite were investigated. The UDMA-TEGDMA photopolymer was prepared in a 3:1 weight ratio and doped with dodecanethiol- (DDT) capped gold nanorods of 25 × 75 or 25 × 85 nm nominal diameter and length. It was found that the presence of the gold nanorods alone (without direct plasmonic excitation) can increase the DC of the photopolymer by 6–15%. This increase was found to be similar to what could be achieved with a control heat treatment of 30 min at 180 °C. It was also shown that femtosecond laser impulses (795 nm, 5 mJ pulse energy, 50 fs pulse length, 2.83 Jcm−2 fluence), applied after the photopolymerization under a standard dental curing lamp, can cause a 2–7% increase in the DC of undoped samples, even after thermal pre-treatment. The best DC values (12–15% increase) were obtained with combined nanorod doping and subsequent laser irradiation close to the plasmon resonance peak of the nanorods (760–800 nm), which proves that the excited plasmon field can directly facilitate double bond breakage (without thermoplasmonic effects due to the short pulse length) and increase the crosslink density independently from the initial photopolymerization process.